[PATCH 06/10] i2c: stm32: Replace dev_err() with dev_err_probe() in probe function

[Enrico Zanda <e.zanda1@gmail.com>]

This simplifies the code while improving log.

Signed-off-by: Enrico Zanda <e.zanda1@gmail.com>
---
 drivers/i2c/busses/i2c-stm32.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/i2c/busses/i2c-stm32.c b/drivers/i2c/busses/i2c-stm32.c
index 157c64e27d0b..3ca84fef230c 100644
--- a/drivers/i2c/busses/i2c-stm32.c
+++ b/drivers/i2c/busses/i2c-stm32.c
@@ -39,7 +39,7 @@ struct stm32_i2c_dma *stm32_i2c_dma_request(struct device *dev,
 	dma_sconfig.direction = DMA_MEM_TO_DEV;
 	ret = dmaengine_slave_config(dma->chan_tx, &dma_sconfig);
 	if (ret < 0) {
-		dev_err(dev, "can't configure tx channel\n");
+		dev_err_probe(dev, ret, "can't configure tx channel\n");
 		goto fail_tx;
 	}
 
@@ -61,7 +61,7 @@ struct stm32_i2c_dma *stm32_i2c_dma_request(struct device *dev,
 	dma_sconfig.direction = DMA_DEV_TO_MEM;
 	ret = dmaengine_slave_config(dma->chan_rx, &dma_sconfig);
 	if (ret < 0) {
-		dev_err(dev, "can't configure rx channel\n");
+		dev_err_probe(dev, ret, "can't configure rx channel\n");
 		goto fail_rx;
 	}
 
-- 
2.43.0