Re: [PATCH v3 6/9] iio: adc: ti-ads1262: support excitation currents

[David Lechner <dlechner@baylibre.com>]

On 8/7/26 10:58 PM, Kurt Borja wrote:
> Support the two IDAC excitation current sources. Each channel can route
> its IDAC1/IDAC2 outputs to a pin via the "excitation-channels" property
> and select a magnitude via "excitation-current-nanoamp".
> 

Reviewed-by: David Lechner <dlechner@baylibre.com>

> @@ -1150,7 +1192,58 @@ static int ads1262_parse_channel_node(struct ads1262 *st,
>  		}
>  	}
>  
> +	if (fwnode_property_present(node, "excitation-channels")) {
> +		count = fwnode_property_count_u32(node, "excitation-channels");
> +		if (count < 0)
> +			return dev_err_probe(dev, count,
> +					     "%s: failed to count excitation-channels\n",
> +					     fwnode_get_name(node));
> +
> +		pins[0] = ADS1262_IDACMUX_NO_CONN;
> +		pins[1] = ADS1262_IDACMUX_NO_CONN;
> +		ret = fwnode_property_read_u32_array(node, "excitation-channels",
> +						     pins, min(count, ARRAY_SIZE(pins)));
> +		if (ret)
> +			return dev_err_probe(dev, ret, "%s: failed to read excitation-channels\n",
> +					     fwnode_get_name(node));
> +		if (pins[0] > ADS1262_IDACMUX_NO_CONN || pins[1] > ADS1262_IDACMUX_NO_CONN)
> +			return dev_err_probe(dev, -EINVAL, "%s: excitation-channels not in range\n",
> +					     fwnode_get_name(node));
> +		chan->idac_mux[0] = pins[0];
> +		chan->idac_mux[1] = pins[1];
> +
> +		mags[0] = 0;
> +		mags[1] = 0;
> +		ret = fwnode_property_read_u32_array(node, "excitation-current-nanoamp",
> +						     mags, min(count, ARRAY_SIZE(mags)));
> +		if (ret == -EOVERFLOW)
> +			return dev_err_probe(dev, ret,
> +					     "%s: excitation-current-nanoamp size mismatch\n",
> +					     fwnode_get_name(node));

I don't think we need a special error message for this case. The error code will already
be printed.

> +		if (ret)
> +			return dev_err_probe(dev, ret,
> +					     "%s: failed to read excitation-current-nanoamp\n",
> +					     fwnode_get_name(node));
> +