Re: [PATCH hwmon 1/1] hwmon: (pmbus) Fix sensors readouts for MPS Multi-phase mp2888 controller

[Guenter Roeck <linux@roeck-us.net>]

On Thu, Sep 29, 2022 at 03:16:42PM +0300, Oleksandr Shamray wrote:
> Fix scale factors for reading MPS Multi-phase mp2888 controller.
> Fixed sensors:
>     - PIN/POUT: based on vendor documentation, set bscale factor 0.5W/LSB
>     - IOUT: based on vendor documentation, set scale factor 0.25 A/LSB
> 
> Fixes: e4db7719d037 ("hwmon: (pmbus) Add support for MPS Multi-phase mp2888 controller")
> Signed-off-by: Oleksandr Shamray <oleksandrs@nvidia.com>
> Reviewed-by: Vadim Pasternak <vadimp@nvidia.com>

Applied.

Thanks,
Guenter

> ---
>  drivers/hwmon/pmbus/mp2888.c | 11 +++++------
>  1 file changed, 5 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/hwmon/pmbus/mp2888.c b/drivers/hwmon/pmbus/mp2888.c
> index 8ecd4adfef40..529eb3c95bb6 100644
> --- a/drivers/hwmon/pmbus/mp2888.c
> +++ b/drivers/hwmon/pmbus/mp2888.c
> @@ -109,7 +109,7 @@ mp2888_read_phase(struct i2c_client *client, struct mp2888_data *data, int page,
>  	 * - Kcs is the DrMOS current sense gain of power stage, which is obtained from the
>  	 *   register MP2888_MFR_VR_CONFIG1, bits 13-12 with the following selection of DrMOS
>  	 *   (data->curr_sense_gain):
> -	 *   00b - 5µA/A, 01b - 8.5µA/A, 10b - 9.7µA/A, 11b - 10µA/A.
> +	 *   00b - 8.5µA/A, 01b - 9.7µA/A, 1b - 10µA/A, 11b - 5µA/A.
>  	 * - Rcs is the internal phase current sense resistor. This parameter depends on hardware
>  	 *   assembly. By default it is set to 1kΩ. In case of different assembly, user should
>  	 *   scale this parameter by dividing it by Rcs.
> @@ -118,10 +118,9 @@ mp2888_read_phase(struct i2c_client *client, struct mp2888_data *data, int page,
>  	 * because sampling of current occurrence of bit weight has a big deviation, especially for
>  	 * light load.
>  	 */
> -	ret = DIV_ROUND_CLOSEST(ret * 100 - 9800, data->curr_sense_gain);
> -	ret = (data->phase_curr_resolution) ? ret * 2 : ret;
> +	ret = DIV_ROUND_CLOSEST(ret * 200 - 19600, data->curr_sense_gain);
>  	/* Scale according to total current resolution. */
> -	ret = (data->total_curr_resolution) ? ret * 8 : ret * 4;
> +	ret = (data->total_curr_resolution) ? ret * 2 : ret;
>  	return ret;
>  }
>  
> @@ -212,7 +211,7 @@ static int mp2888_read_word_data(struct i2c_client *client, int page, int phase,
>  		ret = pmbus_read_word_data(client, page, phase, reg);
>  		if (ret < 0)
>  			return ret;
> -		ret = data->total_curr_resolution ? ret * 2 : ret;
> +		ret = data->total_curr_resolution ? ret  : DIV_ROUND_CLOSEST(ret, 2);
>  		break;
>  	case PMBUS_POUT_OP_WARN_LIMIT:
>  		ret = pmbus_read_word_data(client, page, phase, reg);
> @@ -223,7 +222,7 @@ static int mp2888_read_word_data(struct i2c_client *client, int page, int phase,
>  		 * set 1. Actual power is reported with 0.5W or 1W respectively resolution. Scaling
>  		 * is needed to match both.
>  		 */
> -		ret = data->total_curr_resolution ? ret * 4 : ret * 2;
> +		ret = data->total_curr_resolution ? ret * 2 : ret;
>  		break;
>  	/*
>  	 * The below registers are not implemented by device or implemented not according to the