From mboxrd@z Thu Jan 1 00:00:00 1970 From: Fabio Estevam Subject: [PATCH] i2c: Kconfig: Allow I2C_MXS to be selected by MX23 Date: Sat, 17 Nov 2012 17:48:54 -0200 Message-ID: <1353181734-13253-1-git-send-email-festevam@gmail.com> Return-path: Sender: linux-i2c-owner-u79uwXL29TY76Z2rM5mHXA@public.gmane.org To: w.sang-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org Cc: f.koliqi-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org, marex-ynQEQJNshbs@public.gmane.org, linux-i2c-u79uwXL29TY76Z2rM5mHXA@public.gmane.org, Fabio Estevam List-Id: linux-i2c@vger.kernel.org From: Fabio Estevam With the recent DMA support addition to the i2c-mxs driver, it is now possible to also run it on mx23, so update the Kconfig entry accordingly. Signed-off-by: Fabio Estevam --- drivers/i2c/busses/Kconfig | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/i2c/busses/Kconfig b/drivers/i2c/busses/Kconfig index e9df461..34f48f3 100644 --- a/drivers/i2c/busses/Kconfig +++ b/drivers/i2c/busses/Kconfig @@ -482,12 +482,12 @@ config I2C_MV64XXX will be called i2c-mv64xxx. config I2C_MXS - tristate "Freescale i.MX28 I2C interface" - depends on SOC_IMX28 + tristate "Freescale MXS I2C interface" + depends on ARCH_MXS select STMP_DEVICE help Say Y here if you want to use the I2C bus controller on - the Freescale i.MX28 processors. + the Freescale MXS processors. This driver can also be built as a module. If so, the module will be called i2c-mxs. -- 1.7.9.5