Re: ASRock B650E Taichi support

[jurgenacc@tutanota.com]

My bad. I'm relatively new to Linux. This is the output of the "sensors" command:

amdgpu-pci-0300
Adapter: PCI adapter
vddgfx:      825.00 mV 
fan1:           0 RPM  (min =    0 RPM, max = 3300 RPM)
edge:         +34.0°C  (crit = +100.0°C, hyst = -273.1°C)
                       (emerg = +105.0°C)
junction:     +38.0°C  (crit = +110.0°C, hyst = -273.1°C)
                       (emerg = +115.0°C)
mem:          +38.0°C  (crit = +100.0°C, hyst = -273.1°C)
                       (emerg = +105.0°C)
PPT:          38.00 W  (cap = 303.00 W)

k10temp-pci-00c3
Adapter: PCI adapter
Tctl:         +44.6°C  
Tccd1:        +35.8°C  
Tccd2:        +40.9°C  

nvme-pci-4700
Adapter: PCI adapter
Composite:    +40.9°C  

amdgpu-pci-5000
Adapter: PCI adapter
vddgfx:        1.32 V  
vddnb:         1.15 V  
edge:         +42.0°C  
PPT:          46.25 W  

iwlwifi_1-virtual-0
Adapter: Virtual device
temp1:        +30.0°C  

nvme-pci-4f00
Adapter: PCI adapter
Composite:    +36.9°C  (low  = -273.1°C, high = +81.8°C)
                       (crit = +84.8°C)
Sensor 1:     +36.9°C  (low  = -273.1°C, high = +65261.8°C)
Sensor 2:     +42.9°C  (low  = -273.1°C, high = +65261.8°C)

These are the same as before, so no new sensors.

Thanks,
Jurgen.


May 19, 2023, 1:47 PM by linux@roeck-us.net:

> On Fri, May 19, 2023 at 03:59:34PM +0200, jurgenacc@tutanota.com wrote:
>
>> Hi,
>>
>> Loading the nct6683 did not give an error. However the sensors-detect gives the same output "Sorry, no sensors were detected."
>>
> ??? The sensors-detect command and kernel drivers have no relationship
> to each other.
>
> Question is if you see any sensors after loading the nct6683 driver.
>
> Guenter
>