Re: i2c: designware: unhandled interrupt on N100 lpss channel 0

Heiner Kallweit
2024-03-22T19:28:11Z

On 22.03.2024 17:18, Andy Shevchenko wrote:
> On Thu, Mar 21, 2024 at 10:00:27PM +0100, Heiner Kallweit wrote:
>> On 21.03.2024 18:33, Andy Shevchenko wrote:
>>> On Thu, Mar 21, 2024 at 12:59:59PM +0100, Heiner Kallweit wrote:
>>>> On 21.03.2024 12:20, Andy Shevchenko wrote:
>>>>> On Wed, Mar 20, 2024 at 10:26:06PM +0100, Heiner Kallweit wrote:
>>>>>> On 20.03.2024 22:07, Andy Shevchenko wrote:
>>>>>>> On Wed, Mar 20, 2024 at 09:21:34PM +0100, Heiner Kallweit wrote:
>>>>>>>> On 20.03.2024 16:59, Andy Shevchenko wrote:
>>>>>>>>> On Wed, Mar 20, 2024 at 03:56:29PM +0100, Heiner Kallweit wrote:
>
> ...
>
>>>>>>>>> grep 0000001b /sys/kernel/debug/pinctrl/*/pins
>>>>>>>>
>>>>>>>> pin 3 (GPPC_B_3) 3:INTC1057:00 GPIO 0x80100102 0x0000001b 0x00000000 [LOCKED tx]
>>>>>>>> pin 82 (GPP_F_7_EMMC_CMD) 135:INTC1057:00 GPIO 0x44000300 0x0000001b 0x00000000 [LOCKED full, ACPI]
>>>>>>>> pin 182 (GPPC_C_13) 269:INTC1057:00 GPIO 0x44000300 0x0000001b 0x00000000 [LOCKED full, ACPI]
>>>>>>>
>>>>>>> I was not correct, the value to grep is '0000[0-3][0-9a-f]1b' as there pull
>>>>>>> up/down can be enabled.
>>>>>>>
>>>>>> Result is the same
>>>>>>
>>>>>>> Nevertheless from the above the pin 3 is one that is enabled as GPIO input with
>>>>>>> RTE 27 and direct IRQ. If it's a culprit, try to add in the pinctrl-intel.c at
>>>>>>> the end of .probe:
>>>>>>>
>>>>>>> {
>>>>>>> void __iomem *padcfg0;
>>>>>>> u32 value;
>>>>>>>
>>>>>>> padcfg0 = intel_get_padcfg(pctrl, 3, PADCFG0);
>>>>>>>
>>>>>>> value = readl(padcfg0);
>>>>>>> value |= PADCFG0_GPIOTXDIS;
>>>>>>> value |= PADCFG0_GPIORXDIS;
>>>>>>> writel(value, padcfg0);
>>>>>>> }
>>>>>>>
>>>>>>> If it helps, it will show the BIOS bug (likely).
>>>>>>>
>>>>>> Wow, this indeed fixes the issue for me. Thanks a lot!
>>>>>
>>>>> Wow! Glad to hear this.
>>>>> (Side note, can you test the patch against idma64 I sent yesterday?
>>>>> Tested-by tag will be appreciated!)
>>>>>
>>>> Done, sent the Tested-by
>>>
>>> Thank you!
>>>
>>>>> We may try to have the quirk in the kernel, but it might be (quite) tricky
>>>>> (see the link below).
>>>>>
>>>>> Can you share `acpidump -o n100-tables.dat` (the file) somewhere?
>>>>> I would like to see if this pin is anyhow being mentioned in the DSDT.
>>>>>
>>>> Attached. Compressed file isn't that big, so hope it's ok to send it
>>>> as an attachment.
>>>
>>> Yes, got it.
>>>
>>> Can you also share the output of
>>>
>>> 1) `dmesg` (when kernel command line has 'ignore_loglevel apic=debug');
>> attached
>>> 2) `lspci -nk -vv`;
>> attached
>>> 3) `grep -H 15 /sys/bus/acpi/devices/*/status`?
>>>
>> /sys/bus/acpi/devices/ACPI0003:00/status:15
>> /sys/bus/acpi/devices/ACPI000C:00/status:15
>> /sys/bus/acpi/devices/ACPI000E:00/status:15
>> /sys/bus/acpi/devices/device:4a/status:15
>> /sys/bus/acpi/devices/device:86/status:15
>> /sys/bus/acpi/devices/device:87/status:15
>> /sys/bus/acpi/devices/device:88/status:15
>> /sys/bus/acpi/devices/device:8a/status:15
>> /sys/bus/acpi/devices/device:8b/status:15
>> /sys/bus/acpi/devices/device:8c/status:15
>> /sys/bus/acpi/devices/INT33A1:00/status:15
>> /sys/bus/acpi/devices/INTC1041:00/status:15
>> /sys/bus/acpi/devices/INTC1048:00/status:15
>> /sys/bus/acpi/devices/INTC1057:00/status:15
>> /sys/bus/acpi/devices/INTC1070:00/status:15
>> /sys/bus/acpi/devices/INTC1099:00/status:15
>> /sys/bus/acpi/devices/MSFT0001:00/status:15
>> /sys/bus/acpi/devices/OVTI01AS:00/status:15
>> /sys/bus/acpi/devices/OVTID858:00/status:15
>> /sys/bus/acpi/devices/PNP0103:00/status:15
>> /sys/bus/acpi/devices/PNP0C09:00/status:15
>> /sys/bus/acpi/devices/PNP0C0C:00/status:15
>> /sys/bus/acpi/devices/PNP0C0D:00/status:15
>> /sys/bus/acpi/devices/PRP00001:00/status:15
>> /sys/bus/acpi/devices/TXNW3643:00/status:15
>> /sys/bus/acpi/devices/TXNW3643:01/status:15
>
> Can you also add this
>
> grep -H 15 /sys/bus/acpi/devices/*/status | while read x; do grep -H . `dirname $x`/path; done
>

/sys/bus/acpi/devices/ACPI0003:00/path:\_SB_.ADP1
/sys/bus/acpi/devices/ACPI000C:00/path:\_SB_.PAGD
/sys/bus/acpi/devices/ACPI000E:00/path:\_SB_.AWAC
/sys/bus/acpi/devices/device:4a/path:\_SB_.PC00.TCPU
/sys/bus/acpi/devices/device:86/path:\_SB_.PC00.THC0.TLC1
/sys/bus/acpi/devices/device:87/path:\_SB_.PC00.THC0.TLC2
/sys/bus/acpi/devices/device:88/path:\_SB_.PC00.THC0.TLC3
/sys/bus/acpi/devices/device:8a/path:\_SB_.PC00.THC1.TLC1
/sys/bus/acpi/devices/device:8b/path:\_SB_.PC00.THC1.TLC2
/sys/bus/acpi/devices/device:8c/path:\_SB_.PC00.THC1.TLC3
/sys/bus/acpi/devices/INT33A1:00/path:\_SB_.PEPD
/sys/bus/acpi/devices/INTC1041:00/path:\_SB_.IETM
/sys/bus/acpi/devices/INTC1048:00/path:\_SB_.PC00.LPCB.H_EC.TFN1
/sys/bus/acpi/devices/INTC1057:00/path:\_SB_.GPI0
/sys/bus/acpi/devices/INTC1070:00/path:\_SB_.HIDD
/sys/bus/acpi/devices/INTC1099:00/path:\_SB_.PC00.LPCB.CWDT
/sys/bus/acpi/devices/MSFT0001:00/path:\_SB_.PC00.LPCB.PS2K
/sys/bus/acpi/devices/OVTI01AS:00/path:\_SB_.PC00.LNK0
/sys/bus/acpi/devices/OVTID858:00/path:\_SB_.PC00.LNK1
/sys/bus/acpi/devices/PNP0103:00/path:\_SB_.PC00.LPCB.HPET
/sys/bus/acpi/devices/PNP0C09:00/path:\_SB_.PC00.LPCB.H_EC
/sys/bus/acpi/devices/PNP0C0C:00/path:\_SB_.PWRB
/sys/bus/acpi/devices/PNP0C0D:00/path:\_SB_.PC00.LPCB.H_EC.LID0
/sys/bus/acpi/devices/PRP00001:00/path:\_SB_.PC00.HDAS.IDA_.SNDW
/sys/bus/acpi/devices/TXNW3643:00/path:\_SB_.PC00.FLM0
/sys/bus/acpi/devices/TXNW3643:01/path:\_SB_.PC00.FLM1

> ?
>
>>>>>> For my understanding: Shall we (kernel driver) rely on the BIOS to configure
>>>>>> GPIO's properly?
>>>>>
>>>>> Yes, but there are bugs.
>>>>> You may look, e.g., https://bugzilla.kernel.org/show_bug.cgi?id=214749.
>>>>>
>>>>>> Or better assume that GPIO's are in an unknown state on
>>>>>> driver load and configure them for our needs?
>>>>>
>>>>> It depends. But usually (> 99% cases) we rely on the firmware.
>>>>>
>>>>>> IOW: If we assume that other systems may have similar issues, should
>>>>>> "some driver" use e.g. the pinctrl API to configure relevant pins?
>