[PATCH 3/7] hwmon: (it87) Improve IT8622 support

[Guenter Roeck <linux@roeck-us.net>]

Configuration registers on ITE8622 are different to 8620 and 8628 and
require special handling. Also, the chip supports up to 5 pwm controls.

Signed-off-by: Guenter Roeck <linux@roeck-us.net>
---
 drivers/hwmon/it87.c | 67 +++++++++++++++++++++++++++++++++++++++++++++-------
 1 file changed, 59 insertions(+), 8 deletions(-)

diff --git a/drivers/hwmon/it87.c b/drivers/hwmon/it87.c
index 4d9090f89401..11a28b233006 100644
--- a/drivers/hwmon/it87.c
+++ b/drivers/hwmon/it87.c
@@ -295,10 +295,11 @@ struct it87_devices {
 #define FEAT_SIX_FANS		BIT(11)	/* Supports six fans */
 #define FEAT_10_9MV_ADC		BIT(12)
 #define FEAT_AVCC3		BIT(13)	/* Chip supports in9/AVCC3 */
-#define FEAT_SIX_PWM		BIT(14)	/* Chip supports 6 pwm chn */
-#define FEAT_PWM_FREQ2		BIT(15)	/* Separate pwm freq 2 */
-#define FEAT_SIX_TEMP		BIT(16)	/* Up to 6 temp sensors */
-#define FEAT_VIN3_5V		BIT(17)	/* VIN3 connected to +5V */
+#define FEAT_FIVE_PWM		BIT(14)	/* Chip supports 5 pwm chn */
+#define FEAT_SIX_PWM		BIT(15)	/* Chip supports 6 pwm chn */
+#define FEAT_PWM_FREQ2		BIT(16)	/* Separate pwm freq 2 */
+#define FEAT_SIX_TEMP		BIT(17)	/* Up to 6 temp sensors */
+#define FEAT_VIN3_5V		BIT(18)	/* VIN3 connected to +5V */
 
 static const struct it87_devices it87_devices[] = {
 	[it87] = {
@@ -444,8 +445,8 @@ static const struct it87_devices it87_devices[] = {
 		.suffix = "E",
 		.features = FEAT_NEWER_AUTOPWM | FEAT_12MV_ADC | FEAT_16BIT_FANS
 		  | FEAT_TEMP_OFFSET | FEAT_TEMP_PECI | FEAT_FIVE_FANS
-		  | FEAT_IN7_INTERNAL | FEAT_PWM_FREQ2 | FEAT_AVCC3
-		  | FEAT_VIN3_5V,
+		  | FEAT_FIVE_PWM | FEAT_IN7_INTERNAL | FEAT_PWM_FREQ2
+		  | FEAT_AVCC3 | FEAT_VIN3_5V,
 		.peci_mask = 0x07,
 	},
 	[it8628] = {
@@ -477,6 +478,8 @@ static const struct it87_devices it87_devices[] = {
 #define has_in7_internal(data)	((data)->features & FEAT_IN7_INTERNAL)
 #define has_six_fans(data)	((data)->features & FEAT_SIX_FANS)
 #define has_avcc3(data)		((data)->features & FEAT_AVCC3)
+#define has_five_pwm(data)	((data)->features & (FEAT_FIVE_PWM \
+						     | FEAT_SIX_PWM))
 #define has_six_pwm(data)	((data)->features & FEAT_SIX_PWM)
 #define has_pwm_freq2(data)	((data)->features & FEAT_PWM_FREQ2)
 #define has_six_temp(data)	((data)->features & FEAT_SIX_TEMP)
@@ -1929,11 +1932,13 @@ static ssize_t show_label(struct device *dev, struct device_attribute *attr,
 		"+5V",
 		"5VSB",
 		"Vbat",
+		"AVCC",
 	};
 	static const char * const labels_it8721[] = {
 		"+3.3V",
 		"3VSB",
 		"Vbat",
+		"+3.3V",
 	};
 	struct it87_data *data = dev_get_drvdata(dev);
 	int nr = to_sensor_dev_attr(attr)->index;
@@ -1952,7 +1957,7 @@ static SENSOR_DEVICE_ATTR(in3_label, S_IRUGO, show_label, NULL, 0);
 static SENSOR_DEVICE_ATTR(in7_label, S_IRUGO, show_label, NULL, 1);
 static SENSOR_DEVICE_ATTR(in8_label, S_IRUGO, show_label, NULL, 2);
 /* AVCC3 */
-static SENSOR_DEVICE_ATTR(in9_label, S_IRUGO, show_label, NULL, 0);
+static SENSOR_DEVICE_ATTR(in9_label, S_IRUGO, show_label, NULL, 3);
 
 static umode_t it87_in_is_visible(struct kobject *kobj,
 				  struct attribute *attr, int index)
@@ -2475,8 +2480,10 @@ static int __init it87_find(int sioaddr, unsigned short *address,
 	else
 		sio_data->skip_in |= BIT(9);
 
-	if (!has_six_pwm(config))
+	if (!has_five_pwm(config))
 		sio_data->skip_pwm |= BIT(3) | BIT(4) | BIT(5);
+	else if (!has_six_pwm(config))
+		sio_data->skip_pwm |= BIT(5);
 
 	if (!has_vid(config))
 		sio_data->skip_vid = 1;
@@ -2620,6 +2627,50 @@ static int __init it87_find(int sioaddr, unsigned short *address,
 			sio_data->skip_fan |= BIT(5);
 		}
 
+		/* Check if AVCC is on VIN3 */
+		reg = superio_inb(sioaddr, IT87_SIO_PINX2_REG);
+		if (reg & BIT(0))
+			sio_data->internal |= BIT(0);
+		else
+			sio_data->skip_in |= BIT(9);
+
+		sio_data->beep_pin = superio_inb(sioaddr,
+						 IT87_SIO_BEEP_PIN_REG) & 0x3f;
+	} else if (sio_data->type == it8622) {
+		int reg;
+
+		superio_select(sioaddr, GPIO);
+
+		/* Check for pwm4, fan4 */
+		reg = superio_inb(sioaddr, IT87_SIO_GPIO1_REG);
+		if (reg & BIT(6))
+			sio_data->skip_fan |= BIT(3);
+		if (reg & BIT(5))
+			sio_data->skip_pwm |= BIT(3);
+
+		/* Check for pwm3, fan3, pwm5, fan5 */
+		reg = superio_inb(sioaddr, IT87_SIO_GPIO3_REG);
+		if (reg & BIT(6))
+			sio_data->skip_pwm |= BIT(2);
+		if (reg & BIT(7))
+			sio_data->skip_fan |= BIT(2);
+		if (reg & BIT(3))
+			sio_data->skip_pwm |= BIT(4);
+		if (reg & BIT(1))
+			sio_data->skip_fan |= BIT(4);
+
+		/* Check for pwm2, fan2 */
+		reg = superio_inb(sioaddr, IT87_SIO_GPIO5_REG);
+		if (reg & BIT(1))
+			sio_data->skip_pwm |= BIT(1);
+		if (reg & BIT(2))
+			sio_data->skip_fan |= BIT(1);
+
+		/* Check for AVCC */
+		reg = superio_inb(sioaddr, IT87_SIO_PINX2_REG);
+		if (!(reg & BIT(0)))
+			sio_data->skip_in |= BIT(9);
+
 		sio_data->beep_pin = superio_inb(sioaddr,
 						 IT87_SIO_BEEP_PIN_REG) & 0x3f;
 	} else {
-- 
2.7.4