linux-i2c.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
 messages from 2024-09-26 06:36:55 to 2024-10-04 09:41:28 UTC [more...]

[PATCH 00/51] treewide: Switch to __pm_runtime_put_autosuspend()
 2024-10-04  9:41 UTC  (2+ messages)
` [PATCH 16/51] i2c: "

[PATCH v14 0/3] Add ASPEED AST2600 I2Cv2 controller driver
 2024-10-04  6:58 UTC  (10+ messages)
` [PATCH v14 1/3] dt-bindings: i2c: aspeed: support for AST2600-i2cv2
` [PATCH v14 2/3] i2c: aspeed: support AST2600 i2c new register mode driver
` [PATCH v14 3/3] i2c: aspeed: support AST2600 i2c new register slave "

[PATCH v5 0/6] i2c: npcm: read/write operation, checkpatch
 2024-10-04  2:29 UTC  (15+ messages)
` [PATCH v5 1/6] i2c: npcm: correct the read/write operation procedure
` [PATCH v5 2/6] i2c: npcm: use a software flag to indicate a BER condition
` [PATCH v5 3/6] i2c: npcm: Modify timeout evaluation mechanism
` [PATCH v5 4/6] i2c: npcm: Modify the client address assignment
` [PATCH v5 5/6] i2c: npcm: use i2c frequency table
` [PATCH v5 6/6] i2c: npcm: Enable slave in eob interrupt

[PATCH v4 0/2] Compute HS HCNT and LCNT based on HW parameters
 2024-10-03 13:25 UTC  (6+ messages)
` [PATCH v4 1/2] dt-bindings: i2c: snps,designware-i2c: declare bus capacitance and clk freq optimized
` [PATCH v4 2/2] i2c: dwsignware: determine HS tHIGH and tLOW based on HW parameters

[PATCH v2 0/2] i2c: Add ACPI support for HJMC01
 2024-10-03 12:56 UTC  (7+ messages)
` [PATCH v2 1/2] ACPI: APD: Add clock frequency for HJMC01 I2C controller
` [PATCH v2 2/2] i2c: designware: Add a new ACPI HID "

[PATCH v8 0/2] i2c: octeon: Add block-mode r/w
 2024-10-03 12:16 UTC  (3+ messages)
` [PATCH v8 2/2] i2c: octeon: Add block-mode i2c operations

[PATCH v2 1/1] i2c: qcom-geni: Support systems with 32MHz serial engine clock
 2024-10-03  7:51 UTC  (10+ messages)

[PATCH v1 1/2] i2c: designware: constify abort_sources
 2024-10-03  2:58 UTC  (3+ messages)

[PATCH V4] i2c: imx-lpi2c: add target mode support
 2024-10-02 22:05 UTC  (2+ messages)

回收: [PATCH v3 1/2] dt-bindings: i2c: snps,designware-i2c: declare bus capacitance and clk freq optimized
 2024-10-02 21:18 UTC  (2+ messages)

[PATCH v2] i2c: qcom-geni: Keep comment why interrupts start disabled
 2024-10-02 21:17 UTC  (2+ messages)

[PATCH v4 0/4] i2c: imx: prevent rescheduling in non-dma mode
 2024-10-02 15:16 UTC  (12+ messages)
` [PATCH v4 1/4] i2c: imx: only poll for bus busy in multi master mode
` [PATCH v4 2/4] i2c: imx: separate atomic, dma and non-dma use case
` [PATCH v4 3/4] i2c: imx: use readb_relaxed and writeb_relaxed
` [PATCH v4 4/4] i2c: imx: prevent rescheduling in non dma mode

[PATCH v3 0/2] Compute HS HCNT and LCNT based on HW parameters
 2024-10-02 14:17 UTC  (11+ messages)
` [PATCH v3 1/2] dt-bindings: i2c: snps,designware-i2c: declare bus capacitance and clk freq optimized
` [PATCH v3 2/2] i2c: dwsignware: determine HS tHIGH and tLOW based on HW parameters

[PATCH 00/21] Adding support of ADI ARMv8 ADSP-SC598 SoC
 2024-10-02 13:53 UTC  (8+ messages)
` [PATCH 09/21] gpio: add driver for ADI ADSP-SC5xx platform
` [PATCH 11/21] irqchip: Add irqchip "

[PATCH v5 6/6] i2c: Add driver for the RTL9300 I2C controller
 2024-10-02 10:57 UTC  (8+ messages)
` [PATCH] fixup! "

[linux][PATCH v2 10/20] dt-bindings: i2c: microchip: corei2c: Add PIC64GX as compatible with driver
 2024-10-02 10:40 UTC  (3+ messages)

[PATCH] i2c: Switch back to struct platform_driver::remove()
 2024-10-02  9:11 UTC  (3+ messages)

[PATCH v3 1/1] i2c: qcom-geni: Support systems with 32MHz serial engine clock
 2024-10-02  9:01 UTC  (3+ messages)

[PATCH v5 0/7] Add SDM670 camera subsystem
 2024-10-02  8:53 UTC  (15+ messages)
` [PATCH v5 1/7] dt-bindings: clock: qcom,sdm845-camcc: add sdm670 compatible
` [PATCH v5 2/7] dt-bindings: i2c: qcom-cci: Document SDM670 compatible
` [PATCH v5 3/7] i2c: qcom-cci: Stop complaining about DT set clock rate
` [PATCH v5 4/7] dt-bindings: media: camss: Add qcom,sdm670-camss
` [PATCH v5 5/7] media: qcom: camss: add support for SDM670 camss
` [PATCH v5 6/7] arm64: dts: qcom: sdm670: add camcc
` [PATCH v5 7/7] arm64: dts: qcom: sdm670: add camss and cci

[PATCH v2 0/7] i2c: designware: Group all DesignWare drivers under a single option
 2024-10-02  8:45 UTC  (3+ messages)

[PATCH v1] i2c: microchip-core: actually use repeated sends
 2024-10-02  8:42 UTC  (6+ messages)

[PATCH dt-schema] schemas: i2c: add optional GPIO binding for SMBALERT# line
 2024-10-01 23:05 UTC  (8+ messages)

[PATCH v3 0/5] Congatec Board Controller drivers
 2024-10-01 18:52 UTC  (7+ messages)
` [PATCH v3 1/5] mfd: add Congatec Board Controller mfd driver
` [PATCH v3 2/5] gpio: Congatec Board Controller gpio driver
` [PATCH v3 3/5] i2c: Congatec Board Controller i2c bus driver
` [PATCH v3 4/5] watchdog: Congatec Board Controller watchdog timer driver
` [PATCH v3 5/5] MAINTAINERS: Add entry for Congatec Board Controller

[PATCH v2] i2c: stm32f7: Do not prepare/unprepare clock during runtime suspend/resume
 2024-10-01 14:40 UTC  (2+ messages)

[PATCH] i2c: amd-asf: Fix uninitialized variables issue in amd_asf_process_target
 2024-10-01 13:25 UTC  (7+ messages)
  ` [PATCH v2] "

[PATCH v2 0/5] Congatec Board Controller drivers
 2024-10-01 10:00 UTC  (3+ messages)
` [PATCH v2 3/5] i2c: Congatec Board Controller i2c bus driver

[PATCH v2 0/3] hwmon: pmbus: add tps25990 efuse support
 2024-10-01  7:03 UTC  (3+ messages)
` [PATCH v2 3/3] hwmon: (pmbus/tps25990): add initial support

[PATCH v3 0/4] Enable shared SE support over I2C
 2024-10-01  2:39 UTC  (14+ messages)
` [PATCH v3 1/4] dt-bindindgs: i2c: qcom,i2c-geni: Document shared flag
` [PATCH v3 2/4] dma: gpi: Add Lock and Unlock TRE support to access SE exclusively
` [PATCH v3 3/4] soc: qcom: geni-se: Do not keep GPIOs to sleep state for shared SE usecase
` [PATCH v3 4/4] i2c: i2c-qcom-geni: Enable i2c controller sharing between two subsystems

[PATCH] i2c: stm32f7: Do not prepare/unprepare clock during runtime suspend/resume
 2024-09-30 19:26 UTC  (3+ messages)

[PATCH v2 0/4] i2c: Replace lists of special clients with flagging of such clients
 2024-09-30 10:59 UTC  (4+ messages)

[PATCH v8 0/8] Add tsd,mule-i2c-mux support
 2024-09-30 10:55 UTC  (11+ messages)
` [PATCH v8 2/8] i2c: muxes: add support for tsd,mule-i2c multiplexer
` [PATCH v8 3/8] dt-bindings: hwmon: add support for ti,amc6821
` [PATCH v8 4/8] hwmon: (amc6821) add support for tsd,mule
` (subset) [PATCH v8 0/8] Add tsd,mule-i2c-mux support

[PATCH v2 0/3] amlogic SoC's power-domains fixes
 2024-09-30  7:33 UTC  (2+ messages)
` (subset) "

[PULL REQUEST] i2c-for-6.12-rc1-additional_fixes
 2024-09-29 17:04 UTC  (2+ messages)

[PATCH v4 0/7] Add SDM670 camera subsystem
 2024-09-28 10:46 UTC  (7+ messages)

[PATCH v2 0/2] Compute HS HCNT and LCNT based on HW parameters
 2024-09-28  7:07 UTC  (7+ messages)
` [PATCH v2 1/2] dt-bindings: i2c: snps,designware-i2c: add bus-capacitance-pf and clk-freq-optimized
` [PATCH v2 2/2] i2c: dwsignware: determine HS tHIGH and tLOW based on HW parameters

[GIT PULL v2] i2c-host-fixes for v6.12-rc1
 2024-09-27 16:11 UTC 

[GIT PULL] i2c-host-fixes for v6.12-rc1
 2024-09-27 16:01 UTC  (3+ messages)

[PATCH 0/2] Compute HS HCNT and LCNT based on HW parameters
 2024-09-27 13:41 UTC  (11+ messages)
` [PATCH 1/2] i2c: designware: determine HS tHIGH and tLOW based on HW paramters

[PATCH] i2c: i2c-qcom-geni: Serve transfer during early resume stage
 2024-09-27 12:32 UTC  (5+ messages)

[PATCH v4 0/6] i2c: npcm: read/write operation, checkpatch
 2024-09-27  2:03 UTC  (10+ messages)
` [PATCH v4 1/6] i2c: npcm: correct the read/write operation procedure
` [PATCH v4 2/6] i2c: npcm: use a software flag to indicate a BER condition
` [PATCH v4 3/6] i2c: npcm: Modify timeout evaluation mechanism

[PATCH v5 0/6] RTL9300 support for reboot and i2c
 2024-09-26 20:58 UTC  (11+ messages)
` [PATCH v5 3/6] dt-bindings: mfd: Add Realtek RTL9300 switch peripherals
` [PATCH v5 4/6] mips: dts: realtek: Add syscon-reboot node
` [PATCH v5 5/6] mips: dts: realtek: Add I2C controllers
  ` [PATCH v5] fixup! i2c: Add driver for the RTL9300 I2C controller

[PATCH v1 0/5] i2c: designware: Cleanups (part 4)
 2024-09-26 20:03 UTC  (2+ messages)


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).