From: Rojhalat Ibrahim <imr@rtschenk.de>
To: linux-gpio@vger.kernel.org
Subject: [RFC PATCH] gpiolib: introduce gpio_set_multiple function
Date: Thu, 23 Jan 2014 13:19:42 +0100 [thread overview]
Message-ID: <2473803.SebQ52F62q@pcimr> (raw)
This patch introduces a new function gpio_set_multiple which allows setting
multiple GPIO lines on the same chip with just one function call. If a
corresponding set_multi function is defined for the chip performance can be
significantly improved. Otherwise gpio_set_multiple uses the chip's set
function and the performance stays the same as without the new function.
For my application, where I have to frequently set 9 GPIO lines in order to
configure an FPGA, configuration time goes down from 48 s to 15 s when I use
this new function. (Tested with a modified gpio-mpc8xxx module.)
Signed-off-by: Rojhalat Ibrahim <imr@rtschenk.de>
---
drivers/gpio/gpiolib.c | 59 ++++++++++++++++++++++++++++++++++++++++++
include/asm-generic/gpio.h | 17 ++++++++++++
include/linux/gpio.h | 20 ++++++++++++++
include/linux/gpio/consumer.h | 14 +++++++++
include/linux/gpio/driver.h | 3 ++
5 files changed, 113 insertions(+)
diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
index 50c4922..8355acb 100644
--- a/drivers/gpio/gpiolib.c
+++ b/drivers/gpio/gpiolib.c
@@ -2099,6 +2099,44 @@ void gpiod_set_value(struct gpio_desc *desc, int value)
}
EXPORT_SYMBOL_GPL(gpiod_set_value);
+static void _gpiod_set_raw_multiple(struct gpio_chip *chip,
+ u64 mask, u64 value)
+{
+ if (chip->set_multi)
+ chip->set_multi(chip, mask, value);
+ else {
+ int i;
+ for (i=0; i<64; i++) {
+ if (i > chip->ngpio - 1)
+ break;
+ if (mask & ((u64)(1) << i))
+ chip->set(chip, i, (value >> i) & 1);
+ }
+ }
+}
+
+/**
+ * gpiod_set_raw_multiple() - assign values to multiple GPIOs
+ * @chip: chip the GPIOs belong to
+ * @mask: only GPIOs with corresponding bits in mask set are modified
+ * @value: value bits to assign to GPIOs
+ *
+ * Set the raw values of multiple GPIOs, i.e. physical line values without
+ * regard for their ACTIVE_LOW status.
+ *
+ * This function should be called from contexts where we cannot sleep, and will
+ * complain if the GPIO chip functions potentially sleep.
+ */
+void gpiod_set_raw_multiple(struct gpio_chip *chip, u64 mask, u64 value)
+{
+ if (!chip)
+ return;
+ /* Should be using gpio_set_multiple_cansleep() */
+ WARN_ON(chip->can_sleep);
+ _gpiod_set_raw_multiple(chip, mask, value);
+}
+EXPORT_SYMBOL_GPL(gpiod_set_raw_multiple);
+
/**
* gpiod_cansleep() - report whether gpio value access may sleep
* @desc: gpio to check
@@ -2272,6 +2310,27 @@ void gpiod_set_value_cansleep(struct gpio_desc *desc, int value)
EXPORT_SYMBOL_GPL(gpiod_set_value_cansleep);
/**
+ * gpiod_set_raw_multiple_cansleep() - assign values to multiple GPIOs
+ * @chip: chip the GPIOs belong to
+ * @mask: only GPIOs with corresponding bits in mask set are modified
+ * @value: value bits to assign to GPIOs
+ *
+ * Set the raw values of multiple GPIOs, i.e. physical line values without
+ * regard for their ACTIVE_LOW status.
+ *
+ * This function is to be called from contexts that can sleep.
+ */
+void gpiod_set_raw_multiple_cansleep(struct gpio_chip *chip,
+ u64 mask, u64 value)
+{
+ might_sleep_if(extra_checks);
+ if (!chip)
+ return;
+ _gpiod_set_raw_multiple(chip, mask, value);
+}
+EXPORT_SYMBOL_GPL(gpiod_set_raw_multiple_cansleep);
+
+/**
* gpiod_add_lookup_table() - register GPIO device consumers
* @table: table of consumers to register
*/
diff --git a/include/asm-generic/gpio.h b/include/asm-generic/gpio.h
index a5f56a0..c53d8ac 100644
--- a/include/asm-generic/gpio.h
+++ b/include/asm-generic/gpio.h
@@ -85,6 +85,11 @@ static inline void gpio_set_value_cansleep(unsigned gpio, int value)
{
return gpiod_set_raw_value_cansleep(gpio_to_desc(gpio), value);
}
+static inline void gpio_set_multiple_cansleep(struct gpio_chip *chip, u64 mask,
+ u64 value)
+{
+ return gpiod_set_raw_multiple_cansleep(chip, mask, value);
+}
/* A platform's <asm/gpio.h> code may want to inline the I/O calls when
@@ -99,6 +104,11 @@ static inline void __gpio_set_value(unsigned gpio, int value)
{
return gpiod_set_raw_value(gpio_to_desc(gpio), value);
}
+static inline void __gpio_set_multiple(struct gpio_chip *chip, u64 mask,
+ u64 value)
+{
+ return gpiod_set_raw_multiple(chip, mask, value);
+}
static inline int __gpio_cansleep(unsigned gpio)
{
@@ -218,6 +228,13 @@ static inline void gpio_set_value_cansleep(unsigned gpio, int value)
__gpio_set_value(gpio, value);
}
+static inline void gpio_set_multiple_cansleep(struct gpio_chip *chip, u64 mask,
+ u64 value)
+{
+ might_sleep();
+ __gpio_set_multiple(chip, mask, value);
+}
+
#endif /* !CONFIG_GPIOLIB */
#endif /* _ASM_GENERIC_GPIO_H */
diff --git a/include/linux/gpio.h b/include/linux/gpio.h
index b581b13..cbb4725 100644
--- a/include/linux/gpio.h
+++ b/include/linux/gpio.h
@@ -60,6 +60,12 @@ static inline void gpio_set_value(unsigned int gpio, int value)
__gpio_set_value(gpio, value);
}
+static inline void gpio_set_multiple(struct gpio_chip *chip, u64 mask,
+ u64 value)
+{
+ __gpio_set_multiple(chip, mask, value);
+}
+
static inline int gpio_cansleep(unsigned int gpio)
{
return __gpio_cansleep(gpio);
@@ -161,6 +167,13 @@ static inline void gpio_set_value(unsigned gpio, int value)
WARN_ON(1);
}
+static inline void gpio_set_multiple(struct gpio_chip *chip, u64 mask,
+ u64 value)
+{
+ /* GPIO can never have been requested or set as output */
+ WARN_ON(1);
+}
+
static inline int gpio_cansleep(unsigned gpio)
{
/* GPIO can never have been requested or set as {in,out}put */
@@ -181,6 +194,13 @@ static inline void gpio_set_value_cansleep(unsigned gpio, int value)
WARN_ON(1);
}
+static inline void gpio_set_multiple_cansleep(struct gpio_chip *chip,
+ u64 mask, u64 value)
+{
+ /* GPIO can never have been requested or set as output */
+ WARN_ON(1);
+}
+
static inline int gpio_export(unsigned gpio, bool direction_may_change)
{
/* GPIO can never have been requested or set as {in,out}put */
diff --git a/include/linux/gpio/consumer.h b/include/linux/gpio/consumer.h
index 4d34dbb..5ffdbd0 100644
--- a/include/linux/gpio/consumer.h
+++ b/include/linux/gpio/consumer.h
@@ -42,12 +42,14 @@ int gpiod_get_value(const struct gpio_desc *desc);
void gpiod_set_value(struct gpio_desc *desc, int value);
int gpiod_get_raw_value(const struct gpio_desc *desc);
void gpiod_set_raw_value(struct gpio_desc *desc, int value);
+void gpiod_set_raw_multiple(struct gpio_chip *chip, u64 mask, u64 value);
/* Value get/set from sleeping context */
int gpiod_get_value_cansleep(const struct gpio_desc *desc);
void gpiod_set_value_cansleep(struct gpio_desc *desc, int value);
int gpiod_get_raw_value_cansleep(const struct gpio_desc *desc);
void gpiod_set_raw_value_cansleep(struct gpio_desc *desc, int value);
+void gpiod_set_raw_multiple_cansleep(struct gpio_chip *chip, u64 mask, u64 value);
int gpiod_set_debounce(struct gpio_desc *desc, unsigned debounce);
@@ -145,6 +147,12 @@ static inline void gpiod_set_raw_value(struct gpio_desc *desc, int value)
/* GPIO can never have been requested */
WARN_ON(1);
}
+static inline void gpiod_set_raw_multiple(struct gpio_chip *chip, u64 mask,
+ u64 value)
+{
+ /* GPIO can never have been requested */
+ WARN_ON(1);
+}
static inline int gpiod_get_value_cansleep(const struct gpio_desc *desc)
{
@@ -169,6 +177,12 @@ static inline void gpiod_set_raw_value_cansleep(struct gpio_desc *desc,
/* GPIO can never have been requested */
WARN_ON(1);
}
+static inline void gpiod_set_raw_multiple_cansleep(struct gpio_chip *chip,
+ u64 mask, u64 value)
+{
+ /* GPIO can never have been requested */
+ WARN_ON(1);
+}
static inline int gpiod_set_debounce(struct gpio_desc *desc, unsigned debounce)
{
diff --git a/include/linux/gpio/driver.h b/include/linux/gpio/driver.h
index a3e181e..571ad82 100644
--- a/include/linux/gpio/driver.h
+++ b/include/linux/gpio/driver.h
@@ -27,6 +27,7 @@ struct seq_file;
* @get: returns value for signal "offset"; for output signals this
* returns either the value actually sensed, or zero
* @set: assigns output value for signal "offset"
+ * @set_multi: assigns output values for multiple signals defined by "mask"
* @set_debounce: optional hook for setting debounce time for specified gpio in
* interrupt triggered gpio chips
* @to_irq: optional hook supporting non-static gpio_to_irq() mappings;
@@ -79,6 +80,8 @@ struct gpio_chip {
unsigned offset);
void (*set)(struct gpio_chip *chip,
unsigned offset, int value);
+ void (*set_multi)(struct gpio_chip *chip,
+ u64 mask, u64 value);
int (*set_debounce)(struct gpio_chip *chip,
unsigned offset,
unsigned debounce);
--
1.8.3.2
next reply other threads:[~2014-01-23 12:19 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-01-23 12:19 Rojhalat Ibrahim [this message]
2014-01-24 2:44 ` [RFC PATCH] gpiolib: introduce gpio_set_multiple function Alexandre Courbot
2014-01-24 12:36 ` Gerhard Sittig
2014-01-27 8:12 ` Rojhalat Ibrahim
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=2473803.SebQ52F62q@pcimr \
--to=imr@rtschenk.de \
--cc=linux-gpio@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).