From: Alain Volmat <alain.volmat@st.com>
To: <wsa@kernel.org>, <pierre-yves.mordret@st.com>
Cc: <alexandre.torgue@st.com>, <linux-i2c@vger.kernel.org>,
<linux-stm32@st-md-mailman.stormreply.com>,
<linux-arm-kernel@lists.infradead.org>,
<linux-kernel@vger.kernel.org>, <fabrice.gasnier@st.com>,
<alain.volmat@st.com>
Subject: [PATCH] i2c: stm32f7: add SMBus-Alert support
Date: Mon, 3 Aug 2020 07:26:56 +0200 [thread overview]
Message-ID: <1596432416-24636-1-git-send-email-alain.volmat@st.com> (raw)
Add support for the SMBus-Alert protocol.
Signed-off-by: Alain Volmat <alain.volmat@st.com>
---
This patch has to be integrated on top of the patch
'i2c: stm32f7: Add SMBus Host-Notify protocol support' since SMBus Alert is
enabled by the DT binding 'smbus' introduced in that patch.
drivers/i2c/busses/i2c-stm32f7.c | 71 ++++++++++++++++++++++++++++++++++++++++
1 file changed, 71 insertions(+)
diff --git a/drivers/i2c/busses/i2c-stm32f7.c b/drivers/i2c/busses/i2c-stm32f7.c
index 223c238c3c09..fe7641da54ef 100644
--- a/drivers/i2c/busses/i2c-stm32f7.c
+++ b/drivers/i2c/busses/i2c-stm32f7.c
@@ -51,6 +51,7 @@
/* STM32F7 I2C control 1 */
#define STM32F7_I2C_CR1_PECEN BIT(23)
+#define STM32F7_I2C_CR1_ALERTEN BIT(22)
#define STM32F7_I2C_CR1_SMBHEN BIT(20)
#define STM32F7_I2C_CR1_WUPEN BIT(18)
#define STM32F7_I2C_CR1_SBC BIT(16)
@@ -123,6 +124,7 @@
(((n) & STM32F7_I2C_ISR_ADDCODE_MASK) >> 17)
#define STM32F7_I2C_ISR_DIR BIT(16)
#define STM32F7_I2C_ISR_BUSY BIT(15)
+#define STM32F7_I2C_ISR_ALERT BIT(13)
#define STM32F7_I2C_ISR_PECERR BIT(11)
#define STM32F7_I2C_ISR_ARLO BIT(9)
#define STM32F7_I2C_ISR_BERR BIT(8)
@@ -136,6 +138,7 @@
#define STM32F7_I2C_ISR_TXE BIT(0)
/* STM32F7 I2C Interrupt Clear */
+#define STM32F7_I2C_ICR_ALERTCF BIT(13)
#define STM32F7_I2C_ICR_PECCF BIT(11)
#define STM32F7_I2C_ICR_ARLOCF BIT(9)
#define STM32F7_I2C_ICR_BERRCF BIT(8)
@@ -277,6 +280,17 @@ struct stm32f7_i2c_msg {
};
/**
+ * struct stm32f7_i2c_alert - SMBus alert specific data
+ * @setup: platform data for the smbus_alert i2c client
+ * @ara: I2C slave device used to respond to the SMBus Alert with Alert
+ * Response Address
+ */
+struct stm32f7_i2c_alert {
+ struct i2c_smbus_alert_setup setup;
+ struct i2c_client *ara;
+};
+
+/**
* struct stm32f7_i2c_dev - private data of the controller
* @adap: I2C adapter for this controller
* @dev: device for this controller
@@ -305,6 +319,7 @@ struct stm32f7_i2c_msg {
* @wakeup_src: boolean to know if the device is a wakeup source
* @smbus_mode: states that the controller is configured in SMBus mode
* @host_notify_client: SMBus host-notify client
+ * @alert: SMBus alert specific data
*/
struct stm32f7_i2c_dev {
struct i2c_adapter adap;
@@ -333,6 +348,7 @@ struct stm32f7_i2c_dev {
bool wakeup_src;
bool smbus_mode;
struct i2c_client *host_notify_client;
+ struct stm32f7_i2c_alert *alert;
};
/*
@@ -1601,6 +1617,13 @@ static irqreturn_t stm32f7_i2c_isr_error(int irq, void *data)
f7_msg->result = -EINVAL;
}
+ if (status & STM32F7_I2C_ISR_ALERT) {
+ dev_dbg(dev, "<%s>: SMBus alert received\n", __func__);
+ writel_relaxed(STM32F7_I2C_ICR_ALERTCF, base + STM32F7_I2C_ICR);
+ i2c_handle_smbus_alert(i2c_dev->alert->ara);
+ return IRQ_HANDLED;
+ }
+
if (!i2c_dev->slave_running) {
u32 mask;
/* Disable interrupts */
@@ -1967,6 +1990,42 @@ static void stm32f7_i2c_disable_smbus_host(struct stm32f7_i2c_dev *i2c_dev)
}
}
+static int stm32f7_i2c_enable_smbus_alert(struct stm32f7_i2c_dev *i2c_dev)
+{
+ struct stm32f7_i2c_alert *alert;
+ struct i2c_adapter *adap = &i2c_dev->adap;
+ struct device *dev = i2c_dev->dev;
+ void __iomem *base = i2c_dev->base;
+
+ alert = devm_kzalloc(dev, sizeof(*alert), GFP_KERNEL);
+ if (!alert)
+ return -ENOMEM;
+
+ alert->ara = i2c_new_smbus_alert_device(adap, &alert->setup);
+ if (IS_ERR(alert->ara))
+ return PTR_ERR(alert->ara);
+
+ i2c_dev->alert = alert;
+
+ /* Enable SMBus Alert */
+ stm32f7_i2c_set_bits(base + STM32F7_I2C_CR1, STM32F7_I2C_CR1_ALERTEN);
+
+ return 0;
+}
+
+static void stm32f7_i2c_disable_smbus_alert(struct stm32f7_i2c_dev *i2c_dev)
+{
+ struct stm32f7_i2c_alert *alert = i2c_dev->alert;
+ void __iomem *base = i2c_dev->base;
+
+ if (alert) {
+ /* Disable SMBus Alert */
+ stm32f7_i2c_clr_bits(base + STM32F7_I2C_CR1,
+ STM32F7_I2C_CR1_ALERTEN);
+ i2c_unregister_device(alert->ara);
+ }
+}
+
static u32 stm32f7_i2c_func(struct i2c_adapter *adap)
{
struct stm32f7_i2c_dev *i2c_dev = i2c_get_adapdata(adap);
@@ -2161,6 +2220,14 @@ static int stm32f7_i2c_probe(struct platform_device *pdev)
ret);
goto i2c_adapter_remove;
}
+
+ ret = stm32f7_i2c_enable_smbus_alert(i2c_dev);
+ if (ret) {
+ dev_err(i2c_dev->dev,
+ "failed to enable SMBus alert protocol (%d)\n",
+ ret);
+ goto i2c_disable_smbus_host;
+ }
}
dev_info(i2c_dev->dev, "STM32F7 I2C-%d bus adapter\n", adap->nr);
@@ -2170,6 +2237,9 @@ static int stm32f7_i2c_probe(struct platform_device *pdev)
return 0;
+i2c_disable_smbus_host:
+ stm32f7_i2c_disable_smbus_host(i2c_dev);
+
i2c_adapter_remove:
i2c_del_adapter(adap);
@@ -2204,6 +2274,7 @@ static int stm32f7_i2c_remove(struct platform_device *pdev)
{
struct stm32f7_i2c_dev *i2c_dev = platform_get_drvdata(pdev);
+ stm32f7_i2c_disable_smbus_alert(i2c_dev);
stm32f7_i2c_disable_smbus_host(i2c_dev);
i2c_del_adapter(&i2c_dev->adap);
--
2.7.4
next reply other threads:[~2020-08-03 5:27 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-08-03 5:26 Alain Volmat [this message]
2020-09-09 9:22 ` [PATCH] i2c: stm32f7: add SMBus-Alert support Pierre Yves MORDRET
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1596432416-24636-1-git-send-email-alain.volmat@st.com \
--to=alain.volmat@st.com \
--cc=alexandre.torgue@st.com \
--cc=fabrice.gasnier@st.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-i2c@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-stm32@st-md-mailman.stormreply.com \
--cc=pierre-yves.mordret@st.com \
--cc=wsa@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).