[ 0.000000] EFI v1.10 by INTEL: SALsystab=0xff1b0f70 ACPI 2.0=0xff1b8628 HCDP=0xff1b0e20 SMBIOS=0xff1b0e78 [ 0.000000] booting generic kernel on platform dig [ 0.000000] PCDP: v1 at 0xff1b0e20 [ 0.000000] No EFI ConOut variable? [ 0.000000] Early serial console at I/O port 0x3f8 (options '115200') [ 0.000000] bootconsole [uart8250] enabled [ 0.000000] ACPI: RSDP 00000000ff1b8628 00024 (v02 HOBVM) [ 0.000000] ACPI: XSDT 00000000ff1b864c 00034 (v01 HOBVM HOBVM 1 00000001 HOB 00000001) [ 0.000000] ACPI: APIC 00000000ff1b8680 000FC (v01 HOBVM HOBVM 1 00000001 HOB 00000001) [ 0.000000] ACPI: FACP 00000000ff1b877c 000F4 (v03 HOBVM HOBVM 1 00000001 HOB 00000001) [ 0.000000] ACPI: DSDT 00000000ff1b88b0 000F2 (v02 HOBVM HOBVM 1 00000001 INTL 20061109) [ 0.000000] ACPI: FACS 00000000ff1b8870 00040 [ 0.000000] ACPI: Local APIC address c0000000fee00000 [ 0.000000] 1 CPUs available, 16 CPUs total [ 0.000000] SAL 0.7: HOB VM version 0.2 [ 0.000000] SAL Platform features: None [ 0.000000] SAL: AP wakeup using external interrupt vector 0xfa [ 0.000000] ACPI: Local APIC address c0000000fee00000 [ 0.000000] GSI 12 (level, low) -> CPU 0 (0x0000) vector 49 [ 0.000000] Failed to register rendezvous interrupt with SAL (status -1) [ 0.000000] Virtual mem_map starts at 0xa07fffffffc80000 [ 0.000000] Zone PFN ranges: [ 0.000000] DMA 0x00000100 -> 0x00010000 [ 0.000000] Normal 0x00010000 -> 0x00010000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] early_node_map[2] active PFN ranges [ 0.000000] 0: 0x00000100 -> 0x00003fed [ 0.000000] 0: 0x00003ff4 -> 0x00004000 [ 0.000000] pcpu-alloc: s32408 r8192 d24936 u65536 alloc=1*65536 [ 0.000000] pcpu-alloc: [0] 0 [ 0.000000] Built 1 zonelists in Node order, mobility grouping off. Total pages: 16107 [ 0.000000] Policy zone: DMA [ 0.000000] Kernel command line: BOOT_IMAGE=dev000:\efi\VMLINUX.GZ root=/dev/hda2 console=hcdp all_generic_ide=off irqpoll ro [ 0.000000] Misrouted IRQ fixup and polling support enabled [ 0.000000] This may significantly impact system performance [ 0.000000] PID hash table entries: 4096 (order: -1, 32768 bytes) [ 0.000000] Placing 64MB software IO TLB between e000000004d30000 - e000000008d30000 [ 0.000000] software IO TLB at phys 0x4d30000 - 0x8d30000 [ 0.000000] Memory: 948992k/1018112k available (7172k code, 82752k reserved, 4688k data, 1856k init) [ 0.000000] SLUB: Genslabs=18, HWalign=128, Order=0-3, MinObjects=0, CPUs=1, Nodes=1024 [ 0.000000] Hierarchical RCU implementation. [ 0.000000] RCU-based detection of stalled CPUs is enabled. [ 0.000000] NR_IRQS:768 [ 0.000000] Console: colour dummy device 80x25 [ 0.010000] Calibrating delay loop... 34.71 BogoMIPS (lpj=173568) [ 0.192553] Security Framework initialized [ 0.193561] Dentry cache hash table entries: 131072 (order: 4, 1048576 bytes) [ 0.224653] Inode-cache hash table entries: 65536 (order: 3, 524288 bytes) [ 0.239342] Mount-cache hash table entries: 4096 [ 0.257512] ACPI: Core revision 20091214 [ 0.266935] Boot processor id 0x0/0x0 [ 0.267934] Brought up 1 CPUs [ 0.268188] Total of 1 processors activated (34.71 BogoMIPS). [ 0.315975] DMI 2.1 present. [ 0.322641] NET: Registered protocol family 16 [ 0.329219] ACPI: bus type pci registered [ 0.427107] bio: create slab at 0 [ 0.445644] ACPI: Interpreter enabled [ 0.445891] ACPI: (supports S0) [ 0.446273] ACPI: Using IOSAPIC for interrupt routing [ 0.472371] ACPI: No dock devices found. [ 0.473032] ACPI: PCI Root Bridge [PCI0] (0000:00) [ 0.476484] pci 0000:00:02.0: quirk: [io 0xb000-0xb03f] claimed by PIIX4 ACPI [ 0.497146] vgaarb: loaded [ 0.504033] SCSI subsystem initialized [ 0.514513] Switching to clocksource itc [ 0.515251] pnp: PnP ACPI init [ 0.515603] ACPI: bus type pnp registered [ 0.519008] GSI 4 (edge, high) -> CPU 0 (0x0000) vector 50 [ 0.528323] pnp: PnP ACPI: found 1 devices [ 0.528609] ACPI: ACPI bus type pnp unregistered [ 0.543804] NET: Registered protocol family 2 [ 0.548530] IP route cache hash table entries: 8192 (order: 0, 65536 bytes) [ 0.559868] TCP established hash table entries: 32768 (order: 3, 524288 bytes) [ 0.574819] TCP bind hash table entries: 32768 (order: 3, 524288 bytes) [ 0.592858] TCP: Hash tables configured (established 32768 bind 32768) [ 0.593267] TCP reno registered [ 0.593591] UDP hash table entries: 2048 (order: 0, 65536 bytes) [ 0.598355] UDP-Lite hash table entries: 2048 (order: 0, 65536 bytes) [ 0.603207] NET: Registered protocol family 1 [ 0.603798] pci 0000:00:00.0: Limiting direct PCI/PCI transfers [ 0.604227] pci 0000:00:01.0: PIIX3: Enabling Passive Release [ 0.604712] pci 0000:00:01.0: Activating ISA DMA hang workarounds [ 0.618517] PAL Information Facility v0.5 [ 0.619200] Please use IA-32 EL for executing IA-32 binaries [ 0.627611] HugeTLB registered 256 MB page size, pre-allocated 0 pages [ 0.797567] msgmni has been set to 1852 [ 0.813907] alg: No test for stdrng (krng) [ 1.734013] alg: No test for fips(ansi_cprng) (fips_ansi_cprng) [ 1.734665] io scheduler noop registered [ 1.734951] io scheduler deadline registered [ 1.739832] io scheduler cfq registered (default) [ 1.923203] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled [ 1.938548] 00:00: ttyS0 at I/O 0x3f8 (irq = 50) is a 16450 [ 1.992021] console [ttyS0] enabled [ 1.998467] Uniform Multi-Platform E-IDE driver [ 2.001212] piix 0000:00:03.0: IDE controller (0x8086:0x7010 rev 0x00) [ 2.002362] GSI 14 (level, low) -> CPU 0 (0x0000) vector 51 [ 2.003118] pci 0000:00:03.0: PCI INT A -> GSI 14 (level, low) -> IRQ 51 [ 2.004120] piix 0000:00:03.0: not 100% native mode: will probe irqs later [ 2.004954] IDE_PCI is in compatibility mode [ 2.007619] ide0: BM-DMA at 0xc000-0xc007 [ 2.008248] ide1: BM-DMA at 0xc008-0xc00f [ 2.317460] hda: QEMU HARDDISK, ATA DISK drive [ 2.677187] hdb: QEMU HARDDISK, ATA DISK drive [ 2.679419] hda: MWDMA2 mode selected [ 2.680381] hdb: MWDMA2 mode selected [ 3.288469] ide0: disabled, unable to get IRQ 34 [ 3.289065] ide0: failed to initialize IDE interface [ 3.289763] ide0: disabling port [ 3.290246] ide1: disabled, unable to get IRQ 33 [ 3.290843] ide1: failed to initialize IDE interface [ 3.291541] ide1: disabling port [ 3.292300] piix 0000:00:03.0: IDE controller (0x8086:0x7010 rev 0x00) [ 3.293163] PIIX_IDE 0000:00:03.0: BAR 0: can't reserve [io 0x01f0-0x01f7] [ 3.294025] piix 0000:00:03.0: can't reserve resources [ 3.294744] PIIX_IDE: probe of 0000:00:03.0 failed with error -16 [ 3.299621] ide_generic: please use "probe_mask=0x3f" module parameter for probing all legacy ISA IDE ports [ 3.300775] ide-gd driver 1.18 [ 3.302101] ide-cd driver 5.00 [ 3.317465] e100: Intel(R) PRO/100 Network Driver, 3.5.24-k2-NAPI [ 3.318224] e100: Copyright(c) 1999-2006 Intel Corporation [ 3.320231] Fusion MPT base driver 3.04.13 [ 3.320758] Copyright (c) 1999-2008 LSI Corporation [ 3.321494] Fusion MPT SAS Host driver 3.04.13 [ 3.328518] mice: PS/2 mouse device common for all mice [ 3.330586] NET: Registered protocol family 26 [ 3.345145] IPv4 over IPv4 tunneling driver [ 3.361202] GRE over IPv4 tunneling driver [ 3.381012] TCP cubic registered [ 3.381441] Initializing XFRM netlink socket [ 3.382037] NET: Registered protocol family 17 [ 3.382720] NET: Registered protocol family 15 [ 3.383516] turn off boot console uart8250 [ 3.393039] VFS: Cannot open root device "hda2" or unknown-block(0,0) [ 3.393594] Please append a correct "root=" boot option; here are the available partitions: [ 3.394329] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)