Linux GPIO subsystem development
 help / color / mirror / Atom feed
 messages from 2026-08-19 14:36:28 to 2026-08-19 23:26:46 UTC [more...]

[PATCH v5 0/6] rtc: s35390a: Allow use of output pin for interrupt signal 1 for wakealarm
 2026-08-19 23:26 UTC  (12+ messages)
` [PATCH v5 1/6] dt-bindings: rtc: Add pinctrl for S35390A
` [PATCH v5 2/6] rtc: s35390a: Add missing newline to dev_err
` [PATCH v5 3/6] rtc: s35390a: Fix alarm not disabling
` [PATCH v5 4/6] rtc: s35390a: force 24-hour mode
` [PATCH v5 5/6] rtc: s35390a: Add pinctrl
` [PATCH v5 6/6] rtc: s35390a: Add synology quirk

[brgl:gpio/for-next] BUILD SUCCESS 146cc263e457ff6055fe7829e4f4f4b0b5d5dd86
 2026-08-19 23:02 UTC 

[PATCH v2] gpiolib: of: Only apply the SPI CS quirk to SPI buses
 2026-08-19 15:55 UTC 

[PATCH libgpiod] build: do not require a C++ compiler if it is not needed
 2026-08-19 20:13 UTC 

[PATCH v2 0/2] gpio: realtek-otto: add pinctrl support
 2026-08-19 20:06 UTC  (5+ messages)
` [PATCH v2 1/2] dt-bindings: gpio: otto-gpio: Add gpio-ranges
` [PATCH v2 2/2] gpio: realtek-otto: add pinctrl support

[GIT PULL] gpio updates for v7.3-rc1 - take 2
 2026-08-19 17:20 UTC  (2+ messages)

[GIT PULL] gpio updates for v7.3-rc1
 2026-08-19 17:20 UTC  (2+ messages)

[PATCH v2 00/13] x86/msr: Drop 32-bit MSR interfaces
 2026-08-19 15:33 UTC  (4+ messages)

[PATCH] pinctrl: qcom: nord: Split QUP1 SE2/SE3 into lane-pair functions
 2026-08-19 15:27 UTC  (2+ messages)

[PATCH v5 0/5] pinctrl: renesas: rzg2l: Add support for RZ/G3S I3C
 2026-08-19 14:35 UTC  (6+ messages)
` [PATCH v5 1/5] pinctrl: renesas: rzg2l: Generalize the power source code
` [PATCH v5 2/5] pinctrl: renesas: rzg2l: Drop defines present in struct rzg2l_hwcfg
` [PATCH v5 3/5] pinctrl: renesas: rzg2l: Unify the power source handling
` [PATCH v5 4/5] dt-bindings: pinctrl: renesas,rzg2l-pinctrl: Document the missing I3C power source option
` [PATCH v5 5/5] pinctrl: renesas: rzg2l: Add RZ/G3S support for selecting the I3C power source


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox