From mboxrd@z Thu Jan 1 00:00:00 1970 From: Dave Platt Subject: Re: struggling with gMFSK setup Date: Tue, 31 Oct 2006 14:58:20 -0800 (PST) Message-ID: References: <20061031192555.780641768@teufel.hartford-hwp.com> Mime-Version: 1.0 Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <20061031192555.780641768@teufel.hartford-hwp.com> Sender: linux-hams-owner@vger.kernel.org List-Id: Content-Type: text/plain; charset="us-ascii" To: brownh@hartford-hwp.com Cc: linux-hams@vger.kernel.org brownh@hartford-hwp.com (Haines Brown) wrote: > Kind of a progress report on my initial query. > > I had to do some stumbling about to get myself set up my soundcard to > record so that I might perform a test on my soundcard. I was > eventually able to record and playback sound from my transceiver, and > so the soundcard is working. > > However, I found that if my transceiver (FT-817) audio was at all up, > it triggered the PTT LED on my SignaLink interface, at which point it > blocked sound getting to my sound cards' Mike conenction. As a result, > the volume level on my transceiver had to be turned most of the way > down, and as a result, only a very weak signal was recorded. It's common for a soundcard's mic input to have two different audio routing pathways associated with it. When the input is in the "play" mode, the signal coming from it is mixed into the outgoing (speaker or headphone) audio output, at the level controlled by the input's software volume control. The signal may also be digitized and captured. When the input is in the "record" or "capture" mode, the signal coming from it doesn't go to the outgoing audio output, but only to the digitize-and-capture logic. The same is usually true for the line-level input(s). On some cards, these two signal pathways have a common volume control setting, and there's just a mode switch (record or playback) which controls the particular pathway which is enabled at any given time. On other cards, the two pathways have individual enable/disable switches as well as individual volume controls. What you want, for computer-to-rig hookup, is to put whatever input you're using into the "record" mode. This will prevent the rig's audio signal (fed to the sound card) from being fed back into the rig via the speaker pathway, and will ensure that you won't get accidental or inappropriate triggering of the vox (whether that's on the rig, or in your audio interface box). When using ALSA, you can manipulate the input's mode via the GUI in the "amixer" program. What you'd want to do, I think, is select the input that you're using (MIC, probably), hit the M key to mute it (the display will show MM to indicate that it's muted), and enable capture with the space bar (the display will show CAPTUR rather than ------). This should let you set your rig's audio output level high enough to permit a high-quality signal capture and digitization, without inadvertently feeding back the audio into the transmit side and triggering the vox/PTT.