Re: [PATCH 6/7] i2c/pxa2xx: reset the chip if the bus is not free

[Igor Grinberg <grinberg-UTxiZqZC01RS1MOuV/RT9w@public.gmane.org>]

 On 11/25/10 14:24, Sebastian Andrzej Siewior wrote:
> Igor Grinberg wrote:
>>  Hi,
> Hi,
>
>>>> Even you reset I2C controller, it shouldn't help you since bus isn't
>>>> free. I thinkt that you should reset I2C bus before you reseting I2C
>>>> controller.
>
> According to the register, IBB (bus busy) is cleared at this point. The
> only remaining flag is UB (unit busy) and RW mode.
>
>>> Excuse me that my previous comments are for PXA master mode.
> I am in master mode.
>
>>> I think that you're focused on pxa working on slave mode. But if pxa
>>> is working in master mode, it seems that we needn't reset I2C
>>> controller since it doesn't help.
>>
>> As for PXA3xx, the Developer Manual states:
>> "Software must ensure that the TWSI unit is not busy (ISR[UB] = 0)
>> before it asserts a reset. Software must also ensure that the TWSI bus is idle (ISR[IBB] = 0)
>> when the unit is enabled after reset."
>
> My manual says more or less the same thing. It says "unit not busy" but
> quotes the IBB bit in braces. It is probably a typo.
> The register say: ISR=00000005, ICR=000017e0, IBMR=01
> So according to this I am not allowed to reset the I2C unit while it is
> busy.
>
> I tracked it down to the following: i2cdetect tries to read a byte from
> address 47. This fails because there is no device. Then it goes for 48
> which returns 0 (there is a device). The following read always fails. So I
> guess the device at 48 is still sending data. What is general rule of
> thumb in such a case?

I don't think there is such a rule for this case, as if we "believe" the
Developer Manual, but do the opposite - we can get into trouble...
IMHO, at least we need to report a problem.

Or may be in some way reset the slave device,
if there is such an option available outside the i2c scope...
(Yeah, I know this is a crazy idea...)

>
>>> From my experience, in master mode resetting the controller
>> does not help and if the bus is busy for too much time,
>> there always was a h/w problem involved.
>
> Looks like it.

1) Well, you should check if you have a pull-up resistors on that bus.
2) Or if the slave device chip is broken, then it should be replaced.

>
> Sebastian
>

-- 
Regards,
Igor.