messages from 2026-06-14 14:44:52 to 2026-06-15 07:01:37 UTC [more...]
[PATCH v2 0/2] upboard pinctrl support for device id INTC1055
2026-06-15 7:01 UTC (3+ messages)
[PATCH v2 0/2] pinctrl: qcom: Introduce Pinctrl for the upcoming Maili SoC
2026-06-15 6:55 UTC (3+ messages)
` [PATCH v2 1/2] dt-bindings: pinctrl: qcom: Describe Maili TLMM block
` [PATCH v2 2/2] pinctrl: qcom: Add the tlmm driver for Maili platform
[PATCH v2] serial: max310x: implement gpio_chip::get_direction()
2026-06-15 6:38 UTC
[PATCH v4 0/2] pinctrl: ultrarisc: add DP1000 pinctrl support
2026-06-15 5:53 UTC (4+ messages)
` [PATCH v4 2/2] pinctrl: ultrarisc: Add UltraRISC DP1000 pinctrl driver
[PATCH v2 0/8] x1e80100: Enable PDC wake GPIOs and deepest idle state
2026-06-15 5:36 UTC (21+ messages)
` [PATCH v2 2/8] irqchip/qcom-pdc: Move all statics to struct pdc_desc
` [PATCH v2 3/8] irqchip/qcom-pdc: Remove pdc_enable_intr() wrapper
` [PATCH v2 4/8] irqchip/qcom-pdc: Differentiate between direct SPI and GPIO as SPI
` [PATCH v2 5/8] irqchip/qcom-pdc: Configure PDC to pass through mode
[PATCH RFC 0/2] pinctrl: Add support gpiod_to_irq
2026-06-15 5:32 UTC (7+ messages)
` [PATCH RFC 1/2] dt-bindings: pinctl: amlogic,pinctrl-a4: Add gpio irq property
[PATCH 0/5] iio: adc: Add TI ADS126X ADC family support
2026-06-15 4:42 UTC (24+ messages)
` [PATCH 1/5] dt-bindings: iio: adc: Add TI ADS126x ADC family
` [PATCH 2/5] iio: adc: Add ti-ads1262 driver
` [PATCH 4/5] iio: adc: ti-ads1262: Add calibration support
` [PATCH 5/5] iio: adc: Add ti-ads1263-adc2 driver
[PATCH 0/2] pinctrl: qcom: Introduce Pinctrl for the upcoming Maili SoC
2026-06-15 2:34 UTC (4+ messages)
` [PATCH 2/2] pinctrl: qcom: Add the tlmm driver for Maili platform
[PATCH] Revert "i2c: designware: defer probe if child GpioInt controllers are not bound"
2026-06-14 21:56 UTC (2+ messages)
[PATCH] pinctrl: airoha: fix led1 gpio11 typo and phy4 duplicated map value
2026-06-14 14:43 UTC
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox