D-Link 660TX with tulip - but no eth0

D-Link 660TX with tulip - but no eth0

[Matthias Leonhardt]

Hello hotpluggers,

after I properly set up my kernel 2.4.9 to use hotplugging and
pccard to get my networkcard running the hotplug-script loads successful
the tulip_cb - module without any error. 
PCI enables the device 15:00.0  (0000 -} 0003) and lsmod shows that 
tulip_cb is loaded. But ifconfig eth0 up fails because no eth0 exists.
What should I do to get an eth0-device from the tulib_cb - Module?

thanks for Your hints!

bye Leo

_______________________________________________
Linux-hotplug-devel mailing list  http://linux-hotplug.sourceforge.net
Linux-hotplug-devel@lists.sourceforge.net
http://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel

Re: D-Link 660TX with tulip - but no eth0

[David Hinds]

On Thu, Aug 30, 2001 at 12:10:20AM +0200, Matthias Leonhardt wrote:
> Hello hotpluggers,
> 
> after I properly set up my kernel 2.4.9 to use hotplugging and
> pccard to get my networkcard running the hotplug-script loads successful
> the tulip_cb - module without any error. 

The hotplug script should not load tulip_cb because tulip_cb is an
old-style CardBus driver and is "owned" by cardmgr; the correct
hotplug driver would be the plain tulip module.

-- Dave

_______________________________________________
Linux-hotplug-devel mailing list  http://linux-hotplug.sourceforge.net
Linux-hotplug-devel@lists.sourceforge.net
http://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel