messages from 2026-10-15 10:09:06 to 2026-10-16 10:04:18 UTC [more...]
[PATCH v2 0/1] i2c: i2c-xiic: fix clearing of bnb irq
2026-10-16 10:04 UTC (4+ messages)
` [PATCH v2 1/1] "
[PATCH] HID: mcp2221: always initialize and cancel init_work
2026-10-16 9:48 UTC (2+ messages)
[PATCH 00/10] HID: validate short reports in raw_event callbacks
2026-10-16 9:37 UTC (2+ messages)
[PATCH 00/11] Add NVIDIA LSTP USB adapter drivers
2026-10-16 8:44 UTC (7+ messages)
[PATCH v3 0/7] i2c: qcom-cci: Runtime capability detection and improved read/write
2026-10-16 8:00 UTC (8+ messages)
` [PATCH v3 1/7] i2c: qcom-cci: Factor out write command queue programming
` [PATCH v3 2/7] i2c: qcom-cci: Handle and report queue overflow/underflow interrupts
` [PATCH v3 3/7] i2c: qcom-cci: Detect capabilities from CCI_HW_VERSION at runtime
` [PATCH v3 4/7] i2c: qcom-cci: Add burst write support
` [PATCH v3 5/7] i2c: qcom-cci: Extend i2c read limits based on CCI revision
` [PATCH v3 6/7] i2c: qcom-cci: Add burst read support
` [PATCH v3 7/7] i2c: qcom-cci: Build command words with FIELD_PREP()
[PATCH v4 0/9] Congatec Board Controller: Add storage devices support
2026-10-16 6:47 UTC (11+ messages)
` [PATCH v4 1/9] mfd: cgbc: Fix use of negative error code as valid session handle
` [PATCH v4 4/9] mfd: cgbc: Use PLATFORM_DEVID_AUTO for child device registration
` [PATCH v4 5/9] mfd: cgbc: Use real I2C bus names
[PATCH v11 0/3] i2c: ma35d1: Add support for MA35D1 I2C controller
2026-10-16 2:40 UTC (5+ messages)
` [PATCH v12 1/3] dt-bindings: i2c: nuvoton,ma35d1-i2c: Add "
` [PATCH v12 2/3] i2c: ma35d1: Add Nuvoton MA35D1 I2C driver support
` [PATCH v12 3/3] arm64: dts: nuvoton: Add I2C nodes for MA35D1 SoC
[PATCH v11 0/3] i2c: ma35d1: Add support for MA35D1 I2C controller
2026-10-16 0:55 UTC (4+ messages)
` [PATCH v11 2/3] i2c: ma35d1: Add Nuvoton MA35D1 I2C driver support
[PATCH] i2c: acpi: Fix adapter reference leak in i2c_acpi_new_device_by_fwnode()
2026-10-16 0:44 UTC (2+ messages)
[PATCH] i2c: rk3x: Disable the controller between transfers
2026-10-16 0:33 UTC (2+ messages)
[PATCH] i2c: stm32f7: close SMBus alert work before removing ARA
2026-10-16 0:12 UTC (2+ messages)
[PATCH v8] i2c: xiic: restore non-managed runtime PM to fix clk WARN flood
2026-10-15 21:04 UTC (3+ messages)
[PATCH v3 00/11] Cortina Systems CS75xx: interrupt controller, GPIO, I2C and TWD watchdog
2026-10-15 20:29 UTC (8+ messages)
` [PATCH v3 01/11] dt-bindings: interrupt-controller: Add Cortina Systems CS7542 peripheral interrupt controller
` [PATCH v3 02/11] irqchip: Add Cortina Systems CS75xx "
` [PATCH v3 05/11] dt-bindings: i2c: Add Cortina Systems CS7542 I2C controller
[PATCH v1 0/3] i2c: mlxbf: Fix master GW corruption
2026-10-15 16:19 UTC (2+ messages)
[PATCH] Revert "i2c: qcom-geni: Fix hardcoded clock index in SE_GENI_CLK_SEL"
2026-10-15 13:31 UTC (4+ messages)
[PATCH v3 0/8] soc: qcom: geni: Derive SE clock configuration from OPP table on SA8255P
2026-10-15 12:58 UTC (9+ messages)
` [PATCH v3 1/8] soc: qcom: geni-se: Populate clk_perf_tbl with SE source clock frequencies from perf OPP table
` [PATCH v3 2/8] soc: qcom: geni-se: Add helper to set SE clock rate via OPP
` [PATCH v3 3/8] soc: qcom: geni-se: Remove OPP rate reset from resource deactivation
` [PATCH v3 4/8] serial: qcom-geni: Use geni_se_set_rate() for source clock configuration
` [PATCH v3 5/8] spi: qcom-geni: Use geni_se_set_rate() for setting source clock frequency
` [PATCH v3 6/8] i2c: qcom-geni: Vote for SE clock rate using OPP
` [PATCH v3 7/8] i2c: qcom-geni: Use common GENI resource initialization helper
` [PATCH v3 8/8] i2c: qcom-geni: Use geni_se_set_rate() for setting source clock frequency
[PATCH v5 0/7] riscv: eswin: eic7700: Add support for clocks, resets, pinctrl, HSP bus, I2C and watchdog
2026-10-15 12:54 UTC (8+ messages)
` [PATCH v5 1/7] riscv: dts: eswin: add reset generator for EIC7700 SoC
` [PATCH v5 2/7] riscv: dts: eswin: add clock "
` [PATCH v5 3/7] riscv: dts: eswin: eic7700: add pinctrl support
` [PATCH v5 4/7] riscv: dts: eswin: add hsp bus node
` [PATCH v5 5/7] dt-bindings: i2c: dw: add ESWIN EIC7700 SoC I2C controller
` [PATCH v5 6/7] riscv: dts: eswin: add I2C controller support
` [PATCH v5 7/7] riscv: dts: eswin: add watchdog support
[PATCH v2] i2c: qcom-geni: Fix hardcoded clock index in SE_GENI_CLK_SEL
2026-10-15 12:33 UTC (3+ messages)
[PATCH v13 0/8] I2C Mux per channel bus speed
2026-10-15 11:01 UTC (9+ messages)
` [PATCH v13 1/8] i2c: core: add callback to change bus frequency
` [PATCH v13 2/8] i2c: mux: add idle_state property to i2c_mux_core
` [PATCH v13 3/8] i2c: mux: add support for per channel bus frequency
` [PATCH v13 4/8] i2c: davinci: calculate bus freq from Hz instead of kHz
` [PATCH v13 5/8] i2c: davinci: add support for setting bus frequency
` [PATCH v13 6/8] i2c: mux: ltc4306: set correct idle_state in i2c_mux_core
` [PATCH v13 7/8] docs: i2c: i2c-topology: add section about bus speed
` [PATCH v13 8/8] i2c: mux: pca954x: use idle state from i2c_mux_core
[PATCH v2 00/10] Initial Apple Silicon M4 Pro/Max device trees and dt-bindings
2026-10-15 10:24 UTC (15+ messages)
` [PATCH v2 03/10] dt-bindings: arm: cpus: Add Apple M4 Pro/Max CPU core compatibles
` [PATCH v2 04/10] dt-bindings: arm: power: apple,pmgr-pwrstate: Add t6041 compatible
` [PATCH v2 05/10] dt-bindings: arm: apple: apple,pmgr: "
` [PATCH v2 06/10] dt-bindings: pwm: apple,s5l-fpwm: "
` [PATCH v2 07/10] dt-bindings: pinctrl: apple,pinctrl: "
` [PATCH v2 08/10] dt-bindings: i2c: apple,i2c: "
` [PATCH v2 09/10] dt-bindings: arm: apple: Add M4 Pro/Max based devices
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox