messages from 2023-10-11 14:58:35 to 2023-10-16 13:37:21 UTC [more...]
[PATCH v3 00/20] Add minimal Tensor/GS101 SoC support and Oriole/Pixel6 board
2023-10-16 13:36 UTC (84+ messages)
` [PATCH v3 01/20] dt-bindings: soc: samsung: exynos-pmu: Add gs101 compatible
` [PATCH v3 02/20] dt-bindings: clock: Add Google gs101 clock management unit bindings
` [PATCH v3 03/20] dt-bindings: soc: google: exynos-sysreg: add dedicated SYSREG compatibles to GS101
` [PATCH v3 04/20] dt-bindings: watchdog: Document Google gs101 & gs201 watchdog bindings
` [PATCH v3 05/20] dt-bindings: arm: google: Add bindings for Google ARM platforms
` [PATCH v3 06/20] dt-bindings: pinctrl: samsung: add google,gs101-pinctrl compatible
` [PATCH v3 07/20] dt-bindings: pinctrl: samsung: add gs101-wakeup-eint compatible
` [PATCH v3 08/20] dt-bindings: serial: samsung: Add google-gs101-uart compatible
` [PATCH v3 09/20] clk: samsung: clk-pll: Add support for pll_{0516,0517,518}
` [PATCH v3 10/20] clk: samsung: clk-gs101: Add cmu_top registers, plls, mux and gates
` [PATCH v3 11/20] clk: samsung: clk-gs101: add CMU_APM support
` [PATCH v3 12/20] clk: samsung: clk-gs101: Add support for CMU_MISC clock unit
` [PATCH v3 13/20] pinctrl: samsung: Add filter selection support for alive banks
` [PATCH v3 14/20] pinctrl: samsung: Add gs101 SoC pinctrl configuration
` [PATCH v3 15/20] watchdog: s3c2410_wdt: Add support for Google tensor SoCs
` [PATCH v3 16/20] tty: serial: samsung: Add gs101 compatible and SoC data
` [PATCH v3 17/20] arm64: dts: google: Add initial Google gs101 SoC support
` [PATCH v3 18/20] arm64: dts: google: Add initial Oriole/pixel 6 board support
` [PATCH v3 19/20] arm64: defconfig: Enable Google Tensor SoC
` [PATCH v3 20/20] MAINTAINERS: add entry for "
[libgpiod][PATCH v3 0/1] bindings: python: optionally include module in sdist
2023-10-16 13:10 UTC (3+ messages)
` [libgpiod][PATCH v3 1/1] "
[RESEND PATCH] pinctrl: qcom: lpass-lpi: fix concurrent register updates
2023-10-16 12:58 UTC (2+ messages)
[GIT PULL] pinctrl: samsung: drivers for v6.7
2023-10-16 9:42 UTC (2+ messages)
[PATCH v20 0/4] Add Intel LJCA device driver
2023-10-16 7:38 UTC (11+ messages)
` [PATCH v20 1/4] usb: Add support for Intel LJCA device
[PATCH 0/4] Add support for nuvoton ma35d1 pin control
2023-10-16 4:32 UTC (14+ messages)
` [PATCH 1/4] dt-bindings: reset: Add syscon to nuvoton ma35d1 system-management node
` [PATCH 2/4] dt-bindings: pinctrl: Document nuvoton ma35d1 pin control
` [PATCH 3/4] arm64: dts: nuvoton: Add pinctrl support for ma35d1
[PATCH v4 00/42] ep93xx device tree conversion
2023-10-15 21:17 UTC (2+ messages)
` (subset) "
[brgl:gpio/for-next] BUILD SUCCESS 8c85a102fc4e5c0c942c10677fa43f7a19baa92f
2023-10-15 2:57 UTC
[brgl:gpio/devel] BUILD SUCCESS 680b7cc8f84c182171a5af5b29d8009b811c019f
2023-10-14 9:41 UTC
[PATCH 13/21] clk: samsung: clk-gs101: Add cmu_top registers, plls, mux and gates
2023-10-14 6:37 UTC (2+ messages)
[PATCH v8 00/30] Add support for QMC HDLC, framer infrastructure and PEF2256 framer
2023-10-13 23:46 UTC (10+ messages)
` [PATCH v8 10/30] net: wan: Add support for QMC HDLC
` [PATCH v8 23/30] wan: qmc_hdlc: Add runtime timeslots changes support
` [PATCH v8 24/30] net: wan: Add framer framework support
` [PATCH v8 26/30] net: wan: framer: Add support for the Lantiq PEF2256 framer
[brgl:at24/for-next] BUILD SUCCESS 4791146e9055dd4c21a1a725514512167b8ee75b
2023-10-13 16:19 UTC
[linusw-pinctrl:fixes] BUILD SUCCESS f055ff23c331f28aa4ace4b72dc56f63b9a726c8
2023-10-13 15:57 UTC
[PATCH v2 0/2] pinctrl: qcom: lpass-lpi: allow slew rate bit in main pin config register
2023-10-13 14:59 UTC (3+ messages)
` [PATCH v2 1/2] pinctrl: qcom: lpass-lpi: split slew rate set to separate function
` [PATCH v2 2/2] pinctrl: qcom: lpass-lpi: allow slew rate bit in main pin config register
[GIT PULL] pinctrl: renesas: Updates for v6.7 (take two)
2023-10-13 13:33 UTC (2+ messages)
[libgpiod][PATCH v2 0/2] bindings: python: optionally include (...)
2023-10-13 10:53 UTC (6+ messages)
` [libgpiod][PATCH v2 1/2] bindings: python: optionally include module in sdist
` [libgpiod][PATCH v2 2/2] bindings: python: add pyproject.toml, pep 518
[PATCH v1 0/4] hte: Improve GPIO handling and other cleanups
2023-10-13 9:21 UTC (15+ messages)
` [PATCH v1 1/4] gpiolib: provide gpio_device_find_by_fwnode()
` [PATCH v1 2/4] hte: tegra194: don't access struct gpio_chip
` [PATCH v1 4/4] hte: tegra194: Switch to LATE_SIMPLE_DEV_PM_OPS()
[libgpiod][PATCH] bindings: python: simplify environ access
2023-10-13 8:36 UTC (2+ messages)
[brgl:gpio/devel 48/62] drivers/pinctrl/pinctrl-st.c:1326:9: error: implicit declaration of function 'st_gpio_direction_input'; did you mean 'st_gpio_direction_output'?
2023-10-13 7:28 UTC (2+ messages)
[PATCH 0/3] i2c: mux: don't access GPIOLIB internal structures
2023-10-13 6:50 UTC (16+ messages)
` [PATCH 1/3] gpiolib: provide gpio_device_to_device()
` [PATCH 2/3] gpiolib: provide gpiod_to_gpio_device()
` [PATCH 3/3] i2c: mux: gpio: don't fiddle with GPIOLIB internals
[GIT PULL] pin control fixes for v6.6
2023-10-12 21:21 UTC (2+ messages)
[PATCH v6 0/9] Initial Marvell PXA1908 support
2023-10-12 19:59 UTC (5+ messages)
` [PATCH v6 2/9] dt-bindings: pinctrl: pinctrl-single: add marvell,pxa1908-padconf compatible
[PATCH v2 00/62] pinctrl: don't use GPIOLIB global numberspace in helpers
2023-10-12 19:43 UTC (11+ messages)
` [PATCH v2 01/62] pinctrl: remove unneeded extern specifiers from consumer.h
` [PATCH v2 04/62] gpio: cdev: use pinctrl_gpio_can_use_line_new()
` [PATCH v2 31/62] pinctrl: remove pinctrl_gpio_request()
[libgpiod][PATCH 0/3] bindings: python: optionally include module (...)
2023-10-12 19:37 UTC (10+ messages)
` [libgpiod][PATCH 1/3] bindings: python: optionally include module in sdist
` [libgpiod][PATCH 2/3] bindings: python: add pyproject.toml, pep 518
` [libgpiod][PATCH 3/3] bindings: python: require python 3.9.0
[libgpiod][PATCH 0/1] bindings: python: don't use exec (...)
2023-10-12 19:17 UTC (3+ messages)
` [libgpiod][PATCH 1/1] bindings: python: don't use exec to get __version__
[brgl:gpio/devel 36/62] include/linux/pinctrl/consumer.h:76:1: error: conflicting types for 'pinctrl_gpio_can_use_line'; have 'bool(struct gpio_chip *, unsigned int)' {aka '_Bool(struct gpio_chip *, unsigned int)'}
2023-10-12 18:46 UTC
[PATCH v2 0/4] hte: Improve GPIO handling and other cleanups
2023-10-12 17:36 UTC (8+ messages)
` [PATCH v2 1/4] gpiolib: provide gpio_device_find_by_fwnode()
` [PATCH v2 2/4] hte: tegra194: don't access struct gpio_chip
` [PATCH v2 3/4] hte: tegra194: Remove redundant dev_err()
` [PATCH v2 4/4] hte: tegra194: Switch to LATE_SIMPLE_DEV_PM_OPS()
[PATCH] pinctrl: renesas: rzg2l: Configure interrupt input mode
2023-10-12 16:24 UTC (3+ messages)
[PATCH] pinctrl: Use device_get_match_data()
2023-10-12 15:41 UTC (2+ messages)
[PATCH] gpio: hisi: Fix format specifier
2023-10-12 12:47 UTC (2+ messages)
[PATCH v2 00/20] Add minimal Tensor/GS101 SoC support and Oriole/Pixel6 board
2023-10-12 11:24 UTC (6+ messages)
` [PATCH v2 07/20] dt-bindings: pinctrl: samsung: add gs101-wakeup-eint compatible
` [PATCH v2 16/20] tty: serial: samsung: Add gs101 compatible and SoC data
[PATCH] spi: bcm2835: add a sentinel at the end of the lookup array
2023-10-12 10:48 UTC (8+ messages)
[RFC v2 0/5] gpio: add pinctrl based generic gpio driver
2023-10-12 7:27 UTC (12+ messages)
` [RFC v2 4/5] "
` [RFC v2 5/5] dt-bindings: gpio: Add bindings for "
[PATCH] pinctrl: renesas: rzg2l: Enhance driver to support interrupt affinity setting
2023-10-11 19:59 UTC
[REBASE PATCH v5 00/17] Add Qualcomm Minidump kernel driver related support
2023-10-11 17:48 UTC (4+ messages)
` [REBASE PATCH v5 04/17] remoteproc: qcom: Remove minidump related data from qcom_common.c
[linusw-pinctrl:for-next] BUILD SUCCESS c766fd3059c080dca017c328481aa2ba0f707abb
2023-10-11 17:18 UTC
[linusw-pinctrl:devel] BUILD SUCCESS c341ac65bf2bf297a6e4db61c34c00971876fad6
2023-10-11 16:57 UTC
[PATCH RFT v8 0/6] ARM: pxa: GPIO descriptor conversions
2023-10-11 15:40 UTC (5+ messages)
` [PATCH RFT v8 2/6] ARM: pxa: Convert Spitz LEDs to GPIO descriptors
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).