From mboxrd@z Thu Jan 1 00:00:00 1970 From: Hin-Tak Leung Date: Sun, 17 Nov 2002 13:02:47 +0000 Subject: Re: 2.4.18 kernel oops when eject and hot-plug cardbus card again. Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-hotplug@vger.kernel.org Tried 2.4.19 - it is better, doesn't oops, but after eject (cardctl eject 0; modprobe -r aic7xxx; ... ; modprobe aic7xxx), it won't detect the cd-writer hanging off the end of the SlimSCSI 1480A card. I have most of the scsi stuff (scsi disk, scsi cd, scsi generic, etc) compiled into the kernel. Would it make any difference if I have them as modules? I used to have them compiled into the kernel for my 2.2.x+pcmcia-cs setup, and it has been working fine then. Greg KH wrote: >On Fri, Nov 15, 2002 at 04:53:43AM +0000, Hin-Tak Leung wrote: > > >>Hi. I have recently upgraded to 2.4.18+pci hotplug (the rest of the >>system is mostly Slackware 8.1). >> >> > >Hm, could you try a more recent kernel (like 2.4.19 at the minimum?) >2.4.18 was released last February, which was quite a while ago. > >thanks, > >greg k-h > > > ------------------------------------------------------- This sf.net email is sponsored by: To learn the basics of securing your web site with SSL, click here to get a FREE TRIAL of a Thawte Server Certificate: http://www.gothawte.com/rd524.html _______________________________________________ Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net Linux-hotplug-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel