messages from 2026-11-14 11:30:16 to 2026-11-15 12:19:12 UTC [more...]
[PULL REQUEST] i2c-andi-for-7.5-part1
2026-11-15 12:19 UTC
[PATCH v7 00/23] Add CAMSS support for SM8750 and Eliza
2026-11-15 12:16 UTC (32+ messages)
` [PATCH v7 01/23] dt-bindings: phy: qcom,x1e80100-csi2-phy: Add SM8750 CSI2 PHY
` [PATCH v7 02/23] dt-bindings: phy: qcom,x1e80100-csi2-phy: Add Eliza "
` [PATCH v7 03/23] dt-bindings: media: qcom,sm8750-camss: Add SM8750 CAMSS
` [PATCH v7 04/23] dt-bindings: media: qcom,eliza-camss: Add Eliza CAMSS
` [PATCH v7 05/23] dt-bindings: i2c: qcom-cci: Document Eliza compatible
` [PATCH v7 06/23] phy: qcom-mipi-csi2: Add SM8750 support
` [PATCH v7 07/23] media: qcom: camss: Add SM8750 compatible
` [PATCH v7 08/23] media: qcom: camss: Add PM clock definitions for SM8750
` [PATCH v7 09/23] media: qcom: camss: csid: Scale the clocks with the CSI-2 link rate
` [PATCH v7 10/23] media: qcom: camss: csid: Add support for CSID 980
` [PATCH v7 11/23] media: qcom: camss: vfe: Add support for VFE 980
` [PATCH v7 12/23] media: qcom: camss: tpg: Add support for v2.3.0 TPG
` [PATCH v7 13/23] media: qcom: camss: Add Eliza compatible
` [PATCH v7 14/23] arm64: dts: qcom: sm8750: Add CAMSS and CSIPHY block definitions
` [PATCH v7 15/23] arm64: dts: qcom: sm8750: Add CCI definitions
` [PATCH v7 16/23] arm64: dts: qcom: sm8750: Add camera MCLK pinctrl
` [PATCH v7 17/23] arm64: dts: qcom: sm8750-qrd: Enable S5KJN1 camera sensor
` [PATCH v7 18/23] arm64: dts: qcom: eliza: Add CAMSS and CSIPHY block definitions
` [PATCH v7 19/23] arm64: dts: qcom: eliza: Add CCI definitions
` [PATCH v7 20/23] arm64: dts: qcom: eliza: Add camera MCLK pinctrl
` [PATCH v7 21/23] arm64: dts: qcom: eliza-mtp: Add PM8010 PMICs
` [PATCH v7 22/23] arm64: dts: qcom: eliza-mtp: Enable rear camera
` [PATCH v7 23/23] arm64: dts: qcom: eliza-evk-imx577-camera: Add DT overlay
[PATCH v3 0/2] i2c: rtl9300: remove IO_MODE configuration
2026-11-15 9:32 UTC (4+ messages)
` [PATCH v3 1/2] i2c: rtl9300: add realtek,rtl9607c-i2c compatible
` [PATCH v3 2/2] dt-bindings: i2c: rtl9300: add 'rtl9607c-i2c'
[PATCH v3 00/16] HID: ft260: add UART and GPIO support, plus I2C fixes
2026-11-14 23:08 UTC (17+ messages)
` [PATCH v3 01/16] HID: ft260: add serial driver
` [PATCH v3 02/16] HID: ft260: uart: fix the "
` [PATCH v3 03/16] HID: ft260: add GPIO support
` [PATCH v3 04/16] HID: ft260: i2c: reduce driver module loading time
` [PATCH v3 05/16] HID: ft260: fix sysfs store failure notice for big numbers
` [PATCH v3 06/16] HID: ft260: i2c: reduce bus-error message severity
` [PATCH v3 07/16] HID: ft260: uart: enable flow control
` [PATCH v3 08/16] HID: ft260: uart: add modem pins control via ioctl
` [PATCH v3 09/16] HID: ft260: group sysfs attrs per HID interface
` [PATCH v3 10/16] HID: ft260: i2c: fix large write transaction failure
` [PATCH v3 11/16] HID: ft260: workaround for TN_189 errata endpoint STALL after enumeration
` [PATCH v3 12/16] HID: ft260: i2c: abort in-flight transfers with STOP before reset
` [PATCH v3 13/16] HID: ft260: i2c: reject an I2C clock outside the supported range
` [PATCH v3 14/16] HID: ft260: i2c: fix i2c_reset sysfs store return value
` [PATCH v3 15/16] HID: ft260: i2c: recover a bus held by a slave
` [PATCH v3 16/16] HID: ft260: use lock guards
[PATCH] irqchip: Convert chained handlers to guard_chained_irq()
2026-11-14 15:06 UTC
[PATCH] i2c: qup: scale the transfer timeout with the transfer length
2026-11-14 14:02 UTC
[PATCH v3 0/9] Initial Apple Silicon M5 device trees and dt-bindings
2026-11-14 12:55 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox