[PATCH 4/7] i2c-designware: use dynamic adapter numbering on Lynxpoint

[Mika Westerberg <mika.westerberg@linux.intel.com>]

It is not good idea to mix static and dynamic I2C adapter numbering. In
this particular case on Lynxpoint we had graphics I2C adapter which took
the first numbers preventing the designware I2C driver from using the
adapter numbers it preferred.

Fix this by switching to use dynamic adapter numbering on Intel Lynxpoint.

Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
---
 drivers/i2c/busses/i2c-designware-platdrv.c |    9 ---------
 1 file changed, 9 deletions(-)

diff --git a/drivers/i2c/busses/i2c-designware-platdrv.c b/drivers/i2c/busses/i2c-designware-platdrv.c
index c19c4ce..a22a852 100644
--- a/drivers/i2c/busses/i2c-designware-platdrv.c
+++ b/drivers/i2c/busses/i2c-designware-platdrv.c
@@ -56,20 +56,11 @@ static u32 i2c_dw_get_clk_rate_khz(struct dw_i2c_dev *dev)
 static int dw_i2c_acpi_configure(struct platform_device *pdev)
 {
 	struct dw_i2c_dev *dev = platform_get_drvdata(pdev);
-	struct acpi_device *adev;
-	int busno, ret;
 
 	if (!ACPI_HANDLE(&pdev->dev))
 		return -ENODEV;
 
-	ret = acpi_bus_get_device(ACPI_HANDLE(&pdev->dev), &adev);
-	if (ret)
-		return -ENODEV;
-
 	dev->adapter.nr = -1;
-	if (adev->pnp.unique_id && !kstrtoint(adev->pnp.unique_id, 0, &busno))
-		dev->adapter.nr = busno;
-
 	dev->tx_fifo_depth = 32;
 	dev->rx_fifo_depth = 32;
 	return 0;
-- 
1.7.10.4