From mboxrd@z Thu Jan 1 00:00:00 1970 From: David Brownell Subject: [patch 2.6.27-rc3] tps65010: vibrator hookup to gpiolib Date: Mon, 18 Aug 2008 00:24:32 -0700 Message-ID: <200808180024.32954.david-b@pacbell.net> Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Return-path: Content-Disposition: inline List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Sender: i2c-bounces-GZX6beZjE8VD60Wz+7aTrA@public.gmane.org Errors-To: i2c-bounces-GZX6beZjE8VD60Wz+7aTrA@public.gmane.org To: i2c-GZX6beZjE8VD60Wz+7aTrA@public.gmane.org Cc: Marek Vasut , Russell King List-Id: linux-i2c@vger.kernel.org From: Marek Vasut All the tps6501{0,1,2,3,4} chips have a signal for hooking up with a vibrator (for non-auditory cell phone "ring") ... expose that as one more (output-only) GPIO. [ dbrownell-Rn4VEauK+AKRv+LV9MX5uipxlwaOVQ5f@public.gmane.org: comments; list tps65014 too ] Signed-off-by: David Brownell --- drivers/i2c/chips/tps65010.c | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-) --- a/drivers/i2c/chips/tps65010.c 2008-07-25 12:28:08.000000000 -0700 +++ b/drivers/i2c/chips/tps65010.c 2008-08-18 00:22:48.000000000 -0700 @@ -456,14 +456,17 @@ static irqreturn_t tps65010_irq(int irq, /* offsets 0..3 == GPIO1..GPIO4 * offsets 4..5 == LED1/nPG, LED2 (we set one of the non-BLINK modes) + * offset 6 == vibrator motor driver */ static void tps65010_gpio_set(struct gpio_chip *chip, unsigned offset, int value) { if (offset < 4) tps65010_set_gpio_out_value(offset + 1, value); - else + else if (offset < 6) tps65010_set_led(offset - 3, value ? ON : OFF); + else + tps65010_set_vib(value); } static int @@ -477,8 +480,10 @@ tps65010_output(struct gpio_chip *chip, if (!(tps->outmask & (1 << offset))) return -EINVAL; tps65010_set_gpio_out_value(offset + 1, value); - } else + } else if (offset < 6) tps65010_set_led(offset - 3, value ? ON : OFF); + else + tps65010_set_vib(value); return 0; } @@ -646,7 +651,7 @@ static int tps65010_probe(struct i2c_cli tps->chip.get = tps65010_gpio_get; tps->chip.base = board->base; - tps->chip.ngpio = 6; + tps->chip.ngpio = 7; tps->chip.can_sleep = 1; status = gpiochip_add(&tps->chip); @@ -675,6 +680,7 @@ static const struct i2c_device_id tps650 { "tps65011", TPS65011 }, { "tps65012", TPS65012 }, { "tps65013", TPS65013 }, + { "tps65014", TPS65011 }, /* tps65011 charging at 6.5V max */ { } }; MODULE_DEVICE_TABLE(i2c, tps65010_id); _______________________________________________ i2c mailing list i2c-GZX6beZjE8VD60Wz+7aTrA@public.gmane.org http://lists.lm-sensors.org/mailman/listinfo/i2c