Re: [PATCH v7 5/8] i3c: target: add svc target controller support

[Frank Li <Frank.li@nxp.com>]

On Wed, Mar 06, 2024 at 04:01:17PM +0000, Joshua Yeong wrote:
> Hi Frank,
> 
> > -----Original Message-----
> > From: linux-i3c <linux-i3c-bounces@lists.infradead.org> On Behalf Of Frank Li
> > Sent: Tuesday, February 6, 2024 7:33 AM
> > To: frank.li@nxp.com
> > Cc: alexandre.belloni@bootlin.com; conor.culhane@silvaco.com;
> > devicetree@vger.kernel.org; gregkh@linuxfoundation.org;
> > ilpo.jarvinen@linux.intel.com; imx@lists.linux.dev; jirislaby@kernel.org;
> > joe@perches.com; krzysztof.kozlowski+dt@linaro.org;
> > krzysztof.kozlowski@linaro.org; linux-i3c@lists.infradead.org; linux-
> > kernel@vger.kernel.org; linux-serial@vger.kernel.org;
> > miquel.raynal@bootlin.com; robh@kernel.org;
> > zbigniew.lukwinski@linux.intel.com
> > Subject: [PATCH v7 5/8] i3c: target: add svc target controller support
> > 
> > Add Silvaco I3C target controller support
> > 
> > Signed-off-by: Frank Li <Frank.Li@nxp.com>
> > ---
> > 
> > Notes:
> >     Change from v2 to v3
> >     - fix build warning
> > 
> >  drivers/i3c/master/Makefile         |   2 +-
> >  drivers/i3c/master/svc-i3c-main.c   |  35 +-
> >  drivers/i3c/master/svc-i3c-target.c | 776
> 
> I think putting target mode files under "master" might not make sense. We might have to
> consider that we may have a "secondary master" mode. Some other ways of splitting
> or handling of target mode is needed here.

I think name 'master' is not good here. Previously only support 'master'
mode, it should be fine. Now many controller are dual mode.

And I3C spec use 'controller/target' instead of 'master/slave'. I think
'controller' as master are quite confused. It can be master controller
and slave controller.

Anyway, slave/master may share some code and resource, even only one file.

So far, I think it is fine put under master now. we can rename 'master'
later when more dual mode controller added. 

Frank 

> 
> ...
> 
> > +
> > +#define I3C_SCONFIG	0x4
> > +#define   I3C_SCONFIG_SLVENA_MASK	BIT(0)
> > +#define	  I3C_SCONFIG_OFFLINE_MASK	BIT(9)
> > +#define   I3C_SCONFIG_SADDR_MASK	GENMASK(31, 25)
> > +
> > +#define I3C_SSTATUS	0x8
> > +#define	  I3C_SSTATUS_STNOTSTOP_MASK	BIT(0)
> > +#define	  I3C_SSTATUS_STOP_MASK		BIT(10)
> > +#define	  I3C_SSTATUS_RX_PEND_MASK	BIT(11)
> > +#define   I3C_SSTATUS_TXNOTFULL_MASK	BIT(12)
> > +#define	  I3C_SSTATUS_DACHG_MASK	BIT(13)
> > +#define	  I3C_SSTATUS_EVDET_MASK	GENMASK(21, 20)
> > +#define	  I3C_SSTATUS_EVDET_ACKED	0x3
> > +#define	  I3C_SSTATUS_IBIDIS_MASK	BIT(24)
> > +#define	  I3C_SSTATUS_HJDIS_MASK	BIT(27)
> > +
> 
> There is couple of space formatting here that requires to be fixed.
> 
> Cheers,
> Joshua

-- 
linux-i3c mailing list
linux-i3c@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-i3c