Re: [MeeGo-Dev][PATCH] Topcliff: Update PCH_I2C driver to 2.6.35

[Joe Perches <joe-6d6DIl74uiNBDgjK7y7TUQ@public.gmane.org>]

On Wed, 2010-09-01 at 11:26 +0900, Masayuki Ohtak wrote:
> I2C driver of Topcliff PCH
> +++ b/drivers/i2c/busses/i2c-pch.c
[]
> +static void pch_init(struct i2c_algo_pch_data *adap)
[]
> +	if (pch_i2c_speed == FAST_MODE_CLK) {
> +		reg_value |= FAST_MODE_EN;
> +		dev_dbg(adap->pch_adapter.dev.parent, "Fast mode enabled\n");
> +	}

Just a suggestion below, ignore it at your pleasure...

These dev_<level> calls might be easier to read if you had
some #defines like:

#define pch_dbg(adap, fmt, arg...)		\
	dev_dbg(adap->pch_adapter.dev.parent, fmt, ##arg)
#define pch_err(adap, fmt, arg...)		\
	dev_err(adap->pch_adapter.dev.parent, fmt, ##arg)
#define pch_info(adap, fmt, arg...)		\
	dev_info(adap->pch_adapter.dev.parent, fmt, ##arg)

then the last dev_dbg becomes:

		pch_dbg(adap, "Fast mode enabled\n");

Many modules use similar wrapper #defines.

> +	dev_dbg(adap->pch_adapter.dev.parent,
> +		"%s: I2CCTL=%x pch_i2cbc=%x pch_i2ctmr=%x Enable interrupts\n",
> +		__func__, ioread32(p + PCH_I2CCTL),
> +		pch_i2cbc, pch_i2ctmr);

	pch_dbg(adap, etc...)

etc.

cheers, Joe