From mboxrd@z Thu Jan 1 00:00:00 1970 From: Timur Tabi Subject: Re: [PATCH] pinctrl: qcom: qdf2xxx: expose only some GPIO pins Date: Fri, 23 Jun 2017 08:28:58 -0500 Message-ID: References: <1498164850-4738-1-git-send-email-timur@codeaurora.org> Mime-Version: 1.0 Content-Type: text/plain; charset=utf-8; format=flowed Content-Transfer-Encoding: 7bit Return-path: Received: from smtp.codeaurora.org ([198.145.29.96]:51398 "EHLO smtp.codeaurora.org" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751256AbdFWN3B (ORCPT ); Fri, 23 Jun 2017 09:29:01 -0400 In-Reply-To: Content-Language: en-US Sender: linux-gpio-owner@vger.kernel.org List-Id: linux-gpio@vger.kernel.org To: Linus Walleij Cc: Andy Gross , David Brown , "linux-arm-kernel@lists.infradead.org" , "linux-gpio@vger.kernel.org" , Bjorn Andersson On 6/23/17 7:33 AM, Linus Walleij wrote: >> Instead, the ACPI table now lists only specific GPIOs that are exposed >> externally as generic GPIO pins. > > The ACPI table or the device tree property "gpios" right? > > (But maybe this system is only using ACPI.) It's only ACPI. > I think using "lsgpio" fron tools/gpio/lsgpio.c is better to inspect > the available GPIOs. > > If you haven't tested the GPIO tools, please try it out. I was not aware of these tools. I will try them out, thanks. -- Sent by an employee of the Qualcomm Innovation Center, Inc. The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by The Linux Foundation.