From mboxrd@z Thu Jan 1 00:00:00 1970 From: Oliver Hartkopp Subject: Re: randconfig build error with next-20141001, in drivers/i2c/algos/i2c-algo-bit.c Date: Tue, 07 Oct 2014 10:58:25 +0200 Message-ID: <5433AB31.9090603@hartkopp.net> References: <542C8D93.8090008@infradead.org> <54324D68.6070309@hartkopp.net> <5432C8C6.7060506@infradead.org> <5432D3E6.9020805@hartkopp.net> <5432DAE8.5030509@infradead.org> Mime-Version: 1.0 Content-Type: text/plain; charset=utf-8 Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <5432DAE8.5030509@infradead.org> Sender: linux-can-owner@vger.kernel.org To: Randy Dunlap , Stephane Grosjean Cc: Jim Davis , Stephen Rothwell , linux-next , linux-i2c@vger.kernel.org, "netdev@vger.kernel.org" , linux-can@vger.kernel.org List-Id: linux-i2c@vger.kernel.org On 10/06/2014 08:09 PM, Randy Dunlap wrote: > On 10/06/14 10:39, Oliver Hartkopp wrote: >> AFAICS there is 'just' a style problem as 'configs should not enable entire >> subsystems'. But it finally is a correct and valid Kconfig, right? > > Yes, right. (..) > In the unlikely case that I2C is not enabled, the user should have to enable > it instead of a solitary driver enabling it. IOW, if a subsystem is disabled, > the user probably wanted it that way and a single driver should not override > that setting. Due to the fact that a change to 'depends on I2C' would make the config option invisible (and therefore not selectable) in the case I2C was (unlikely) disabled I would finally vote to leave it as-is. The current Kconfig entry already contains a description that points to the requirement to have I2C and I2C_ALGOBIT to be enabled to compile this driver: config CAN_PEAK_PCIEC bool "PEAK PCAN-ExpressCard Cards" depends on CAN_PEAK_PCI select I2C select I2C_ALGOBIT default y ---help--- Say Y here if you want to use a PCAN-ExpressCard from PEAK-System Technik. This will also automatically select I2C and I2C_ALGO configuration options. AFAIK the PEAK PCAN-ExpressCard is usually used in x86 architecture Laptops, so it's near to an academic discussion as x86 usually selects I2C ;-) @Stephane: When updating the help text to introduce the PCAN-ExpressCard 34 support anyway you might probably add some more information *why* the I2C support is needed (for CAN transceiver settings and status LED). And /s/I2C_ALGO/I2C_ALGOBIT/ :-) Tnx & best regards, Oliver