From: Krzysztof Kozlowski <krzk@kernel.org>
To: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
Cc: Hardeep Sharma <hardeep.sharma@oss.qualcomm.com>,
Bjorn Andersson <andersson@kernel.org>,
Konrad Dybcio <konradybcio@kernel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski@oss.qualcomm.com>,
Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
Ulf Hansson <ulfh@kernel.org>,
Michael Turquette <mturquette@baylibre.com>,
Stephen Boyd <sboyd@kernel.org>,
Brian Masney <bmasney@redhat.com>,
Taniya Das <quic_tdas@quicinc.com>,
Georgi Djakov <djakov@kernel.org>,
Bartosz Golaszewski <brgl@kernel.org>,
Linus Walleij <linusw@kernel.org>,
Thomas Gleixner <tglx@kernel.org>, Radu Rendec <radu@rendec.net>,
Robert Marko <robimarko@gmail.com>,
Guru Das Srinagesh <linux@gurudas.dev>,
linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org,
devicetree@vger.kernel.org, linux-pm@vger.kernel.org,
linux-clk@vger.kernel.org, linux-gpio@vger.kernel.org
Subject: Re: [PATCH 15/15] ARM: dts: qcom: Add initial device tree for Kuno SoC
Date: Thu, 13 Aug 2026 11:44:28 +0200 [thread overview]
Message-ID: <20260813-generous-romantic-asp-be92e8@quoll> (raw)
In-Reply-To: <wjzyvt7q4vpirxclbwexrhsmcoi23hmsqbjjpfto26ofci23t7@uufz7ilar4qk>
On Tue, Aug 11, 2026 at 04:13:40AM +0300, Dmitry Baryshkov wrote:
> On Sun, Aug 09, 2026 at 12:57:14PM +0530, Hardeep Sharma wrote:
> > Add SoC-level DTSI (qcom-kuno.dtsi) and IDP board DTS
> > (qcom-kuno-idp.dts) for the Qualcomm Kuno SoC.
> >
> > Peripherals included in this initial set:
> > - Single Cortex-A7 CPU with PSCI idle states
> > - RPMh RSC with clock controller, power domains, and BCM voter
> > - GCC (Global Clock Controller)
> > - TLMM pin controller (110 GPIOs)
> > - Interconnect (aggre-noc, cnoc-main)
> > - GENI UART console (QUP SE3)
> > - SMEM, hardware spinlocks (TCSR mutex)
>
> This is pretty limited without any storage. Does it NAND?
It has serial connection. this is enough for a start. At least one
communication interface is needed for early upstreaming.
Best regards,
Krzysztof
next prev parent reply other threads:[~2026-08-13 9:44 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-08-09 7:26 [PATCH 00/15] Add initial support for Qualcomm Kuno SoC Hardeep Sharma
2026-08-09 7:27 ` [PATCH 01/15] soc: qcom: geni-se: allow selection on 32-bit ARM Qualcomm SoCs Hardeep Sharma
2026-08-11 0:48 ` Dmitry Baryshkov
2026-08-11 1:15 ` Dmitry Baryshkov
2026-08-11 3:07 ` Hardeep Sharma
2026-08-11 14:05 ` Dmitry Baryshkov
2026-08-11 9:44 ` Krzysztof Kozlowski
2026-08-11 10:30 ` Hardeep Sharma
2026-08-11 10:34 ` Hardeep Sharma
2026-08-11 7:20 ` Mukesh Savaliya
2026-08-09 7:27 ` [PATCH 02/15] dt-bindings: power: rpmpd: Document Kuno RPMh power domains Hardeep Sharma
2026-08-13 9:35 ` Krzysztof Kozlowski
2026-08-09 7:27 ` [PATCH 03/15] pmdomain: qcom: rpmhpd: Add power domains for Kuno Hardeep Sharma
2026-08-09 7:27 ` [PATCH 04/15] dt-bindings: clock: qcom,rpmhcc: Add Kuno RPMh clock controller Hardeep Sharma
2026-08-09 7:27 ` [PATCH 05/15] clk: qcom: clk-rpmh: Add support for Kuno RPMh clocks Hardeep Sharma
2026-08-11 0:58 ` Dmitry Baryshkov
2026-08-09 7:27 ` [PATCH 06/15] dt-bindings: interconnect: Add Qualcomm Kuno NoC Hardeep Sharma
2026-08-11 0:59 ` Dmitry Baryshkov
2026-08-09 7:27 ` [PATCH 07/15] interconnect: qcom: Add Kuno interconnect provider driver Hardeep Sharma
2026-08-10 9:37 ` Uwe Kleine-König
2026-08-11 1:00 ` Dmitry Baryshkov
2026-08-11 3:47 ` Hardeep Sharma
2026-08-11 14:07 ` Dmitry Baryshkov
2026-08-09 7:27 ` [PATCH 08/15] dt-bindings: pinctrl: qcom: Add Kuno TLMM Hardeep Sharma
2026-08-13 9:37 ` Krzysztof Kozlowski
2026-08-09 7:27 ` [PATCH 09/15] pinctrl: qcom: Add Kuno pinctrl driver Hardeep Sharma
2026-08-10 11:03 ` Bartosz Golaszewski
2026-08-09 7:27 ` [PATCH 10/15] dt-bindings: clock: qcom: Add Kuno Global Clock Controller Hardeep Sharma
2026-08-13 9:40 ` Krzysztof Kozlowski
2026-08-09 7:27 ` [PATCH 11/15] clk: qcom: Add Global Clock Controller driver for Kuno Hardeep Sharma
2026-08-11 1:06 ` Dmitry Baryshkov
2026-08-09 7:27 ` [PATCH 12/15] dt-bindings: interrupt-controller: qcom,pdc: Add Kuno compatible string Hardeep Sharma
2026-08-13 9:41 ` Krzysztof Kozlowski
2026-08-09 7:27 ` [PATCH 13/15] dt-bindings: firmware: qcom,scm: Document SCM on Kuno SoC Hardeep Sharma
2026-08-10 9:50 ` Bartosz Golaszewski
2026-08-09 7:27 ` [PATCH 14/15] dt-bindings: arm: qcom: Document Kuno IDP board Hardeep Sharma
2026-08-13 9:42 ` Krzysztof Kozlowski
2026-08-09 7:27 ` [PATCH 15/15] ARM: dts: qcom: Add initial device tree for Kuno SoC Hardeep Sharma
2026-08-10 20:03 ` Linus Walleij
2026-08-11 1:13 ` Dmitry Baryshkov
2026-08-13 9:44 ` Krzysztof Kozlowski [this message]
2026-08-10 18:06 ` [PATCH 00/15] Add initial support for Qualcomm " Linus Walleij
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260813-generous-romantic-asp-be92e8@quoll \
--to=krzk@kernel.org \
--cc=andersson@kernel.org \
--cc=bmasney@redhat.com \
--cc=brgl@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=djakov@kernel.org \
--cc=dmitry.baryshkov@oss.qualcomm.com \
--cc=hardeep.sharma@oss.qualcomm.com \
--cc=konradybcio@kernel.org \
--cc=krzk+dt@kernel.org \
--cc=krzysztof.kozlowski@oss.qualcomm.com \
--cc=linusw@kernel.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=linux@gurudas.dev \
--cc=mturquette@baylibre.com \
--cc=quic_tdas@quicinc.com \
--cc=radu@rendec.net \
--cc=robh@kernel.org \
--cc=robimarko@gmail.com \
--cc=sboyd@kernel.org \
--cc=tglx@kernel.org \
--cc=ulfh@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox