Re: [PATCH net-next v8 2/9] i2c: designware: Add driver support for Wangxun 10Gb NIC

[andy.shevchenko@gmail.com]

Mon, May 15, 2023 at 02:31:53PM +0800, Jiawen Wu kirjoitti:
> Wangxun 10Gb ethernet chip is connected to Designware I2C, to communicate
> with SFP.
> 
> Introduce the property "snps,i2c-platform" to match device data for Wangxun
> in software node case. Since IO resource was mapped on the ethernet driver,
> add a model quirk to get regmap from parent device.
> 
> The exists IP limitations are dealt as workarounds:
> - IP does not support interrupt mode, it works on polling mode.
> - Additionally set FIFO depth address the chip issue.

...

>  	dev->flags = (uintptr_t)device_get_match_data(&pdev->dev);
> +	if (device_property_present(&pdev->dev, "snps,i2c-platform"))
> +		dev->flags |= MODEL_WANGXUN_SP;

What I meant here is to use device_property_present() _iff_ you have decided to
go with the _vendor-specific_ property name.

Otherwise it should be handled differently, i.e. with reading the actual value
of that property. Hence it should correspond the model enum, which you need to
declare in the Device Tree bindings before use.

So, either

	if (device_property_present(&pdev->dev, "wx,..."))
		dev->flags |= MODEL_WANGXUN_SP;

or

	if ((dev->flags & MODEL_MASK) == MODEL_NONE) {
	// you now have to distinguish that there is no model set in driver data
		u32 model;

		ret = device_property_read_u32(dev, "snps,i2c-platform");
		if (ret) {
			...handle error...
		}
		dev->flags |= model

-- 
With Best Regards,
Andy Shevchenko