linux-i2c.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
 messages from 2014-11-29 21:00:03 to 2014-12-10 14:19:12 UTC [more...]

[RFC 0/2] i2c: sh_mobile: don't regress on deferred probing
 2014-12-10 14:19 UTC  (6+ messages)
  ` [RFC 1/2] i2c: sh_mobile: refactor DMA setup
` [RFC 2/2] i2c: sh_mobile: rework deferred probing

[PATCH] i2c: sh_mobile: remove unneeded DMA mask
 2014-12-10 13:13 UTC 

[PATCH v4 0/2] Cadence I2C driver fixes
 2014-12-10 11:44 UTC  (3+ messages)
` [PATCH v4 1/2] i2c: cadence: Handle > 252 byte transfers
  ` [PATCH v4 2/2] i2c: cadence: Check for errata condition involving master receive

[PATCH 0/4] ARM: shmobile: koelsch: Add DA9063 watchdog restart support
 2014-12-10 10:06 UTC  (10+ messages)
` [PATCH 1/4] watchdog: da9063: Add restart handler support
` [PATCH 2/4] DT: i2c: Add devices handled by the da9063 MFD driver
` [PATCH 3/4] ARM: shmobile: koelsch: Add DA9063 PMIC device node for system restart
  ` [PATCH 4/4] ARM: shmobile: Enable DA9063 watchdog in multiplatform defconfig

[PATCH 0/5] i2c: sh_mobile: add DMA support
 2014-12-10  8:01 UTC  (6+ messages)
` [PATCH 2/5] "

[PATCH 0/4] Add I2C support to Broadcom iProc
 2014-12-10  3:58 UTC  (24+ messages)
    ` [PATCH 1/4] i2c: iProc: define Broadcom iProc I2C binding
    ` [PATCH 2/4] i2c: iproc: Add Broadcom iProc I2C Driver
    ` [PATCH 3/4] ARM: mach-bcm: Enable I2C support for iProc
    ` [PATCH 4/4] ARM: dts: add I2C device nodes for Broadcom Cygnus
  ` [PATCH v2 0/4] Add I2C support to Broadcom iProc
    ` [PATCH v2 1/4] i2c: iProc: define Broadcom iProc I2C binding
    ` [PATCH v2 2/4] i2c: iproc: Add Broadcom iProc I2C Driver
      ` [PATCH v2 3/4] ARM: mach-bcm: Enable I2C support for iProc
    ` [PATCH v2 4/4] ARM: dts: add I2C device nodes for Broadcom Cygnus
  ` [PATCH v3 0/3] Add I2C support to Broadcom iProc
    ` [PATCH v3 1/3] i2c: iProc: define Broadcom iProc I2C binding
    ` [PATCH v3 2/3] i2c: iproc: Add Broadcom iProc I2C Driver
    ` [PATCH v3 3/3] ARM: dts: add I2C device nodes for Broadcom Cygnus

[RFC] Documentation: i2c: add fault code for not supporting 10 bit addresses
 2014-12-09 17:48 UTC 

[PATCH v3] i2c: Driver to expose PowerNV platform i2c busses
 2014-12-09 13:18 UTC  (9+ messages)
  ` [v3] "

[PATCH] i2c: rk3x: fix bug that cause measured high_ns doesn't meet I2C spec
 2014-12-08 20:04 UTC  (17+ messages)
  ` [PATCH v2] "
  ` [PATCH v3] "

[PATCH v4 1/3] mfd: add support for Cypress CYUSBS234 USB Serial Bridge controller
 2014-12-08 16:16 UTC  (6+ messages)

[PATCH] MAINTAINERS: add I2C dt bindings also to I2C realm
 2014-12-08  9:56 UTC 

[PATCH v3] iio: imu: inv_mpu6050: Add i2c mux for by pass
 2014-12-06 11:01 UTC  (3+ messages)

[PULL REQUEST] i2c for 3.18
 2014-12-06  8:26 UTC 

[PATCH V2] i2c-designware: Add Intel Baytrail PMIC I2C bus support
 2014-12-06  3:51 UTC  (11+ messages)
  ` [PATCH V3 0/2] i2c-designware: Baytrail bus locking driver
    ` [PATCH V3 1/2] i2c-designware: Add i2c bus locking support
    ` [PATCH V3 2/2] i2c-designware: Add Intel Baytrail PMIC I2C bus support

[PATCH v2] iio: imu: inv_mpu6050: Add i2c mux for by pass
 2014-12-05 17:49 UTC  (5+ messages)

[RFC 0/2] i2c: omap: new fixes for driver
 2014-12-05 17:18 UTC  (9+ messages)
` [RFC 1/2] i2c: omap: fix buffer overruns during RX/TX data processing
` [RFC 2/2] i2c: omap: show that the reason of system lockup is an unhandled ISR event

[PATCH v3 0/2] Cadence I2C driver fixes
 2014-12-05 17:11 UTC  (5+ messages)
  ` [PATCH v3 1/2] i2c: cadence: Handle > 252 byte transfers
` [PATCH v3 2/2] i2c: cadence: Check for errata condition involving master receive

[PATCH v2 0/3] Cadence I2C driver fixes
 2014-12-05  8:15 UTC  (12+ messages)
  ` [PATCH v2 1/3] i2c: cadence: Handle > 252 byte transfers
` [PATCH v2 2/3] i2c: cadence: Set the hardware time-out register to maximum value
` [PATCH v2 3/3] i2c: cadence: Check for errata condition involving master receive

[PATCH v3 0/5] i2c: davinci improvements and fixes
 2014-12-04 18:29 UTC  (9+ messages)
  ` [PATCH v3 1/5] i2c: i2c-davinci: switch to use platform_get_irq
` [PATCH v3 2/5] i2c: davinci: generate STP always when NACK is received
` [PATCH v3 3/5] i2c: recovery: change input parameter to i2c_adapter for prepare/unprepare_recovery
` [PATCH v3 4/5] i2c: davinci: use bus recovery infrastructure
` [PATCH 5/5] i2c: davinci: use ICPFUNC to toggle I2C as gpio for bus recovery

[PATCH 1/2] Documentation: i2c: Use PM ops instead of legacy suspend/resume
 2014-12-04 18:23 UTC  (8+ messages)
  ` [PATCH 2/2] i2c: Remove support for legacy PM

[RFC 0/5] i2c: omap: new fixes 2
 2014-12-04 18:23 UTC  (10+ messages)
` [RFC 1/5] i2c: omap: ack only reported events
` [RFC 2/5] i2c: omap: simplify i462 errata handling for NACK and AL cases
` [RFC 3/5] i2c: omap: move STP generation logic into ISR thread
` [RFC 4/5] i2c: omap: reimpelement STP hack via 2-phases transfer
` [RFC 5/5] i2c: omap: add trace

[PATCH] i2c: sh_mobile: optimize irq entry
 2014-12-04 17:50 UTC  (3+ messages)

[PULL REQUEST] i2c for 3.18
 2014-12-03 20:22 UTC 

Question about patch "i2c: omap: resize fifos before each message"
 2014-12-03 20:04 UTC  (7+ messages)

[PATCH 0/4] Cadence I2C driver fixes
 2014-12-03 11:28 UTC  (15+ messages)
` [PATCH 1/4] i2c: cadence: Handle > 252 byte transfers
  ` [PATCH 2/4] i2c: cadence: Set the hardware time-out register to maximum value
  ` [PATCH 3/4] devicetree: bindings: Add defeature-repeated-start property for Cadence I2C
  ` [PATCH 4/4] i2c: cadence: Defeature repeated start based on devicetree property

[PATCH] i2c-omap / PM: Drop CONFIG_PM_RUNTIME from i2c-omap.c
 2014-12-03 11:17 UTC  (2+ messages)

[PATCH v4 2/3] i2c: add support for Cypress CYUSBS234 USB-I2C adapter
 2014-12-03 11:07 UTC  (2+ messages)

[PATCH 1/3] staging: imx-drm: document internal HDMI I2C master controller DT binding
 2014-12-02 13:21 UTC  (8+ messages)

[PATCH] i2c: Add parameters to sysfs-added i2c devices
 2014-12-02 13:06 UTC  (4+ messages)

[PATCH v4 3/3] gpio: add support for Cypress CYUSBS234 USB-GPIO adapter
 2014-12-02  9:28 UTC  (3+ messages)

[PATCH] i2c: mux: pca9541: add return value check on register writes
 2014-12-01 17:33 UTC  (2+ messages)

[PATCH v3 1/2] i2c: mux: create symlink to actual mux device
 2014-12-01 17:26 UTC  (5+ messages)
` [PATCH v3 2/2] i2c: mux: create "channel-n" symlinks for child segments in the "

[PATCH] i2c-qoriq: modified compatibility for correct prescaler
 2014-12-01 17:23 UTC  (11+ messages)

[PATCH] i2c: mpc: add register documentation to Freescale I2C driver
 2014-12-01 17:21 UTC  (2+ messages)

[PATCH v2] i2c: Driver to expose PowerNV platform i2c busses
 2014-12-01 16:56 UTC  (4+ messages)

[PATCH v3 2/4] i2c: omap: implement workaround for handling invalid BB-bit values
 2014-11-29 22:06 UTC  (6+ messages)
` [RFC] i2c: omap: TEST: do IP reset during probe


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).