From mboxrd@z Thu Jan 1 00:00:00 1970 From: Leon Cogs Date: Wed, 14 Jan 2004 19:38:50 +0000 Subject: Re:hotplug script goes bonkers with 2.6.1 Message-Id: <40059ACA.9050001@eircom.net> List-Id: References: <20040113081013.3783E39C2@mprdmxin.myway.com> In-Reply-To: <20040113081013.3783E39C2@mprdmxin.myway.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-hotplug@vger.kernel.org Same here. I unloaded scanner form kernel but I don't know how to set it up otherwise as advised "you can just use xsane through usbfs instead" . I have looked all over. Below is a line in /etc/sysconfig/hotplug could this cause bother if scanner modules has been deleted from kernel? ##Type: string ##Default: scanner ##ServiceRestart: # HOTPLUG_USB_MODULES_TO_UNLOAD="scanner" Also printer epson 740 doesn't load as a module unless I modprobe usblp and then set it up in Yast2 Suse 9, How is this done. Another problem is a maxtor usb2 hard disk and iomega usb2 cdwriter which dont hotplug in 2.6.1-rc1 Below are 2 lines which I included in fstab which seem to access these devices at the moment, but I am not sure about. /dev/sda1 /media/sda1 auto sync,noauto,user,exec 0 0 # for ext hd dev/sr0 /media/sr0 auto ro,noauto,user,exec 0 0 #for writer LmCogs ------------------------------------------------------- This SF.net email is sponsored by: Perforce Software. Perforce is the Fast Software Configuration Management System offering advanced branching capabilities and atomic changes on 50+ platforms. Free Eval! http://www.perforce.com/perforce/loadprog.html _______________________________________________ Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net Linux-hotplug-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel