From: Marco Bettini <marco.bettini@ragesistemi.it>
To: linux-hotplug@vger.kernel.org
Subject: error plugging usb hard drive token with crypto capabilities
Date: Wed, 08 Dec 2004 15:57:32 +0000 [thread overview]
Message-ID: <41B7246C.9000402@ragesistemi.it> (raw)
Hi all, i've got a linux box:
fedora core 3 up2dated
i tied to plug my usb token "MIA" from SATA hi-tech services that can
permit to be a simple usb static disk or a ciphered data disk via usb
but kernel started trying to access without success.
There's the /var/log/messages dump the firt half for the insertion and
the second one for the extraction.
Thanks for your job!
Marco Bettini
Dec 8 16:50:13 marcorh kernel: hub 1-0:1.0: connect-debounce failed,
port 8 dis
abled
Dec 8 16:50:13 marcorh kernel: usb 5-1: new full speed USB device using
address
4
Dec 8 16:50:13 marcorh kernel: usb 5-1: config 1 has an invalid
interface numbe
r: 1 but max is 0
Dec 8 16:50:13 marcorh kernel: usb 5-1: config 1 has 2 interfaces,
different fr
om the descriptor's value: 1
Dec 8 16:50:14 marcorh kernel: Initializing USB Mass Storage driver...
Dec 8 16:50:14 marcorh kernel: scsi2 : SCSI emulation for USB Mass
Storage devi
ces
Dec 8 16:50:14 marcorh kernel: Vendor: SATA MIA Model: Flash Media
R/W Rev
:
Dec 8 16:50:14 marcorh kernel: Type:
Direct-Access ANS
I SCSI revision: 02
Dec 8 16:50:14 marcorh kernel: sda : READ CAPACITY failed.
Dec 8 16:50:14 marcorh kernel: sda : status=0, message\0, host=7,
driver\0
Dec 8 16:50:14 marcorh kernel: sda : sense not available.
Dec 8 16:50:14 marcorh kernel: sda: Write Protect is off
Dec 8 16:50:14 marcorh kernel: sda: assuming drive cache: write through
Dec 8 16:50:19 marcorh wait_for_sysfs[4676]: either wait_for_sysfs
(udev 039) n
eeds an update to handle the device
'/devices/pci0000:00/0000:00:1d.3/usb5/5-1/5
-1:1.0/host2/2:0:0:0' properly (no bus device link) or the sysfs-support
of your
device's driver needs to be fixed, please report to
<linux-hotplug-devel@lists.
sourceforge.net>
Dec 8 16:50:19 marcorh wait_for_sysfs[4684]: either wait_for_sysfs
(udev 039) n
eeds an update to handle the device '/block/sda' properly (no bus device
link) o
r the sysfs-support of your device's driver needs to be fixed, please
report to
<linux-hotplug-devel@lists.sourceforge.net>
Dec 8 16:50:26 marcorh kernel: sda : READ CAPACITY failed.
Dec 8 16:50:26 marcorh kernel: sda : status=0, message\0, host=7,
driver\0
Dec 8 16:50:26 marcorh kernel: sda : sense not available.
Dec 8 16:50:29 marcorh hal.hotplug[4687]: timout(10000 ms) waiting for
/devices
/pci0000:00/0000:00:1d.3/usb5/5-1/5-1:1.0/host2/2:0:0:0
Dec 8 16:50:39 marcorh scsi.agent[4699]: Attribute
/sys/devices/pci0000:00/0000
:00:1d.3/usb5/5-1/5-1:1.0/host2/2:0:0:0/type does not exist
Dec 8 16:50:50 marcorh kernel: sda: Write Protect is off
Dec 8 16:50:50 marcorh kernel: sda: assuming drive cache: write through
Dec 8 16:50:50 marcorh kernel: sda : READ CAPACITY failed.
Dec 8 16:50:50 marcorh kernel: sda : status=0, message\0, host=7,
driver\0
Dec 8 16:50:50 marcorh kernel: sda : sense not available.
Dec 8 16:50:50 marcorh kernel: sda: Write Protect is off
Dec 8 16:50:50 marcorh kernel: sda: assuming drive cache: write through
Dec 8 16:50:50 marcorh kernel: sda:<3>Buffer I/O error on device sda,
logical
block 0
Dec 8 16:50:50 marcorh kernel: Buffer I/O error on device sda, logical
block 0
Dec 8 16:50:50 marcorh kernel: Buffer I/O error on device sda, logical
block 26
2143
Dec 8 16:50:50 marcorh kernel: Buffer I/O error on device sda, logical
block 26
2143
Dec 8 16:50:50 marcorh kernel: Buffer I/O error on device sda, logical
block 0
Dec 8 16:50:50 marcorh kernel: unable to read partition table
Dec 8 16:50:50 marcorh kernel: sda:<3>Buffer I/O error on device sda,
logical
block 0
Dec 8 16:50:50 marcorh kernel: Buffer I/O error on device sda, logical
block 26
2143
Dec 8 16:50:50 marcorh kernel: Buffer I/O error on device sda, logical
block 0
Dec 8 16:50:50 marcorh kernel: unable to read partition table
Dec 8 16:50:50 marcorh kernel: Attached scsi removable disk sda at
scsi2, chann
el 0, id 0, lun 0
Dec 8 16:50:50 marcorh kernel: usbcore: registered new driver usb-storage
Dec 8 16:50:50 marcorh kernel: USB Mass Storage support registered.
Dec 8 16:50:50 marcorh kernel: usb 5-1: USB disconnect, address 4
Dec 8 16:50:50 marcorh hald[2835]: Timed out waiting for hotplug event
325. Reb
asing to 325
Dec 8 16:50:52 marcorh kernel: hub 1-0:1.0: connect-debounce failed,
port 8 dis
abled
Dec 8 16:50:52 marcorh hald[2835]: Timed out waiting for hotplug event
330. Reb
asing to 331
Dec 8 16:50:55 marcorh wait_for_sysfs[4721]: either wait_for_sysfs
(udev 039) n
eeds an update to handle the device '/class/scsi_device/2:0:0:0'
properly (no de
vice symlink) or the sysfs-support of your device's driver needs to be
fixed, pl
ease report to <linux-hotplug-devel@lists.sourceforge.net>
-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://productguide.itmanagersjournal.com/
_______________________________________________
Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net
Linux-hotplug-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel
next reply other threads:[~2004-12-08 15:57 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2004-12-08 15:57 Marco Bettini [this message]
2004-12-08 20:43 ` error plugging usb hard drive token with crypto capabilities Kay Sievers
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=41B7246C.9000402@ragesistemi.it \
--to=marco.bettini@ragesistemi.it \
--cc=linux-hotplug@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).