Re: [PATCH 13/13] extcon: intel-cht-wc: Add support for devices with an USB-micro-B connector

[Andy Shevchenko <andy.shevchenko@gmail.com>]

On Sat, Oct 30, 2021 at 9:29 PM Hans de Goede <hdegoede@redhat.com> wrote:
>
> So far the extcon-intel-cht-wc code has only been tested on devices with
> a Type-C connector with USB-PD, USB3 (superspeed) and DP-altmode support
> through a FUSB302 Type-C controller.
>
> Some devices with the intel-cht-wc PMIC however come with an USB-micro-B
> connector, or an USB-2 only Type-C connector without USB-PD.
>
> These device are identified by "intel,cht-wc-setup" = "bq25890,bq27520",
> since there is no Type-C controller on these devices the extcon code must
> control the Vbus 5V boost converter and the USB role switch depending on
> the detected cable-type.

...

> +       if (ext->vbus_boost && ext->vbus_boost_enabled != enable) {
> +               if (enable)
> +                       ret = regulator_enable(ext->vbus_boost);
> +               else
> +                       ret = regulator_disable(ext->vbus_boost);

> +               if (ret == 0)
> +                       ext->vbus_boost_enabled = enable;
> +               else
> +                       dev_err(ext->dev, "Error updating Vbus boost regulator: %d\n", ret);

if (ret)
 dev_err()
else
 ...

?

> +       }

...


> +               /*
> +                * Classic micro USB-B setup, this requires controling

controlling

> +                * the role-sw and vbus based on the id-pin.
> +                */

-- 
With Best Regards,
Andy Shevchenko