[PATCH 35/47] i2c: remove bfin-twi driver

Arnd Bergmann
2018-03-14T15:35:48Z

The blackfin architecture is getting removed, so the
twi driver can also be removed.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>
---
drivers/i2c/busses/Kconfig | 18 -
drivers/i2c/busses/Makefile | 1 -
drivers/i2c/busses/i2c-bfin-twi.c | 737 --------------------------------------
3 files changed, 756 deletions(-)
delete mode 100644 drivers/i2c/busses/i2c-bfin-twi.c

diff --git a/drivers/i2c/busses/Kconfig b/drivers/i2c/busses/Kconfig
index 68ceac7617ff..4c0895165727 100644
--- a/drivers/i2c/busses/Kconfig
+++ b/drivers/i2c/busses/Kconfig
@@ -445,24 +445,6 @@ config I2C_BRCMSTB

If you do not need I2C interface, say N.

-config I2C_BLACKFIN_TWI
- tristate "Blackfin TWI I2C support"
- depends on BLACKFIN
- depends on !BF561 && !BF531 && !BF532 && !BF533
- help
- This is the I2C bus driver for Blackfin on-chip TWI interface.
-
- This driver can also be built as a module. If so, the module
- will be called i2c-bfin-twi.
-
-config I2C_BLACKFIN_TWI_CLK_KHZ
- int "Blackfin TWI I2C clock (kHz)"
- depends on I2C_BLACKFIN_TWI
- range 21 400
- default 50
- help
- The unit of the TWI clock is kHz.
-
config I2C_CADENCE
tristate "Cadence I2C Controller"
depends on ARCH_ZYNQ || ARM64 || XTENSA
diff --git a/drivers/i2c/busses/Makefile b/drivers/i2c/busses/Makefile
index 2ce8576540a2..9e475a54e36e 100644
--- a/drivers/i2c/busses/Makefile
+++ b/drivers/i2c/busses/Makefile
@@ -38,7 +38,6 @@ obj-$(CONFIG_I2C_AU1550) += i2c-au1550.o
obj-$(CONFIG_I2C_AXXIA) += i2c-axxia.o
obj-$(CONFIG_I2C_BCM2835) += i2c-bcm2835.o
obj-$(CONFIG_I2C_BCM_IPROC) += i2c-bcm-iproc.o
-obj-$(CONFIG_I2C_BLACKFIN_TWI) += i2c-bfin-twi.o
obj-$(CONFIG_I2C_CADENCE) += i2c-cadence.o
obj-$(CONFIG_I2C_CBUS_GPIO) += i2c-cbus-gpio.o
obj-$(CONFIG_I2C_CPM) += i2c-cpm.o
diff --git a/drivers/i2c/busses/i2c-bfin-twi.c b/drivers/i2c/busses/i2c-bfin-twi.c
deleted file mode 100644
index ff3343186a82..000000000000
--
2.9.0