Re: [PATCH] omap-i2c: fix incorrect log message when using a device tree

[Shubhrajyoti <shubhrajyoti@ti.com>]

On Friday 31 August 2012 04:32 PM, Florian Vaussard wrote:
> When booting using a device tree, the adapter number is dynamically
> assigned after the log message is sent.
> This patch modifies the log message to get a correct adapter id.
>
> Applies on 3.6-rc3. Tested on OMAP3 (Gumstix Overo).
>
> Signed-off-by: Florian Vaussard <florian.vaussard@epfl.ch>
Looks good to me.

Acked-by: Shubhrajyoti D <shubhrajyoti@ti.com>
> ---
>  drivers/i2c/busses/i2c-omap.c |    6 +++---
>  1 files changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
> index 5d19a49..136b4fe 100644
> --- a/drivers/i2c/busses/i2c-omap.c
> +++ b/drivers/i2c/busses/i2c-omap.c
> @@ -1064,9 +1064,6 @@ omap_i2c_probe(struct platform_device *pdev)
>  		goto err_unuse_clocks;
>  	}
>  
> -	dev_info(dev->dev, "bus %d rev%d.%d.%d at %d kHz\n", pdev->id,
> -		 dev->dtrev, dev->rev >> 4, dev->rev & 0xf, dev->speed);
> -
>  	adap = &dev->adapter;
>  	i2c_set_adapdata(adap, dev);
>  	adap->owner = THIS_MODULE;
> @@ -1084,6 +1081,9 @@ omap_i2c_probe(struct platform_device *pdev)
>  		goto err_free_irq;
>  	}
>  
> +	dev_info(dev->dev, "bus %d rev%d.%d.%d at %d kHz\n", adap->nr,
> +		 dev->dtrev, dev->rev >> 4, dev->rev & 0xf, dev->speed);
> +
>  	of_i2c_register_devices(adap);
>  
>  	pm_runtime_put(dev->dev);