messages from 2026-07-29 08:59:17 to 2026-07-30 20:23:56 UTC [more...]
[PATCH v6 0/2] i2c: Add dynamic transfer timeout based on message length and frequency
2026-07-30 20:23 UTC (11+ messages)
` [PATCH v6 1/2] i2c: core: Add i2c_update_timeout() helper for dynamic transfer timeouts
[PATCH v3 0/3] i2c: xiic: fix SMBus block read and PEC support
2026-07-30 18:43 UTC (3+ messages)
[PATCH] i2c: core: fix debugfs UAF on adapter removal
2026-07-30 16:23 UTC
[PATCH v4 2/2] i2c: core: support recovery for single-ended GPIOs
2026-07-30 9:32 UTC (6+ messages)
` [PATCH v5 0/2] i2c: improve bus "
` [PATCH v5 2/2] i2c: core: support "
[PATCH v4 0/3] i2c: Add Novatek NT72676 SoC I2C controller
2026-07-30 7:25 UTC (4+ messages)
` [PATCH v4 1/3] dt-bindings: i2c: Add Novatek NT72676 "
` [PATCH v4 2/3] i2c: nt72676: Add Novatek NT72676 I2C controller driver
` [PATCH v4 3/3] MAINTAINERS: Add entry for "
[PATCH] i2c: prevent new device registration during adapter removal
2026-07-30 7:18 UTC
[PATCH] i2c: rtl9300: remove IO_MODE configuration
2026-07-29 21:28 UTC (2+ messages)
[PATCH v2 0/3] usbio: fix two out-of-bounds accesses and a hang
2026-07-29 21:16 UTC (3+ messages)
` [PATCH v2 1/3] usb: misc: usbio: reject endpoints smaller than the packet header
[PATCH v7 0/3] i2c: ma35d1: Add support for MA35D1 I2C controller
2026-07-29 21:06 UTC (3+ messages)
` [PATCH v7 2/3] i2c: ma35d1: Add Nuvoton MA35D1 I2C driver support
[PATCH v2 0/2] i2c: rcar: add Gen5 support
2026-07-29 20:35 UTC (2+ messages)
[PATCH v7 0/2] i2c: i2c-qcom-geni: serve transfers during early resume
2026-07-29 20:21 UTC (5+ messages)
` [PATCH v7 1/2] i2c: qcom-geni: Handle runtime PM disabled state "
` [PATCH v7 2/2] dmaengine: qcom-gpi: Keep GPI interrupt active during system resume
[PATCH v7 0/2] i2c: i2c-gpio: Enhance driver for buses with shared SCL
2026-07-29 19:02 UTC (2+ messages)
[PATCH v3 0/5] i2c: qcom-cci: Enforce the required CCI clock rate
2026-07-29 12:25 UTC (6+ messages)
` [PATCH v3 1/5] i2c: qcom-cci: Switch msm8953 to the CCI v2 timing/rate config
` [PATCH v3 2/5] i2c: qcom-cci: Support per-mode CCI clock rates
` [PATCH v3 3/5] i2c: qcom-cci: Add 19.2 MHz timings for the v2 CCI
` [PATCH v3 4/5] i2c: qcom-cci: Share the timing table across CCI revisions
` [PATCH v3 5/5] i2c: qcom-cci: Enforce the required CCI clock rate
[PATCH v2 0/3] i2c: qcom-cci: Fix CCI clock rate enforcement
2026-07-29 11:51 UTC (11+ messages)
` [PATCH v2 1/3] i2c: qcom-cci: Switch msm8953 to the CCI v2 timing/rate config
` [PATCH v2 3/3] i2c: qcom-cci: Fix CCI clock rate enforcement
[PATCH] i2c: fix use-after-free in debugfs directory during adapter removal
2026-07-29 8:58 UTC
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox