From mboxrd@z Thu Jan 1 00:00:00 1970 From: Dave Platt Subject: Re: Filter for 430Mhz Date: Tue, 9 Aug 2005 14:11:42 -0700 (PDT) Message-ID: <20050809211142.4910.qmail@radagast.org> References: <200508092151.57245.stephen@g6dzj.demon.co.uk> Mime-Version: 1.0 Return-path: In-Reply-To: <200508092151.57245.stephen@g6dzj.demon.co.uk> Sender: linux-hams-owner@vger.kernel.org List-Id: Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: stephen@g6dzj.demon.co.uk Cc: linux-hams@vger.kernel.org > I have a problem with a really near 430Mz transmitter (my own) that is > breaking though to the TV. The Transmitter isn't off tune and as far as I > Know or can see, it isn't producing any side transmissions or birdies. I had similar problems with my 2-meter transmissions affecting all the TVs in the house. The root of the problem was the use of a cheap Radio Shack TV signal amplifier and distribution box. The strong local signal was overdriving the amplifier (probably a 1- or 2-transistor broadband design) and causing it to distort every signal passing through it. You may be running into a similar problem, even if you don't have a separate distribution amplifier. TV tuner circuits are often optimized for weak-signal conditions, and may not have a high enough IP3 to hold off a strong local signal. This "fundamental overload" can't be cured at the transmitter, as you clearly understand - you have to keep the strong signal out of the electronics which were being overdriven. > So, My question is, does anyone know of a really good filter design or > commercial filer that will block 430.625 so that it dosn't appear in the > downlead to the TV. You'll need a notch or bandstop filter, or a set of paralleled bandpass filters, to allow the TV frequencies through and block the 430 MHz signal. A notch or bandstop will probably be the best way to go. The solution I found (after searching around for quite a while) is a notch filter made by the Tin Lee company in Canada. They specialize in TV filters of various sorts, and their selection is much richer than I was able to find via any local supplier. The one I bought was one of their CR7 models - a band-stop type which knocks out everything from 130 MHz to 175 MHz. Mounted right up at the antenna, it does a beautiful job... the overload/interference problem has gone away entirely. I suggest that you contact them at www.tinlee.com, and give them the details of the frequency range(s) you want to pass and which you wish to notch out. They may have a stock model which will do what you want, they have some tunable models, and if all else fails I'm sure they can build you a custom trap against the frequency you're concerned about. You could try building a coaxial-trap notch (e.g. a quarter-wave open section of coax, or a half-wave shorted section of coax, connected in parallel with the feedline) but this might have adverse effects on other frequencies. 73, Dave AE6EO