From mboxrd@z Thu Jan 1 00:00:00 1970 From: Brad Hards Date: Sat, 19 May 2001 03:13:14 +0000 Subject: Re: Hotplug and USB device removal Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: linux-hotplug@vger.kernel.org Stephen Williams wrote: > Also, as you guessed, I have a program that loads the ez-usb device > from user mode. It won't be much effort for me to polish up and > make it available to the world (especially since it supports sdcc > output) as a generic ez-usb loader, but there must be millions of > them out there:-) I would be keen to see this loader work with the ezusb_load_0-3.tar.gz module that Adam Richter put together (ftp://ftp.yggdrasil.com/private/adam/ezusb/). Ideally, the loader would be generalized to handle a range of different formats (automatically, if possible). I had planned to do some work in this area (sdcc toolchain, and support libs for EZUSB FX2), but I also have an original anchorchips EZUSB board to do some testing (and a port of the ezload code from the BSD community). I still don't support removing the various firmware codes from the kernel without better reasons that have been presented to date, but I do support being _able_ to do it from user speace. Brad _______________________________________________ Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net Linux-hotplug-devel@lists.sourceforge.net http://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel