Re: [PATCH v3 0/6] i2c: designware: Generic polling mode code

'Andy Shevchenko'
2024-02-23T15:20:07Z

On Fri, Feb 23, 2024 at 05:09:37PM +0200, Jarkko Nikula wrote:
> On 2/18/24 11:19, Jiawen Wu wrote:
> > On Tue, Feb 13, 2024 8:49 PM, Jarkko Nikula wrote:
> > > Hi Jiawen, Sanket and Basavaraj
> > >
> > > I hope you could give a quick test to this patchset to see it won't cause
> > > regression on your HW. This is mostly the same than the first version what
> > > Jiawen tested earlier but in this 3rd version I decided to drop semphore
> > > touching code patches from v2 due they being out of scope and fix a few
> > > things noted by Andy.
> > >
> > > Changes are in the patch 3/6 with two minor fixes to comments while moving
> > > them and the patch 6/6 where i2c_dw_wait_transfer() is slightly modified
> > > by Andy's suggestion plus I decided to remove one comment which became
> > > unclear after this patch.
> >
> > Hi Jarkko,
> >
> > I've been testing the v3 patch series on Wangxun 10Gb NIC, it works well, too.
> > Thanks!
> >
> > Tested-by: Jiawen Wu <jiawenwu@trustnetic.com>
> >
> Andy: Was this set ok in your point of view now?

Yes, I hoped that Andi applies it earlier last week or so.

--
With Best Regards,
Andy Shevchenko