Re: [PATCH v8 02/11] mfd: Add max7360 support

[Christophe JAILLET <christophe.jaillet@wanadoo.fr>]

Le 09/05/2025 à 11:14, mathieu.dubois-briand@bootlin.com a écrit :
> From: Kamel Bouhara <kamel.bouhara@bootlin.com>
> 
> Add core driver to support MAX7360 i2c chip, multi function device
> with keypad, GPIO, PWM, GPO and rotary encoder submodules.
> 
> Signed-off-by: Kamel Bouhara <kamel.bouhara@bootlin.com>
> Co-developed-by: Mathieu Dubois-Briand <mathieu.dubois-briand@bootlin.com>
> Signed-off-by: Mathieu Dubois-Briand <mathieu.dubois-briand@bootlin.com>
> ---

Hi,

...

> +static int max7360_mask_irqs(struct regmap *regmap)
> +{
> +	struct device *dev = regmap_get_device(regmap);
> +	unsigned int val;
> +	int ret;
> +
> +	/*
> +	 * GPIO/PWM interrupts are not masked on reset: as the MAX7360 "INTI"
> +	 * interrupt line is shared between GPIOs and rotary encoder, this could
> +	 * result in repeated spurious interrupts on the rotary encoder driver
> +	 * if the GPIO driver is not loaded. Mask them now to avoid this
> +	 * situation.
> +	 */
> +	for (unsigned int i = 0; i < MAX7360_PORT_PWM_COUNT; i++) {
> +		ret = regmap_write_bits(regmap, MAX7360_REG_PWMCFG(i),
> +					MAX7360_PORT_CFG_INTERRUPT_MASK,
> +					MAX7360_PORT_CFG_INTERRUPT_MASK);
> +		if (ret)
> +			return dev_err_probe(dev, ret,
> +					     "Failed to write MAX7360 port configuration");

Nitpick: Missing \n

> +	}
> +
> +	/* Read GPIO in register, to ACK any pending IRQ. */
> +	ret = regmap_read(regmap, MAX7360_REG_GPIOIN, &val);
> +	if (ret)
> +		return dev_err_probe(dev, ret, "Failed to read GPIO values: %d\n", ret);

Nitpick: ret is not needed in the error message.

> +
> +	return 0;
> +}

...

CJ