From mboxrd@z Thu Jan 1 00:00:00 1970 From: Greg KH Date: Wed, 25 May 2005 15:55:57 +0000 Subject: Re: 2.6.12-rc4+ & udev kobject problem Message-Id: <20050525155557.GA22298@kroah.com> List-Id: References: <42931DD4.4040200@iit.demokritos.gr> In-Reply-To: <42931DD4.4040200@iit.demokritos.gr> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-hotplug@vger.kernel.org On Wed, May 25, 2005 at 02:55:38PM +0300, Vassilis Virvilis wrote: > Greg KH wrote: > >On Tue, May 24, 2005 at 03:28:04PM +0300, Vassilis Virvilis wrote: > > > > > >>[] load_module+0x733/0x9c0 > >>[] sys_init_module+0x5f/0x1f0 > >>[] syscall_call+0x7/0xb > > > > > >Oh, that's not good at all. What module were you loading at this point > >in time? > > That's the point I don't know... > > I tried to enable modules-init-tools logging facilities but they use > syslog. I put descriptive printf instead but I still didn't get any info > at all. Is vsysolg output visible before syslog runs? How can I persuade > modrpobe to be more verbose? You can modify it to do so. > The modprobe is a custom port of mine to klibc (the porting was quite > straight forward patches available to klibc mailing list). I don't > expect problems because of that but you never know... Hm, at this point in time, I'd suspect your modprobe as I haven't seen this error reported before. But you never know... Good luck, greg k-h ------------------------------------------------------- SF.Net email is sponsored by: GoToMeeting - the easiest way to collaborate online with coworkers and clients while avoiding the high cost of travel and communications. There is no equipment to buy and you can meet as often as you want. Try it free.http://ads.osdn.com/?ad_idt02&alloc_id135&op=click _______________________________________________ Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net Linux-hotplug-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel