messages from 2026-09-08 10:43:05 to 2026-09-17 02:40:32 UTC [more...]
[PATCH v4] i2c: hisi: Add I2C bus recovery support
2026-09-17 2:40 UTC
[STABLE REQUEST] i2c: smbus: reject oversized block transfers in the common path
2026-09-16 23:46 UTC
[PATCH v10 0/2] i2c: mux: Propagate firmware nodes to channel adapters
2026-09-16 22:07 UTC (9+ messages)
` [PATCH v10 1/2] i2c: mux: Factor out channel node lookup
` [PATCH v10 2/2] i2c: mux: Propagate firmware nodes to channel adapters
[PATCH] i2c: of-prober: Fix device node reference leak in i2c_of_probe_simple_enable()
2026-09-16 22:06 UTC (2+ messages)
[PATCH] i2c: imx-lpi2c: use dmaengine_get_dma_device() for DMA mapping
2026-09-16 16:43 UTC (2+ messages)
[PATCH] i2c: st: Fix clock reference leak in st_i2c_probe()
2026-09-16 16:02 UTC
[PATCH] i2c: qcom-cci: Fix of_node reference leak in cci_probe()
2026-09-16 16:00 UTC
[PATCH] i2c: pnx: Fix of_node reference leak in i2c_pnx_probe()
2026-09-16 15:58 UTC
[PATCH] i2c: acpi: Fix adapter reference leak in i2c_acpi_new_device_by_fwnode()
2026-09-16 15:55 UTC
[PATCH RESEND] docs: i2c: writing-clients: Add missing end of command
2026-09-16 14:07 UTC
[PATCH v11 0/6] Add VIM4 MCU/FAN support
2026-09-16 13:01 UTC (4+ messages)
` [PATCH v11 3/6] mfd: khadas-mcu: Add support for VIM4 MCU variant
[PATCH 00/13] HID: ft260: add UART and GPIO support, plus I2C fixes
2026-09-16 12:58 UTC (5+ messages)
[PATCH v3] dt-bindings: i2c: renesas,rcar-i2c: allow 6 DMA channels
2026-09-16 10:50 UTC (4+ messages)
[PATCH] i2c: tiny-usb: add Zephyr Project VID/PID pair
2026-09-16 10:11 UTC (2+ messages)
[PATCH v9 0/2] i2c: Add dynamic transfer timeout based on message length and frequency
2026-09-16 10:05 UTC (4+ messages)
` [PATCH v9 1/2] i2c: core: Add i2c_update_timeout() helper for dynamic transfer timeouts
` [PATCH v9 2/2] i2c: qcom-geni: Add dynamic transfer timeout based on transfer length and frequency
[PATCH] i2c: qcom-cci: fix device_node refcount leak in cci_probe()/cci_remove()
2026-09-16 8:36 UTC (4+ messages)
` [PATCH v2] "
[PATCH v2 12/14] ARM: versatile: remove mps2 support
2026-09-16 8:11 UTC (2+ messages)
[PATCH 0/3] i2c: fix DMA channel leaks on probe error and remove
2026-09-16 7:54 UTC (2+ messages)
[PATCH] i2c: ljca: drop redundant explicit adapter deletion
2026-09-16 7:28 UTC (2+ messages)
[PATCH 04/20] i2c: viai2c-wmt: Fix clock leak in wmt_i2c_probe()
2026-09-16 7:17 UTC (2+ messages)
Re:i2c_hid_acpi: ELAN2514 touchscreen causes IRQ flood on HP Omnibook X 14 (Lunar Lake)
2026-09-16 7:00 UTC (2+ messages)
` i2c_hid_acpi: "
[PATCH] i2c: atr: fix dangling adapter pointer on add failure
2026-09-16 6:09 UTC (3+ messages)
` [PATCH v2] "
[PATCH] i2c: imx: disable autosuspend on remove
2026-09-16 5:28 UTC (3+ messages)
i2c: sysfs interface to enable MCTP on mux child busses
2026-09-16 2:17 UTC
[PATCH v3 0/2] Add Qualcomm I2C target controller driver
2026-09-15 13:48 UTC (6+ messages)
` [PATCH v3 2/2] i2c: qcom-target: Add driver for Qualcomm I2C target controller
[PATCH] i2c: imx-lpi2c: release clocks on remove
2026-09-15 11:07 UTC (2+ messages)
[PATCH] i2c: qcom-cci: enable SCL clock stretching in standard mode on CCI v2
2026-09-14 13:23 UTC
[PATCH v2 00/12] I2C - detailed transfer reporting in case of a fault
2026-09-14 12:19 UTC (3+ messages)
` [PATCH v2 02/12] i2c: nomadik: optimize struct layout, change unsigned char into u8
linux-next: regression in i2c-imx-lpi2c.c after rust-i2c-next merge (next-20260910)
2026-09-14 10:17 UTC (2+ messages)
[PATCH v2 0/3] i2c: Add Starfive JHB100 I2C master/slave support
2026-09-14 10:15 UTC (2+ messages)
` 回复: "
[PATCH 08/13] HID: ft260: uart: add modem pins control via ioctl
2026-09-14 8:57 UTC (3+ messages)
[PATCH] i2c: img-scb: disable autosuspend on remove
2026-09-14 8:55 UTC
[PATCH] i2c: fsi: fix device node reference leak on remove
2026-09-14 8:44 UTC
[PATCH v1] i2c: slave-testunit: prevent work requeueing during remove
2026-09-12 16:12 UTC
[PATCH v2 0/2] i2c: Add I2C High-Speed mode support for qcom-geni
2026-09-12 13:04 UTC (3+ messages)
` [PATCH v2 1/2] dmaengine: qcom-gpi: Add I2C High-Speed mode configuration support
` [PATCH v2 2/2] i2c: qcom-geni: Add support for I2C High-Speed mode
ee1004: DDR4 SPD cannot be read, decode-dimms fails, “Failed to select page 0 (-6)”
2026-09-11 20:33 UTC (5+ messages)
[PATCH v3 0/9] Congatec Board Controller: Add storage devices support
2026-09-11 18:48 UTC (10+ messages)
` [PATCH v3 1/9] mfd: cgbc: Fix use of negative error code as valid session handle
` [PATCH v3 2/9] mfd: cgbc: Add I2C platform data
` [PATCH v3 3/9] i2c: cgbc: Use plateform data to get bus ID and adapter name
` [PATCH v3 4/9] mfd: cgbc: Use PLATFORM_DEVID_AUTO for child device registration
` [PATCH v3 5/9] mfd: cgbc: Use real I2C bus names
` [PATCH v3 6/9] i2c: cgbc: Add support for fixed frequency buses
` [PATCH v3 7/9] mfd: cgbc: Add virtual I2C bus support
` [PATCH v3 8/9] mfd: cgbc: Add virtual storage devices on the virtual I2C bus
` [PATCH v3 9/9] i2c: cgbc: Register known I2C devices on the bus
[PATCH v2 0/9] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-09-11 17:42 UTC (13+ messages)
` [PATCH v2 4/9] soc: qcom: geni-se: Remove OPP rate reset from resource deactivation
` [PATCH v2 7/9] i2c: qcom-geni: Vote for SE clock rate using OPP
[PATCH v3] i2c: hisi: Add I2C bus recovery support
2026-09-11 9:25 UTC (2+ messages)
[PATCH v2] i2c: imx: add I2C_M_REV_DIR_ADDR and I2C_M_NOSTART
2026-09-11 8:35 UTC (3+ messages)
[PATCH] i2c: qcom-geni: Simplify PM resume error handling
2026-09-10 20:51 UTC (2+ messages)
[PATCH] i2c: amd: fix SMBus block header and PEC handling in the RX path
2026-09-10 18:44 UTC (2+ messages)
[PATCH v4] i2c: Add FTDI FT4222H USB I2C adapter
2026-09-10 9:16 UTC (4+ messages)
[PATCH v7] i2c: xiic: restore non-managed runtime PM to fix clk WARN flood
2026-09-10 6:40 UTC (3+ messages)
[PATCH v4 0/3] i2c: xiic: fix SMBus block read and PEC support
2026-09-10 3:40 UTC (4+ messages)
` [PATCH v4 1/3] i2c: xiic: preserve PEC byte length in SMBus block read setup
` [PATCH v4 2/3] i2c: xiic: defer RX_FULL until all trailing bytes are in FIFO
` [PATCH v4 3/3] i2c: xiic: don't clobber msg->len to signal block-read completion
[PATCH v9 0/3] i2c: Add Novatek NT72676 SoC I2C controller
2026-09-10 3:01 UTC (4+ messages)
` [PATCH v9 1/3] dt-bindings: i2c: Add Novatek NT72676 "
` [PATCH v9 2/3] i2c: nt72676: Add Novatek NT72676 I2C controller driver
` [PATCH v9 3/3] MAINTAINERS: Add entry for "
[PATCH] i2c: qcom-geni: Use modern PM operation macros
2026-09-09 17:04 UTC (2+ messages)
[PATCH RESEND 1/2] media: i2c: isl7998x: Inline i2c_check_functionality() check
2026-09-09 16:58 UTC (4+ messages)
` [PATCH RESEND 2/2] i2c: Change return type to bool for i2c_check_functionality()
[PATCH v2 00/10] riscv: Add device tree support for UltraRISC DP1000
2026-09-09 16:54 UTC (5+ messages)
` [PATCH v2 06/10] dt-bindings: i2c: dw: Add compatible for UltraRISC DP1000 SoC
` (subset) [PATCH v2 00/10] riscv: Add device tree support for UltraRISC DP1000
Acer Swift SFG14-01 Camera Support not working on Linux
2026-09-09 11:28 UTC (2+ messages)
[PATCH 0/2] i2c: mux: Add NXP PCA9641 I2C bus master arbiter
2026-09-09 10:00 UTC (6+ messages)
` [PATCH 1/2] dt-bindings: i2c: "
` [PATCH 2/2] i2c: mux: Add NXP PCA9641 I2C bus master arbiter driver
[PATCH 11/13] ARM: versatile: remove mps2 support
2026-09-08 19:58 UTC (7+ messages)
[PATCH v3] i2c: imx: honour I2C_M_IGNORE_NAK
2026-09-08 16:01 UTC
[PATCH v2 0/8] OMAP I2C driver cleanups
2026-09-08 15:42 UTC (9+ messages)
` [PATCH v2 1/8] i2c: omap: Drop bit shift for I2C register addresses
` [PATCH v2 2/8] i2c: omap: Remove unused is_rdr and is_xdr variables
` [PATCH v2 3/8] i2c: omap: Use devm_pm_runtime_enable() helper
` [PATCH v2 4/8] i2c: omap: Combine event flags register definitions
` [PATCH v2 5/8] i2c: omap: Use bool for flag values
` [PATCH v2 6/8] i2c: omap: Make reset bit name match register name
` [PATCH v2 7/8] i2c: omap: Switch to using BIT and GENMASK
` [PATCH v2 8/8] i2c: omap: Add OMAP_I2C_BUF_{TX,RX}TRSH definitions
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).