From: Wei Liu <wei.liu@kernel.org>
To: Mukesh R <mrathor@linux.microsoft.com>
Cc: Magnus Kulke <magnuskulke@linux.microsoft.com>,
linux-hyperv@vger.kernel.org, Arnd Bergmann <arnd@arndb.de>,
Magnus Kulke <magnuskulke@microsoft.com>,
Wei Liu <wei.liu@kernel.org>, Paolo Bonzini <pbonzini@redhat.com>,
Dexuan Cui <decui@microsoft.com>, Long Li <longli@microsoft.com>,
linux-arch@vger.kernel.org, linux-kernel@vger.kernel.org,
"K. Y. Srinivasan" <kys@microsoft.com>,
Souradeep Chakrabarti <schakrabarti@microsoft.com>,
Haiyang Zhang <haiyangz@microsoft.com>,
Wei Liu <liuwe@microsoft.com>,
Anirudh Rayabharam <Anirudh.Rayabharam@microsoft.com>
Subject: Re: [PATCH v4] drivers/hv: remove deposited pages from direct map
Date: Fri, 30 Oct 2026 11:18:23 -0700 [thread overview]
Message-ID: <20261030181823.GA581409@liuwe-devbox-debian-v2.local> (raw)
In-Reply-To: <49a7b3b0-5314-c028-d0e6-a46e65ed880d@linux.microsoft.com>
On Wed, Oct 28, 2026 at 03:54:30PM -0700, Mukesh R wrote:
> On 9/30/26 05:10, Magnus Kulke wrote:
> > hv_call_deposit_pages() donates pages (deposit) to hypervisor for L2
> > guest on L1VH systems via HVCALL_DEPOSIT_MEMORY. The hypervisor takes
> > ownership of those pages and per contract revokes root partition
> > access to them, raising a #GP on access from the L1VH root partition.
> >
> > However, the pages remain mapped in the kernel direct map, so kernel
> > code may still access them even though the hypervisor has revoked
> > access.
> >
> > Helpers such as "load_unaligned_zeropad()" deliberately read past the
> > end of a buffer and across page boundaries. A read into an unmapped
> > page is tolerated and triggers a #PF, for which the kernel executes
> > a fixup in the exception table.
> >
> > If such a call steps into a page that has been deposited, the access
> > raises a #GP by the hypervisor from which the above handler cannot
> > recover and the kernel panics:
> >
> > Oops: general protection fault, maybe for address 0xff1100941a3dfffc
> > RIP: 0010:csum_partial+0xe5/0x110
> >
> > This condition will appear on L1VH system that have created L2
> > partitions (and hence deposited pages) and exercise networking code
> > paths such as csum_partial() can trigger this condition when a buffer
> > ends close to a page boundary (e.g fffc in the above example).
> >
> > The fix is to remove the deposited pages from the direct map before
> > they are passed to the hypervisor, and restore them when the hypervisor
> > returns them again.
> >
> > We want to avoid flushing the TLB in the loop, so we use the _noflush()
> > variant of set_direct_map_valid() when marking a deposited page invalid
> > and flush the affected page ranges in one go ourselves. In the opposite
> > direction this is not required:
> >
> > > If a paging-structure entry is modified to change the P flag from
> > > 0 to 1, no invalidation is necessary. This is because no TLB entry
> > > or paging-structure cache entry is created with information from a
> > > paging-structure entry in which the P flag is 0.
> >
> > (Intel SDM Vol. 3, 4.10.4.3)
> >
> > Signed-off-by: Magnus Kulke <magnuskulke@linux.microsoft.com>
> > ---
> > Changes since v3:
> > - Batch contiguous pages in the restore path
> > - Adjusted comment about failure modes
> >
> > Changes since v2:
> > - Checkpatch format fix
> >
> > Changes since RFC:
> > - Handle direct-map restoration failures without returning unmapped
> > pages to the allocator.
> > - Move freeing of withdrawn pages into the restoration helper.
> > ---
> > drivers/hv/hv_proc.c | 83 +++++++++++++++++++++++++++++++++-
> > drivers/hv/mshv_root_hv_call.c | 4 +-
> > include/asm-generic/mshyperv.h | 4 ++
> > 3 files changed, 87 insertions(+), 4 deletions(-)
> >
> > diff --git a/drivers/hv/hv_proc.c b/drivers/hv/hv_proc.c
> > index 57b2c64197cb..b056051a5ac5 100644
> > --- a/drivers/hv/hv_proc.c
> > +++ b/drivers/hv/hv_proc.c
> > @@ -7,7 +7,9 @@
> > #include <linux/cpuhotplug.h>
> > #include <linux/minmax.h>
> > #include <linux/export.h>
> > +#include <linux/set_memory.h>
> > #include <asm/mshyperv.h>
> > +#include <asm/tlbflush.h>
> > /*
> > * See struct hv_deposit_memory. The first u64 is partition ID, the rest
> > @@ -15,6 +17,35 @@
> > */
> > #define HV_DEPOSIT_MAX (HV_HYP_PAGE_SIZE / sizeof(u64) - 1)
> > +/*
> > + * Add or remove a set of physically contiguous page runs from the kernel
> > + * direct map. Once a page has been deposited the hypervisor owns it and
> > + * revokes root partition access to it.
> > + */
> > +static int hv_deposit_update_direct_map(struct page **pages, int *counts,
> > + int num_allocations, bool valid)
> > +{
> > + int i, err, ret = 0;
> > +
> > + for (i = 0; i < num_allocations; ++i) {
> > + err = set_direct_map_valid_noflush(pages[i], counts[i], valid);
> > + if (err && !ret)
> > + ret = err;
> > + }
>
> I realize I am late to the review, so if too late, please ignore.
> If the caller is going to not continue on error but will revert,
> what is the reason to keep going on error then?
>
> And this function should undo it itself if there is error instead
> of forcing the caller to do it imo. It could just undo the part which
> is done.
>
Magnus, while you work on rebasing the patch, perhaps you can also
address this.
Wei
prev parent reply other threads:[~2026-10-30 18:18 UTC|newest]
Thread overview: 10+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-09-30 12:10 [PATCH v4] drivers/hv: remove deposited pages from direct map Magnus Kulke
2026-09-30 12:21 ` sashiko-bot
2026-10-01 11:42 ` Anirudh Rayabharam
2026-10-21 7:30 ` Wei Liu
2026-10-28 18:28 ` Thorsten Leemhuis
2026-10-28 18:31 ` Wei Liu
2026-10-28 18:44 ` Thorsten Leemhuis
2026-10-29 5:41 ` Wei Liu
2026-10-28 22:54 ` Mukesh R
2026-10-30 18:18 ` Wei Liu [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261030181823.GA581409@liuwe-devbox-debian-v2.local \
--to=wei.liu@kernel.org \
--cc=Anirudh.Rayabharam@microsoft.com \
--cc=arnd@arndb.de \
--cc=decui@microsoft.com \
--cc=haiyangz@microsoft.com \
--cc=kys@microsoft.com \
--cc=linux-arch@vger.kernel.org \
--cc=linux-hyperv@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=liuwe@microsoft.com \
--cc=longli@microsoft.com \
--cc=magnuskulke@linux.microsoft.com \
--cc=magnuskulke@microsoft.com \
--cc=mrathor@linux.microsoft.com \
--cc=pbonzini@redhat.com \
--cc=schakrabarti@microsoft.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox