[PATCH v3 1/3] i2c: imx: Fix race condition in dma read

[Esben Haabendal <esben.haabendal@gmail.com>]

From: Esben Haabendal <eha@deif.com>

This fixes a race condition, where the DMAEN bit ends up being set after
I2C slave has transmitted a byte following the dummy read.  When that
happens, an interrupt is generated instead, and no DMA request is generated
to kickstart the DMA read, and a timeout happens after DMA_TIMEOUT (1 sec).

Fixed by setting the DMAEN bit before the dummy read.

Signed-off-by: Esben Haabendal <eha@deif.com>
---
 drivers/i2c/busses/i2c-imx.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/i2c/busses/i2c-imx.c b/drivers/i2c/busses/i2c-imx.c
index 498c5e891649..f7bd6c21da27 100644
--- a/drivers/i2c/busses/i2c-imx.c
+++ b/drivers/i2c/busses/i2c-imx.c
@@ -668,9 +668,6 @@ static int i2c_imx_dma_read(struct imx_i2c_struct *i2c_imx,
 	struct imx_i2c_dma *dma = i2c_imx->dma;
 	struct device *dev = &i2c_imx->adapter.dev;
 
-	temp = imx_i2c_read_reg(i2c_imx, IMX_I2C_I2CR);
-	temp |= I2CR_DMAEN;
-	imx_i2c_write_reg(temp, i2c_imx, IMX_I2C_I2CR);
 
 	dma->chan_using = dma->chan_rx;
 	dma->dma_transfer_dir = DMA_DEV_TO_MEM;
@@ -809,6 +806,8 @@ static int i2c_imx_read(struct imx_i2c_struct *i2c_imx, struct i2c_msg *msgs, bo
 	 */
 	if ((msgs->len - 1) || block_data)
 		temp &= ~I2CR_TXAK;
+	if (i2c_imx->dma && msgs->len >= DMA_THRESHOLD && !block_data)
+		temp |= I2CR_DMAEN;
 	imx_i2c_write_reg(temp, i2c_imx, IMX_I2C_I2CR);
 	imx_i2c_read_reg(i2c_imx, IMX_I2C_I2DR); /* dummy read */
 
-- 
2.18.0