messages from 2026-07-27 09:21:40 to 2026-07-28 22:04:16 UTC [more...]
[PATCH v7 0/2] i2c: i2c-gpio: Enhance driver for buses with shared SCL
2026-07-28 22:04 UTC (5+ messages)
` [PATCH v7 2/2] "
[PATCH v2 0/2] Add trace events for Qualcomm GENI I2C drivers
2026-07-28 22:01 UTC (2+ messages)
[PATCH] i2c: qup: Propagate clock enable failures
2026-07-28 21:45 UTC (2+ messages)
[PATCH] i2c: qcom-cci: drop custom suspend/resume and rely on runtime PM helpers
2026-07-28 21:37 UTC (2+ messages)
[PATCH v3 1/2] i2c: imx: Clear slave pointer on registration error
2026-07-28 21:32 UTC (3+ messages)
` [PATCH v4 0/2] i2c: imx: Fix slave mode corner issues
[RESEND PATCH] i2c: smbus: make i2c_smbus_read_block_data() safer
2026-07-28 20:57 UTC (3+ messages)
[PATCH v2 0/6] ACPI: Introduce and use acpi_dev_is_video_device() helper
2026-07-28 19:21 UTC (3+ messages)
` [PATCH v2 4/6] i2c: acpi: Convert to "
[PATCH] i2c: iop3xx: fix adapter and IRQ teardown
2026-07-28 17:15 UTC
[PATCH v2] i2c: iproc: reset bus after timeout if START_BUSY is stuck
2026-07-28 16:34 UTC (3+ messages)
[PATCH v2 0/3] i2c: qcom-cci: Fix CCI clock rate enforcement
2026-07-28 15:57 UTC (12+ messages)
` [PATCH v2 1/3] i2c: qcom-cci: Switch msm8953 to the CCI v2 timing/rate config
` [PATCH v2 2/3] Revert "i2c: qcom-cci: Remove unused struct member cci_clk_rate"
` [PATCH v2 3/3] i2c: qcom-cci: Fix CCI clock rate enforcement
[PATCH v3 0/3] i2c: qcom-geni: improve transfer error recovery and synchronization
2026-07-28 15:46 UTC (2+ messages)
[PATCH v5] i2c: imx: mark I2C adapter when hardware is powered down
2026-07-28 15:35 UTC (2+ messages)
[PATCH v6 0/2] i2c: imx-lpi2c: fix probe error handling and reset controller
2026-07-28 15:31 UTC (2+ messages)
[PATCH v3 0/8] arm64: Add Axiado AX3005 SoC and EVK support
2026-07-28 15:24 UTC (5+ messages)
` [PATCH v3 3/8] dt-bindings: i2c: cdns: add Axiado AX3005 I2C variant
` [PATCH v3 8/8] arm64: dts: axiado: Add initial support for AX3005 SoC and eval board
[PATCH v2] i2c: i801: keep the byte-by-byte ISR buffer private to the driver
2026-07-28 14:50 UTC (2+ messages)
[PATCH v2 0/3] DO-NOT-MERGE: HID: mcp2221: stop device IO before hid_hw_stop and fix UAF/OOB-read
2026-07-28 13:14 UTC (4+ messages)
` [PATCH v2 1/3] HID: mcp2221: stop device IO before hid_hw_stop
` [PATCH v2 2/3] HID: mcp2221: clear rxbuf after I2C/SMBus transfer completes
` [PATCH v2 3/3] HID: mcp2221: validate report size in mcp2221_raw_event()
[PATCH v3 0/1] i2c: imc-skylake: add Intel Skylake-X iMC SMBus adapter
2026-07-28 12:24 UTC (2+ messages)
` [PATCH v3 1/1] "
[PATCH v6 0/2] i2c: Add dynamic transfer timeout based on message length and frequency
2026-07-28 10:14 UTC (8+ messages)
` [PATCH v6 1/2] i2c: core: Add i2c_update_timeout() helper for dynamic transfer timeouts
[PATCH v3] i2c: qcom-geni: Use devm_pm_runtime_enable() for PM management
2026-07-28 8:47 UTC (2+ messages)
[PATCH] dt-bindings: i2c: qcom,sa8255p-geni-i2c: Add compatible for Nord SA8797P
2026-07-28 8:38 UTC (2+ messages)
[PATCH] nvmem: core: Mark nWP GPIO as non-exclusive
2026-07-28 8:32 UTC (8+ messages)
[PATCH v13] i2c: designware: defer probe if child GpioInt controllers are not bound
2026-07-28 8:30 UTC (4+ messages)
[PATCH] HID: mcp2221: stop device IO before hid_hw_stop
2026-07-28 6:19 UTC
[PATCH v2] i2c: jz4780: Cache host clock rate at probe to prevent CCF prepare_lock deadlock
2026-07-27 20:59 UTC (2+ messages)
[PATCH v2 0/2] i2c: rcar: add Gen5 support
2026-07-27 12:25 UTC (3+ messages)
` [PATCH v2 1/2] dt-bindings: i2c: rcar-i2c: Document R-Car X5H support
` [PATCH v2 2/2] i2c: rcar: add R-Car Gen5 support
[PATCH 0/2] i2c: rcar: add Gen5 support
2026-07-27 11:48 UTC (4+ messages)
` [PATCH 1/2] dt-bindings: i2c: rcar-i2c: Document R-Car X5H support
` [PATCH 2/2] i2c: rcar: add R-Car Gen5 support
[PATCH v2 0/8] riscv: eswin: eic7700: Add support for clocks, resets, pinctrl, HSP bus, I2C and watchdog
2026-07-27 10:22 UTC (3+ messages)
` [PATCH v2 6/8] dt-bindings: i2c: dw: add ESWIN EIC7700 SoC I2C controller
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox