From mboxrd@z Thu Jan 1 00:00:00 1970 From: "Surekha.PC" Date: Wed, 19 Nov 2003 13:48:03 +0000 Subject: RE: udev does not create scsi disk entries during bootup Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-hotplug@vger.kernel.org Hi all, Request your attention for the problem I am facing. This issue is urgent for our iSCSI driver inclusion to 2.6 kernel. Appreciate your response. Thanks, surekha -----Original Message----- From: Surekha.PC [mailto:surekhap@cisco.com] Sent: Tuesday, November 18, 2003 1:42 PM To: 'Martin Hicks' Cc: 'linux-hotplug-devel@lists.sourceforge.net' Subject: RE: udev does not create scsi disk entries during bootup >> Hi, >> >> I am not able to run udev during boot time inspite of having >> installed udev, and the associated configuration. Appreciate help in >> resolving this issue soon. >> >> Is this feature working for udev-005 right now or one needs to >> manually run "udev add/remove" to configure devices ? >I suspect that you still have to run udev-005 manually unless the >devices are detected after the hotplug service starts >(i.e., if your scsi disk code is a module). Is that right Greg? Ok, that applies for native scsi disks. I have a iSCSI setup. My iSCSI disks are detected long after hotplug service has started. In that case, the device entries should have been created by udev. Does this still require sd_mod to be loaded as a module? Thanks, surekha -----Original Message----- From: Martin Hicks [mailto:mort@wildopensource.com] Sent: Monday, November 17, 2003 6:33 PM To: Surekha.PC Cc: linux-hotplug-devel@lists.sourceforge.net Subject: RE: udev does not create scsi disk entries during bootup On Sun, 2003-11-16 at 23:52, Surekha.PC wrote: > Hi, > > I am not able to run udev during boot time inspite of having > installed udev, and the associated configuration. Appreciate help in > resolving this issue soon. > > Is this feature working for udev-005 right now or one needs to > manually run "udev add/remove" to configure devices ? I suspect that you still have to run udev-005 manually unless the devices are detected after the hotplug service starts (i.e., if your scsi disk code is a module). Is that right Greg? mh -- Martin Hicks Wild Open Source Inc. mort@wildopensource.com 613-266-2296 ------------------------------------------------------- This SF.net email is sponsored by: SF.net Giveback Program. Does SourceForge.net help you be more productive? Does it help you create better code? SHARE THE LOVE, and help us help YOU! Click Here: http://sourceforge.net/donate/ _______________________________________________ Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net Linux-hotplug-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel