messages from 2026-07-21 09:54:15 to 2026-07-27 13:10:37 UTC [more...]
[PATCH] nvmem: core: Mark nWP GPIO as non-exclusive
2026-07-27 13:10 UTC (6+ messages)
[PATCH v2 0/2] i2c: rcar: add Gen5 support
2026-07-27 12:25 UTC (3+ messages)
` [PATCH v2 1/2] dt-bindings: i2c: rcar-i2c: Document R-Car X5H support
` [PATCH v2 2/2] i2c: rcar: add R-Car Gen5 support
[PATCH 0/2] i2c: rcar: add Gen5 support
2026-07-27 11:48 UTC (4+ messages)
` [PATCH 1/2] dt-bindings: i2c: rcar-i2c: Document R-Car X5H support
` [PATCH 2/2] i2c: rcar: add R-Car Gen5 support
[PATCH v2 0/8] riscv: eswin: eic7700: Add support for clocks, resets, pinctrl, HSP bus, I2C and watchdog
2026-07-27 10:22 UTC (7+ messages)
` [PATCH v2 4/8] dt-bindings: mfd: syscon: add ESWIN EIC7700 compatible
` [PATCH v2 6/8] dt-bindings: i2c: dw: add ESWIN EIC7700 SoC I2C controller
[PATCH v2 0/3] i2c: qcom-cci: Fix CCI clock rate enforcement
2026-07-27 9:50 UTC (7+ messages)
` [PATCH v2 1/3] i2c: qcom-cci: Switch msm8953 to the CCI v2 timing/rate config
` [PATCH v2 2/3] Revert "i2c: qcom-cci: Remove unused struct member cci_clk_rate"
` [PATCH v2 3/3] i2c: qcom-cci: Fix CCI clock rate enforcement
[PATCH v7 0/3] i2c: ma35d1: Add support for MA35D1 I2C controller
2026-07-27 8:18 UTC (4+ messages)
` [PATCH v7 1/3] dt-bindings: i2c: nuvoton,ma35d1-i2c: Add "
` [PATCH v7 2/3] i2c: ma35d1: Add Nuvoton MA35D1 I2C driver support
` [PATCH v7 3/3] arm64: dts: nuvoton: Add I2C nodes for MA35D1 SoC
[PATCH v4] i2c: Add FTDI FT4222H USB I2C adapter
2026-07-27 8:07 UTC (3+ messages)
[PATCH 0/3] Add Qualcomm I2C slave controller driver
2026-07-27 4:36 UTC (4+ messages)
` [PATCH v1 1/3] dt-bindings: i2c: Add Qualcomm I2C slave controller
[PATCH v6 0/2] i2c: Add dynamic transfer timeout based on message length and frequency
2026-07-27 4:15 UTC (11+ messages)
` [PATCH v6 1/2] i2c: core: Add i2c_update_timeout() helper for dynamic transfer timeouts
` [PATCH v6 2/2] i2c: qcom-geni: Add dynamic transfer timeout based on transfer length and frequency
[PATCH 0/8] driver core: prefer platform_device_set_fwnode()
2026-07-26 20:50 UTC (6+ messages)
` [PATCH 2/8] i2c: pxa-pci: use platform_device_set_fwnode()
` [PATCH 5/8] pmdomain: imx: "
[PATCH v2 0/8] Add support for Advantech EIO MFD series devices
2026-07-26 20:41 UTC (5+ messages)
` [PATCH v2 2/8] Add Advantech EIO GPIO driver
` [PATCH v2 4/8] Add Advantech EIO I2C driver
[PATCH 0/3] i2c: qcom-cci: Fix CCI clock rate enforcement
2026-07-26 15:08 UTC (16+ messages)
` [PATCH 1/3] Revert "i2c: qcom-cci: Remove unused struct member cci_clk_rate"
` [PATCH 2/3] i2c: qcom-cci: Add missing cci_clk_rate for msm8953
` [PATCH 3/3] i2c: qcom-cci: Fix CCI clock rate enforcement
[PATCH v3 0/9] Initial Apple M3 Pro, Max and Ultra device trees
2026-07-26 15:04 UTC (11+ messages)
` [PATCH v3 1/9] dt-bindings: arm: apple: Add M3 Pro/Max/Ultra devices (T603x)
` [PATCH v3 2/9] dt-bindings: interrupt-controller: apple,aic2: Invert #interrupt-cells condition
` [PATCH v3 3/9] dt-bindings: interrupt-controller: apple,aic2: Add apple,t6031-aic3 compatible
` [PATCH v3 4/9] dt-bindings: arm: apple: apple,pmgr: Add t6030 and t6031 compatibles
` [PATCH v3 5/9] dt-bindings: power: apple,pmgr-pwrstate: "
` [PATCH v3 6/9] dt-bindings: i2c: apple,i2c: "
` [PATCH v3 7/9] dt-bindings: pwm: apple,s5l-fpwm: "
` [PATCH v3 8/9] arm64: dts: apple: Initial T603[124] (M3 Max and Ultra) device trees
` [PATCH v3 9/9] arm64: dts: apple: Initial T6030 (M3 Pro) "
[PATCH v2] i2c: i801: Clamp adapter timeout to prevent system lockup
2026-07-26 14:19 UTC (4+ messages)
[PATCH 0/3] usbio: fix two out-of-bounds accesses and a hang
2026-07-26 12:18 UTC (9+ messages)
` [PATCH 1/3] usb: misc: usbio: reject endpoints smaller than the packet header
` [PATCH 2/3] i2c: usbio: reject bridges with undersized transfer buffers
` [PATCH 3/3] usb: misc: usbio: bound the debug hex dumps by the received length
[PATCH v2 0/3] usbio: fix two out-of-bounds accesses and a hang
2026-07-26 11:41 UTC (5+ messages)
` [PATCH v2 1/3] usb: misc: usbio: reject endpoints smaller than the packet header
` [PATCH v2 2/3] i2c: usbio: reject bridges with undersized transfer buffers
` [PATCH v2 3/3] usb: misc: usbio: bound the debug hex dumps by the received length
[RFC PATCH 0/3] rust: power_supply class abstraction and SMB347 charger driver
2026-07-26 2:33 UTC (3+ messages)
[PATCH] i2c: rtl9300: remove IO_MODE configuration
2026-07-25 8:21 UTC
[PATCH v8 0/2] i2c: ls2x: Add clock- related properties and parsing
2026-07-24 23:39 UTC (4+ messages)
` [PATCH v8 1/2] dt-bindings: i2c: ls2x-i2c: Add clocks and clock-frequency properties
` [PATCH v8 2/2] i2c: ls2x: Add clocks property parsing and adjust bus speed
[PATCH] i2c: amd-mp2: Unregister callback on adapter add failure
2026-07-24 23:03 UTC (2+ messages)
[PATCH] i2c: spacemit: request IRQ after controller initialization
2026-07-24 22:52 UTC (5+ messages)
` [PATCH v2] "
[PATCH v7 0/2] i2c: i2c-qcom-geni: serve transfers during early resume
2026-07-24 8:29 UTC (5+ messages)
` [PATCH v7 1/2] i2c: qcom-geni: Handle runtime PM disabled state "
[PATCH v12 0/7] I2C Mux per channel bus speed
2026-07-24 6:24 UTC (5+ messages)
` [PATCH v12 1/7] i2c: core: add callback to change bus frequency
` [PATCH v12 2/7] i2c: mux: add idle_state property to i2c_mux_core
[PATCH v8 0/8] Add VIM4 MCU/FAN support
2026-07-23 15:48 UTC (3+ messages)
` [PATCH v8 4/8] mfd: khadas-mcu: Add support for VIM4 MCU variant
[PATCH i2c-tools v4 0/8] decode-dimms: Implement DDR5 decoding
2026-07-23 13:40 UTC (9+ messages)
` [PATCH i2c-tools v4 1/8] decode-dimms: Implement DDR5 checksum parsing
` [PATCH i2c-tools v4 2/8] decode-dimms: Decode DDR5 Manufacturer Data
` [PATCH i2c-tools v4 3/8] decode-dimms: Decode timings and other data for DDR5
` [PATCH i2c-tools v4 5/8] decode-dimms: Add basic decoding of type specific information "
` [PATCH i2c-tools v4 4/8] decode-dimms: Decode DDR5 common module information
` [PATCH i2c-tools v4 6/8] decode-dimms: Add second level separator
` [PATCH i2c-tools v4 7/8] decode-dimms: Decode DDR5 error log
` [PATCH i2c-tools v4 8/8] decode-dimms: Add DDR5 XMP 3.0 and EXPO decoding
[PATCH] i2c-tools: i2ctransfer: Set I2C adapter timeout using I2C_TIMEOUT ioctl
2026-07-23 7:19 UTC (5+ messages)
[PATCH v6 0/6] Add CAMSS and IMX577 sensor support for Shikra EVK
2026-07-23 4:44 UTC (7+ messages)
` [PATCH v6 1/6] dt-bindings: media: qcom: Add Shikra CAMSS compatible
` [PATCH v6 2/6] arm64: dts: qcom: shikra: Add CAMSS node
` [PATCH v6 3/6] arm64: dts: qcom: shikra: Add CCI definitions
` [PATCH v6 4/6] arm64: dts: qcom: shikra: Add pin configuration for mclks
` [PATCH v6 5/6] arm64: dts: qcom: shikra-cqm-cqs-evk-imx577-camera: Add DT overlay
` [PATCH v6 6/6] arm64: dts: qcom: shikra-iqs-evk-imx577-camera: "
[PATCH] i2c: i801: Clamp adapter timeout to prevent system lockup
2026-07-23 2:51 UTC
[PATCH v3 0/9] arm64: mediatek: Chromebook trackpad supply fixes
2026-07-22 9:06 UTC (12+ messages)
` [PATCH v3 1/9] regulator: core: Add "enable and wait" functions
` [PATCH v3 2/9] Input: elan_i2c - sort include statements
` [PATCH v3 6/9] i2c: of-prober: Defer regulator_disable() on successful probe in simple helper
` [PATCH v3 7/9] platform/chrome: of_hw_prober: Add delay for hana trackpads
[PATCH v5 0/2] i2c-tools: Make tools accept bus path
2026-07-22 8:52 UTC (3+ messages)
` [PATCH v5 1/2] i2c-tools: Allow passing device file paths
` [PATCH v5 2/2] i2c-tools: Document device paths as I2CBUS arg
[PATCH v2 0/2] i2c: Add ACPI support for HJMC01
2026-07-22 7:30 UTC (2+ messages)
` [PATCH v3] ACPI: APD: Add clock frequency for HJMC01 I2C controller
[PATCH v3 2/3] dt-bindings: i2c: Add Novatek NT726xx SoC I2C controller
2026-07-22 6:29 UTC (4+ messages)
[PATCH v3 3/3] i2c: Add i2c-nt726xx.c I2C driver for Novatek NT726xx SoCs
2026-07-22 2:41 UTC (2+ messages)
[PATCH v3 1/3] MAINTAINERS: Add entry for Novatek NT726xx SoC I2C controller driver
2026-07-22 1:42 UTC (3+ messages)
[PATCH v2 0/6] ACPI: Introduce and use acpi_dev_is_video_device() helper
2026-07-21 13:40 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox