Re: [PATCH v3 06/12] ASoC: codecs: add wsa881x-i2c amplifier codec driver

["Alexey Klimov" <alexey.klimov@linaro.org>]

Hello Srini,

On Thu May 29, 2025 at 11:05 AM BST, Srinivas Kandagatla wrote:
>
> On 5/22/25 6:40 PM, Alexey Klimov wrote:
>> Add support to analog mode of WSA8810/WSA8815 Class-D Smart Speaker
>> family of amplifiers. Such amplifiers are primarily interfaced with
>> SoundWire but they also support analog mode which is configurable by
>> setting one of the pins to high/low. In such case the WSA881X amplifier
>> is configurable only using i2c.
>> 
>> To have stereo two WSA881X amplifiers are required but mono
>> configurations are also possible.

[...]

>> --- /dev/null
>> +++ b/sound/soc/codecs/wsa881x-i2c.c

[..]

>> +struct reg_default wsa881x_ana_reg_defaults[] = {
>
> This does not make sense.
>
> All the regmaps should be same, it should not change with the change in
> interface from SWD to I2C.
>
> Could you calrify this before we start reviewing rest of the driver.

It was sent initially in nov 2024 I guess and that one was v3. v2 was
sent in December 2024.

I am currently reimplementing this. I obviously agree that registers
are the same but why we should be 100% sure that regs defaults
should be the same if the mode is different?

Or do you suggest/expect that, for instance, analog defaults should be
kinds applied on top of common (swd) default values?


[....]
(The rest of original email was sent and quoted but I did not
see any comments there, so I removed it but if I missed smth there
please let me know)

Thanks,
Alexey