messages from 2014-11-26 19:26:10 to 2014-12-10 02:18:10 UTC [more...]
[PATCH 0/4] Add I2C support to Broadcom iProc
2014-12-10 2:18 UTC (11+ messages)
` [PATCH 1/4] i2c: iProc: define Broadcom iProc I2C binding
` [PATCH 2/4] i2c: iproc: Add Broadcom iProc I2C Driver
` [PATCH 3/4] ARM: mach-bcm: Enable I2C support for iProc
` [PATCH 4/4] ARM: dts: add I2C device nodes for Broadcom Cygnus
` [PATCH v2 0/4] Add I2C support to Broadcom iProc
` [PATCH v2 1/4] i2c: iProc: define Broadcom iProc I2C binding
[PATCH 0/4] ARM: shmobile: koelsch: Add DA9063 watchdog restart support
2014-12-10 0:33 UTC (9+ messages)
` [PATCH 1/4] watchdog: da9063: Add restart handler support
` [PATCH 2/4] DT: i2c: Add devices handled by the da9063 MFD driver
` [PATCH 3/4] ARM: shmobile: koelsch: Add DA9063 PMIC device node for system restart
` [PATCH 4/4] ARM: shmobile: Enable DA9063 watchdog in multiplatform defconfig
[RFC] Documentation: i2c: add fault code for not supporting 10 bit addresses
2014-12-09 17:48 UTC
[PATCH 0/5] i2c: sh_mobile: add DMA support
2014-12-09 14:09 UTC (4+ messages)
` [PATCH 2/5] "
[PATCH v3] i2c: Driver to expose PowerNV platform i2c busses
2014-12-09 13:18 UTC (9+ messages)
` [v3] "
[PATCH] i2c: rk3x: fix bug that cause measured high_ns doesn't meet I2C spec
2014-12-08 20:04 UTC (17+ messages)
` [PATCH v2] "
` [PATCH v3] "
[PATCH v4 1/3] mfd: add support for Cypress CYUSBS234 USB Serial Bridge controller
2014-12-08 16:16 UTC (6+ messages)
[PATCH] MAINTAINERS: add I2C dt bindings also to I2C realm
2014-12-08 9:56 UTC
[PATCH v3] iio: imu: inv_mpu6050: Add i2c mux for by pass
2014-12-06 11:01 UTC (3+ messages)
[PULL REQUEST] i2c for 3.18
2014-12-06 8:26 UTC
[PATCH V2] i2c-designware: Add Intel Baytrail PMIC I2C bus support
2014-12-06 3:51 UTC (11+ messages)
` [PATCH V3 0/2] i2c-designware: Baytrail bus locking driver
` [PATCH V3 1/2] i2c-designware: Add i2c bus locking support
` [PATCH V3 2/2] i2c-designware: Add Intel Baytrail PMIC I2C bus support
[PATCH v2] iio: imu: inv_mpu6050: Add i2c mux for by pass
2014-12-05 17:49 UTC (5+ messages)
[RFC 0/2] i2c: omap: new fixes for driver
2014-12-05 17:18 UTC (9+ messages)
` [RFC 1/2] i2c: omap: fix buffer overruns during RX/TX data processing
` [RFC 2/2] i2c: omap: show that the reason of system lockup is an unhandled ISR event
[PATCH v3 0/2] Cadence I2C driver fixes
2014-12-05 17:11 UTC (5+ messages)
` [PATCH v3 1/2] i2c: cadence: Handle > 252 byte transfers
` [PATCH v3 2/2] i2c: cadence: Check for errata condition involving master receive
[PATCH v2 0/3] Cadence I2C driver fixes
2014-12-05 8:15 UTC (12+ messages)
` [PATCH v2 1/3] i2c: cadence: Handle > 252 byte transfers
` [PATCH v2 2/3] i2c: cadence: Set the hardware time-out register to maximum value
` [PATCH v2 3/3] i2c: cadence: Check for errata condition involving master receive
[PATCH v3 0/5] i2c: davinci improvements and fixes
2014-12-04 18:29 UTC (9+ messages)
` [PATCH v3 1/5] i2c: i2c-davinci: switch to use platform_get_irq
` [PATCH v3 2/5] i2c: davinci: generate STP always when NACK is received
` [PATCH v3 3/5] i2c: recovery: change input parameter to i2c_adapter for prepare/unprepare_recovery
` [PATCH v3 4/5] i2c: davinci: use bus recovery infrastructure
` [PATCH 5/5] i2c: davinci: use ICPFUNC to toggle I2C as gpio for bus recovery
[PATCH 1/2] Documentation: i2c: Use PM ops instead of legacy suspend/resume
2014-12-04 18:23 UTC (8+ messages)
` [PATCH 2/2] i2c: Remove support for legacy PM
[RFC 0/5] i2c: omap: new fixes 2
2014-12-04 18:23 UTC (10+ messages)
` [RFC 1/5] i2c: omap: ack only reported events
` [RFC 2/5] i2c: omap: simplify i462 errata handling for NACK and AL cases
` [RFC 3/5] i2c: omap: move STP generation logic into ISR thread
` [RFC 4/5] i2c: omap: reimpelement STP hack via 2-phases transfer
` [RFC 5/5] i2c: omap: add trace
[PATCH] i2c: sh_mobile: optimize irq entry
2014-12-04 17:50 UTC (3+ messages)
[PULL REQUEST] i2c for 3.18
2014-12-03 20:22 UTC
Question about patch "i2c: omap: resize fifos before each message"
2014-12-03 20:04 UTC (7+ messages)
[PATCH 0/4] Cadence I2C driver fixes
2014-12-03 11:28 UTC (15+ messages)
` [PATCH 1/4] i2c: cadence: Handle > 252 byte transfers
` [PATCH 2/4] i2c: cadence: Set the hardware time-out register to maximum value
` [PATCH 3/4] devicetree: bindings: Add defeature-repeated-start property for Cadence I2C
` [PATCH 4/4] i2c: cadence: Defeature repeated start based on devicetree property
[PATCH] i2c-omap / PM: Drop CONFIG_PM_RUNTIME from i2c-omap.c
2014-12-03 11:17 UTC (2+ messages)
[PATCH v4 2/3] i2c: add support for Cypress CYUSBS234 USB-I2C adapter
2014-12-03 11:07 UTC (2+ messages)
[PATCH 1/3] staging: imx-drm: document internal HDMI I2C master controller DT binding
2014-12-02 13:21 UTC (8+ messages)
[PATCH] i2c: Add parameters to sysfs-added i2c devices
2014-12-02 13:06 UTC (4+ messages)
[PATCH v4 3/3] gpio: add support for Cypress CYUSBS234 USB-GPIO adapter
2014-12-02 9:28 UTC (3+ messages)
[PATCH] i2c: mux: pca9541: add return value check on register writes
2014-12-01 17:33 UTC (2+ messages)
[PATCH v3 1/2] i2c: mux: create symlink to actual mux device
2014-12-01 17:26 UTC (5+ messages)
` [PATCH v3 2/2] i2c: mux: create "channel-n" symlinks for child segments in the "
[PATCH] i2c-qoriq: modified compatibility for correct prescaler
2014-12-01 17:23 UTC (11+ messages)
[PATCH] i2c: mpc: add register documentation to Freescale I2C driver
2014-12-01 17:21 UTC (2+ messages)
[PATCH v2] i2c: Driver to expose PowerNV platform i2c busses
2014-12-01 16:56 UTC (4+ messages)
[RFC 0/4] i2c: omap: patch series related to multimaster mode
2014-11-29 22:06 UTC (13+ messages)
` [PATCH v3 "
` [PATCH v3 2/4] i2c: omap: implement workaround for handling invalid BB-bit values
` [RFC] i2c: omap: TEST: do IP reset during probe
[PATCH v4 3/3] gpio: add support for Cypress CYUSBS234 USB-GPIO adapter
2014-11-29 6:21 UTC
[PATCH v4 2/3] i2c: add support for Cypress CYUSBS234 USB-I2C adapter
2014-11-28 16:41 UTC
[PATCH v4 1/3] mfd: add support for Cypress CYUSBS234 USB Serial Bridge controller
2014-11-28 16:41 UTC
linux-3.7.[1,4]: kmemleak in i801_probe
2014-11-28 14:04 UTC (8+ messages)
` How should dev_[gs]et_drvdata be used? (was: Re: [PATCH] i2c: i801: fix memleak on probe error)
` How should dev_[gs]et_drvdata be used?
Fix Penguin Penalty 17th October2014 ( mail-archive.com )
2014-11-28 11:54 UTC
[PATCH v3 0/2] ARM: mediatek: Add driver for Mediatek I2C controller
2014-11-27 16:45 UTC (4+ messages)
Freeze of mouse and keyboard after suspend due to i2c-designware
2014-11-27 16:40 UTC (6+ messages)
[PATCH] omap: i2c: don't check bus state IP rev3.3 and earlier
2014-11-26 21:33 UTC (7+ messages)
` [PATCH v2] "
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox