messages from 2026-10-16 16:46:41 to 2026-10-20 14:13:53 UTC [more...]
[PATCH 0/8] i3c: renesas: Add RZ/G3L support
2026-10-20 14:13 UTC (11+ messages)
` [PATCH 1/8] i3c: renesas: Fix zero I2C SCL rate on pure I3C buses
` [PATCH 2/8] i3c: renesas: Drop comma after OF match table sentinel
` [PATCH 3/8] dt-bindings: i3c: renesas,i3c: Add RZ/G3L support
` [PATCH 4/8] i3c: renesas: "
` [PATCH 5/8] clk: renesas: r9a08g046: Add I3C clocks and resets
` [PATCH 6/8] pinctrl: renesas: rzg2l: Split SoC-specific masks in struct rzg2l_register_masks
` [PATCH 7/8] pinctrl: renesas: rzg2l: Add RZ/G3L support for selecting I3C power source
` [PATCH 8/8] arm64: dts: renesas: r9a08g046: Add I3C support
[PATCH 0/3] i3c: renesas: Add support for the analog noise filter
2026-10-20 9:36 UTC (4+ messages)
` [PATCH 1/3] dt-bindings: i3c: renesas,i3c: Document analog noise filter control
` [PATCH 2/3] i3c: renesas: Add support for the analog noise filter
` [PATCH 3/3] arm64: dts: renesas: r9a08g046: Enable I3C "
[PATCH 00/20] arm64: add Synaptics SL261X SoCs and RDK boards
2026-10-20 1:08 UTC (7+ messages)
` [PATCH 04/20] dt-bindings: i3c: dw: support up to two reset lines
` [PATCH 05/20] i3c: dw: switch to array-based exclusive reset control
[PATCH 0/3] Add vendor glue layer support and Amlogic A9 implementation
2026-10-19 20:32 UTC (9+ messages)
` [PATCH 1/3] i3c: master: Rework SVC I3C to support vendor glue layers
` [PATCH 2/3] dt-bindings: i3c: Add Amlogic A9 I3C controller
` [PATCH 3/3] i3c: master: svc: Add Amlogic A9 glue layer
[RFC PATCH 0/7] i3c: hub: p3h2x4x: add debugfs, i2c-tools, bus rate and GPIO mode support
2026-10-19 14:25 UTC (9+ messages)
` [RFC PATCH 1/7] i3c: hub: p3h2x4x: Add support for debugfs
` [RFC PATCH 2/7] i3c: hub: add i2c-tools support for SMBus-configured target ports
` [RFC PATCH 3/7] dt-bindings: i3c: nxp,p3h2840: add clock-frequency for SMBus "
` [RFC PATCH 4/7] i3c: hub: p3h2x4x: add clock-frequency DTS support
` [RFC PATCH 5/7] dt-bindings: i3c: nxp,p3h2840: add GPIO mode target ports
` [RFC PATCH 6/7] i3c: hub: p3h2x4x: configure target ports placed in GPIO mode
` [RFC PATCH 7/7] gpio: p3h2x4x: add GPIO expander for the NXP P3H2x4x I3C hub
[PATCH v5 0/5] i3c: add i3cdev module to expose i3c dev in /dev
2026-10-19 9:47 UTC (8+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox