messages from 2014-12-04 18:28:28 to 2014-12-18 17:44:07 UTC [more...]
[PATCH v3] i2c: rk3x: Account for repeated start time requirement
2014-12-18 17:44 UTC
[PATCH 3/3] iio: ak8975: Added autodetect feature for ACPI
2014-12-18 17:30 UTC (4+ messages)
[PATCH] input: adxl34x: Add OF match support
2014-12-18 13:03 UTC (4+ messages)
[PATCHv2 0/8] from now on, use 'isil' as prefix for Intersil
2014-12-17 21:59 UTC (4+ messages)
` [PATCHv2 2/8] dt-bindings: use isil prefix for Intersil in I2C trivial-devices.txt
[PATCH] i2c: sh_mobile: I2C_SH_MOBILE should depend on HAS_DMA
2014-12-17 18:29 UTC (7+ messages)
[PATCH 0/2] i2c: sh_mobile: handle deferred probe properly when requesting DMA channels
2014-12-17 18:29 UTC (5+ messages)
` [PATCH 1/2] i2c: sh_mobile: refactor DMA setup
` [PATCH 2/2] i2c: sh_mobile: rework deferred probing
[PATCH 0/2] i2c: i2c-mv64xxx: fix offload support
2014-12-17 18:15 UTC (5+ messages)
` [PATCH 1/2] i2c: i2c-mv64xxx: use BIT() macro for register value definitions
` [PATCH 2/2] i2c: i2c-mv64xxx: rework offload support to fix several problems
[RFC 0/2] i2c: sh_mobile: don't regress on deferred probing
2014-12-16 21:06 UTC (10+ messages)
` [RFC 1/2] i2c: sh_mobile: refactor DMA setup
` [RFC 2/2] i2c: sh_mobile: rework deferred probing
[PATCH] of: i2c: Add DT bindings for idle states to PCA954x mux driver
2014-12-16 20:13 UTC (8+ messages)
[PATCHv1 1/7] dt-bindings: use isil prefix for Intersil
2014-12-16 18:44 UTC (3+ messages)
[PATCH 0/4] Add I2C support to Broadcom iProc
2014-12-16 0:12 UTC (26+ messages)
` [PATCH 1/4] i2c: iProc: define Broadcom iProc I2C binding
` [PATCH 2/4] i2c: iproc: Add Broadcom iProc I2C Driver
` [PATCH 3/4] ARM: mach-bcm: Enable I2C support for iProc
` [PATCH 4/4] ARM: dts: add I2C device nodes for Broadcom Cygnus
` [PATCH v2 0/4] Add I2C support to Broadcom iProc
` [PATCH v2 1/4] i2c: iProc: define Broadcom iProc I2C binding
` [PATCH v2 2/4] i2c: iproc: Add Broadcom iProc I2C Driver
` [PATCH v2 3/4] ARM: mach-bcm: Enable I2C support for iProc
` [PATCH v2 4/4] ARM: dts: add I2C device nodes for Broadcom Cygnus
` [PATCH v3 0/3] Add I2C support to Broadcom iProc
` [PATCH v3 1/3] i2c: iProc: define Broadcom iProc I2C binding
` [PATCH v3 2/3] i2c: iproc: Add Broadcom iProc I2C Driver
` [PATCH v3 3/3] ARM: dts: add I2C device nodes for Broadcom Cygnus
[PATCH 0/5] i2c: sh_mobile: add DMA support
2014-12-15 14:50 UTC (25+ messages)
` [PATCH 2/5] "
[PATCH v5 1/3] mfd: add support for Cypress CYUSBS234 USB Serial Bridge controller
2014-12-15 10:07 UTC (6+ messages)
` [PATCH v5 3/3] gpio: add support for Cypress CYUSBS234 USB-GPIO adapter
` [PATCH v5 2/3] i2c: add support for Cypress CYUSBS234 USB-I2C adapter
[PULL REQUEST] i2c for 3.19
2014-12-14 13:38 UTC
[PATCH v4] i2c: Driver to expose PowerNV platform i2c busses
2014-12-13 18:01 UTC
[PATCH v4 2/3] i2c: add support for Cypress CYUSBS234 USB-I2C adapter
2014-12-13 12:14 UTC (4+ messages)
[PATCH v4 3/3] gpio: add support for Cypress CYUSBS234 USB-GPIO adapter
2014-12-13 11:50 UTC (3+ messages)
[PATCH v3] i2c: Driver to expose PowerNV platform i2c busses
2014-12-12 5:30 UTC (10+ messages)
` [v3] "
[PATCH v5 0/2] Cadence I2C driver fixes
2014-12-12 4:18 UTC (3+ messages)
` [PATCH v5 1/2] i2c: cadence: Handle > 252 byte transfers
` [PATCH v5 2/2] i2c: cadence: Check for errata condition involving master receive
[PATCH v3 0/2] ARM: mediatek: Add driver for Mediatek I2C controller
2014-12-12 2:40 UTC (5+ messages)
[PATCH v2] i2c: rk3x: Account for repeated start time requirement
2014-12-11 23:00 UTC
[PATCH] i2c: rk3x: Account for repeated start time requirement
2014-12-11 21:58 UTC (2+ messages)
[PATCH] i2c: sh_mobile: remove unneeded DMA mask
2014-12-11 21:29 UTC (2+ messages)
[PATCH 0/3] i2c: slave support framework for Linux devices
2014-12-11 21:26 UTC (2+ messages)
[PATCH] i2c: rk3x: fix bug that cause measured high_ns doesn't meet I2C spec
2014-12-11 19:22 UTC (19+ messages)
` [PATCH v2] "
` [PATCH v3] "
` [PATCH v4] i2c: rk3x: fix bug that cause measured high_ns doesn't meet I2C specification
` [PATCH v5] "
[PATCH v4 0/2] Cadence I2C driver fixes
2014-12-11 17:28 UTC (6+ messages)
` [PATCH v4 1/2] i2c: cadence: Handle > 252 byte transfers
` [PATCH v4 2/2] i2c: cadence: Check for errata condition involving master receive
[PATCH] i2c-qoriq: modified compatibility for correct prescaler
2014-12-11 13:44 UTC (10+ messages)
[PATCH] i2c: designware: use {readl|writel}_relaxed instead of readl/writel
2014-12-11 6:26 UTC
[PATCH 0/4] ARM: shmobile: koelsch: Add DA9063 watchdog restart support
2014-12-11 1:04 UTC (11+ messages)
` [PATCH 1/4] watchdog: da9063: Add restart handler support
` [PATCH 2/4] DT: i2c: Add devices handled by the da9063 MFD driver
` [PATCH 3/4] ARM: shmobile: koelsch: Add DA9063 PMIC device node for system restart
` [PATCH 4/4] ARM: shmobile: Enable DA9063 watchdog in multiplatform defconfig
[RFC] Documentation: i2c: add fault code for not supporting 10 bit addresses
2014-12-09 17:48 UTC
[PATCH v4 1/3] mfd: add support for Cypress CYUSBS234 USB Serial Bridge controller
2014-12-08 16:16 UTC (6+ messages)
[PATCH] MAINTAINERS: add I2C dt bindings also to I2C realm
2014-12-08 9:56 UTC
[PATCH v3] iio: imu: inv_mpu6050: Add i2c mux for by pass
2014-12-06 11:01 UTC (3+ messages)
[PULL REQUEST] i2c for 3.18
2014-12-06 8:26 UTC
[PATCH V2] i2c-designware: Add Intel Baytrail PMIC I2C bus support
2014-12-06 3:51 UTC (11+ messages)
` [PATCH V3 0/2] i2c-designware: Baytrail bus locking driver
` [PATCH V3 1/2] i2c-designware: Add i2c bus locking support
` [PATCH V3 2/2] i2c-designware: Add Intel Baytrail PMIC I2C bus support
[PATCH v2] iio: imu: inv_mpu6050: Add i2c mux for by pass
2014-12-05 17:49 UTC (5+ messages)
[RFC 0/2] i2c: omap: new fixes for driver
2014-12-05 17:18 UTC (6+ messages)
` [RFC 1/2] i2c: omap: fix buffer overruns during RX/TX data processing
[PATCH v3 0/2] Cadence I2C driver fixes
2014-12-05 17:11 UTC (5+ messages)
` [PATCH v3 1/2] i2c: cadence: Handle > 252 byte transfers
` [PATCH v3 2/2] i2c: cadence: Check for errata condition involving master receive
[PATCH v2 0/3] Cadence I2C driver fixes
2014-12-05 8:15 UTC (12+ messages)
` [PATCH v2 1/3] i2c: cadence: Handle > 252 byte transfers
` [PATCH v2 2/3] i2c: cadence: Set the hardware time-out register to maximum value
` [PATCH v2 3/3] i2c: cadence: Check for errata condition involving master receive
[PATCH v3 0/5] i2c: davinci improvements and fixes
2014-12-04 18:29 UTC (5+ messages)
` [PATCH v3 2/5] i2c: davinci: generate STP always when NACK is received
` [PATCH v3 3/5] i2c: recovery: change input parameter to i2c_adapter for prepare/unprepare_recovery
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox